Limited Modular Approval Request

FCC ID: LDK102063

Cover Letter(s)

Download: PDF
FCCID_777365

                                                                        Jim Nicholson
                                                                        EMC Compliance Engineer
                                                                        Cisco Systems, Inc.
                                                                        4125 Highlander Parkway
                                                                        Richfield, OH 44286




April 4, 2007

Federal Communications Commission
Equipment Authorization branch
7435 Oakland Mills Road
Columbia, MD 21046

Re:   FCC ID LDK102063: Request for Limited Modular Transmitter Approval

To Whom It May Concern:

Cisco Systems, Inc. hereby requests Modular Transmitter Approval for the above listed FCC
submittal. In support of this request, please note the declarations listed below.

        1. The modular transmitter has its own RF shielding and does not rely upon the shielding
           provided by the device into which it is installed in order to comply with Part 15 limits.

        2. The modular transmitter has buffered modulation/data inputs and will comply with Part
           15 requirements under conditions of excessive data rates or over-modulation.

        3. The modular transmitter has its own power supply regulation, and will comply with Part
           15 requirements regardless of the design of the power supplying circuitry in the device
           into which the module is installed.

        4. The modular transmitter complies with the antenna requirements of Section 15.203 and
           15.204(c). The modular transmitter employs a “unique” antenna coupler, and all
           antennas used with the module are being approved with the module.

        5. The modular transmitter was tested in the access point in which it will solely operate.

        6. The modular transmitter will be labeled with its own FCC ID number, and the outside
           of the device into which the module is installed will also display a label referring to the
           enclosed module.

        7. The modular transmitter complies with the rules and operating requirements defined
           by Part 15.247 and Part 15.407.

        8. The modular transmitter complies with all applicable RF exposure requirements.

Best Regards,



Jim Nicholson
EMC Compliance Engineer
Cisco Systems, Inc.




Phone: (330) 523-2094                 Fax:    (330) 523-2002            E-Mail: jimnicho@cisco.com



Document Created: 2007-04-04 10:36:53
Document Modified: 2007-04-04 10:36:53

© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC