1

FCC ID: MFEWAVECOMR438-01

ID Label/Location Info

Download: PDF
FCCID_46961

                                                     13 May 1998
                                                     FCC ID: MFEWAVECOMR438—01


5.0         Labeling Requirements


5.1         FCC ID Label and Placement




                       im i
                            .
                                                               O
                                    ie                          §g§ B
                                                                      26;
                                    E.5                         $58
                                    gif s                       sBskrl,
                                    sif £
                                                                {lt
                                                                fall,
                                    it}sE
                                    $5555                       8 %gi f
                                                                Eggggggg
                                                                tharsh:d



                                                              O
                         Bottom View of Unit

FIGURE 3   — Drawing Showing Location of FCC ID and Placement

      All information on the label will be etched or screened. All
      methods will exceed the expected lifetime of the equipment.

      The label will be large         enough to allow all           information to
      be readily legible.

      The Labelling Requirements            of   15.19(c)   shall     appear   in   the
      Owners Manual.




                                          33


                                               13 May 1998
                                               FCC ID: MFEWAVECOMRA438—01

FCC ID Label and Placement           Cont inued)


Label will be constructed of 0.02 inch plastic attached
as shown on the equipment with permanent adhesive.   To
protect     the   ID   label,   the     area       where   the   FCC   ID number
is installed is below the surface of the back of the
case.   This keeps the label from being "peeled" off.
All   information on   the  label  will  be  etched  or
screened. All methods will exceed the expected lifetime
of the equipment.    The label will be large enough to
allow all information to be readily legible.


Additional Labels Required


 This   device  complies with Part 15 of the FCC Rules.
 Operation is subject to the following two conditions:
 (1) This   device  may not cause harmful interference,
 and   (2) This  device  must  accept  any interference
 received,   including  interference  that   may   cause
 undesired operation.


Shown above is a copy of the label with the Part 15.19
Compliance Statement, Location of required information
is checked "below".


      The label will be placed in a conspicuous location
      on the device.


[j    The    device      is     too small for a compliance label.
      Therefore        the label will be placed in a prominent
      location  in  the   Instruction   Manual                         or   other
      information supplied to the user.


[]    The  device  is  too small for a compliance label.
      The label will be placed on the container in which
      the device will be marketed.




                                34



Document Created: 2001-06-07 22:46:09
Document Modified: 2001-06-07 22:46:09

© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC