Request for modular approval

FCC ID: LDK9KG80001

Attestation Statements

Download: PDF
FCCID_1789038

ob frer|c. C1ISCO . Robert Lyall 5030 Sugarloaf Parkway Lawrenceviliec. GA 30044 Direct: 770—236—7439 lyallr@cisco.com www.cisco.com RE FCC ID: LDKOKG80001 To the certification reviewer: We are hereby applying for limited modular approval of the above—referenced FCC ID, based on compliance with all of the criteria as detailed below. Sincerely, _ G Robert Lyall Regulatory Compliance Technical Leader Cisco Systems, Inc. Part 15 Unlicensed Single Modular Transmitter Approval Justification per 15.212 Requirement per 15.212 reference (i) The radio elements of the modular The module itself is not shielded. Shielding is transmitter must have their own RF provided by a ground plane on the printed wiring shielding. board. (ii) The modular transmitter must have buffered The input to this module is 8 MHz SPIL. modulation/data inputs (if such inputs are provided. Gin The modular transmitter must have its own The power supply circuitry in the set—top product power supply regulation. using the module provides power and regulation to the module. (iv) The modular transmitter must comply with The antenna is permanently attached to the module the antenna and transmission system located inside the set—top product that uses it. requirements of §§ 15.203, 15.204(b) and 15.204(c). (v) The modular transmitter must be tested in a The module was tested in a stand—alone stand—alone configuration, i.e., the module configuration in the chamber, with the set—top that must not be inside another device during controls and powers it being outside the chamber. testing for compliance with Part 15 parameters.

(vi) The modular transmitter must be equipped The FCC ID for the module is displayed on the set— with either a permanently affixed label or top product that uses it and on the module itself. must be capable of electronically displaying its FCC identification number. If the FCC ID is not visible when the module is installed inside another device, then the outside of the device into which the module is installed must also display a label referring to the enclosed module. (vii) The modular transmitter must comply with The module complies fully with the operating any specific rules or operating requirements requirements of Part 15 section 15.249 as that ordinarily apply to a complete demonstrated in the test report exhibit. transmitter and the manufacturer must provide adequate instructions along with the module to explain any such requirements. A copy of these instructions must be included in the application for equipment authorization. (vii) The modular transmitter must comply with This module operates under Part 15 section 249, any applicable RF exposure requirements in which is exempt from RF exposure evaluation its final configuration. owing to the very low operating power:


Document Created: 2012-08-15 09:40:47
Document Modified: 2012-08-15 09:40:47
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC