Module approval justification

FCC ID: LDK102059

Cover Letter(s)

Download: PDF
FCCID_632904

                                                                       Jim Nicholson
                                                                       EMC Compliance Engineer
                                                                       Cisco Systems, Inc.
                                                                       4125 Highlander Parkway
                                                                       Richfield, OH 44286


March 2, 2006

Federal Communications Commission
Equipment Authorization branch
7435 Oakland Mills Road
Columbia, MD 21046

Re:   FCC ID LDK102059: Request for Modular Transmitter Approval

To Whom It May Concern:

Cisco Systems, Inc. hereby requests Modular Transmitter Approval for the above listed FCC
submittal. In support of this request, please note the declarations listed below.

       1. The modular transmitter has its own RF shielding and does not rely upon the shielding
          provided by the device into which it is installed in order to comply with Part 15 limits.

       2. The modular transmitter has buffered modulation/data inputs and will comply with Part
          15 requirements under conditions of excessive data rates or over-modulation.

       3. The modular transmitter has its own power supply regulation, and will comply with Part
          15 requirements regardless of the design of the power supplying circuitry in the device
          into which the module is installed.

       4. The modular transmitter complies with the antenna requirements of Section 15.203 and
          15.204(c). The modular transmitter employs a “unique” antenna coupler, and all
          antennas used with the module are being approved with the module.

       5. The modular transmitter was tested in a stand-alone configuration, and is capable of
          complying with Part 15 emission limits regardless of the device into which it is
          eventually installed.

       6. The modular transmitter will be labeled with its own FCC ID number, and the outside
          of the device into which the module is installed will also display a label referring to the
          enclosed module.

       7. The modular transmitter complies with the rules and operating requirements defined
          by Part 15.407.

       8. The modular transmitter complies with all applicable RF exposure requirements.

Best Regards,



Jim Nicholson
EMC Compliance Engineer
Cisco Systems, Inc.




Phone: (330) 523-2094                Fax:    (330) 523-2002            E-Mail: jimnicho@cisco.com



Document Created: 2006-03-02 07:16:53
Document Modified: 2006-03-02 07:16:53

© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC