Modular Approval Request

FCC ID: MCQ55M1644

Cover Letter(s)

Download: PDF
FCCID_1786731

MODULAR APPROVAL REQUEST Date 09/07/2012 TRaC Global 100 Frobisher Business Park Leigh Sinton Road Malvern Worcestershire WR14 1BX UK RE: FCC Modular Approval FCC ID: MCQ55M1644 To Whom It May Concern: Please be advised that the manufacturer requests that the above-referenced model be approved for Modular Approval in accordance with the FCC Rules and Regulations. Our Product meets the FCC meet the FCC modular approval policies in the following ways: i The radio elements must have the radio frequency circuitry shielded. Physical/discrete and tuning capacitors may be located external to the shield, but must be on the module assembly; The radio frequency circuit on the module is shielded by the screening scan that is fitted over the RF device (ref H1). All required discrete components are fitted to the module. ii The module must have buffered modulation/data inputs to ensure that the device will comply with Part 15 requirements with any type of input signal; The module has buffered inputs that are integrated in the Atheros device. iii The module must contain power supply regulation on the module; The module is fitted with a power supply regulator (ref U3).

iv The module must contain a permanently attached antenna, or contain a unique antenna connector, and be marketed and operated only with specific antenna(s), per Sections 15.203, 15.204(b), 15.204(c), 15.212(a), 2.929(b); The module has one u.FL connector. The product is shipped with the appropriate antennas. v The module must demonstrate compliance in a stand-alone configuration; The module has been successfully tested in a stand-alone configuration at an approved test lab. vi The module must be labelled with its permanently affixed FCC ID label, or use an electronic display (See KDB Publication 997198 about labelling requirements); The module has a permanently fixed label indicating the FCC ID “MCQ50M1644”. vii The module must comply with all specific rules applicable to the transmitter. The grantee must provide comprehensive instructions to explain compliance requirements; The module has been successfully tested to all applicable standards at an approved test lab. viii The module must comply with RF exposure requirements. For any transmitters intended for use in portable devices, SAR compliance must be demonstrated to be independent of the host device. See KDB Publication 447498 Item 2) as a guide to determine if a transmitter can be tested without being limited to a host device. If SAR compliance can only be demonstrated in specific host types or platforms, then the module type must be “limited.” The Installation Guide for the device has a section indicating the SAR requirements of the module. Thank you for your attention to this matter. Yours faithfully Digi International Ltd Mr John Pinkney


Document Created: 2012-09-07 15:38:23
Document Modified: 2012-09-07 15:38:23
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC