Request for modular approval

FCC ID: LDK102052

Cover Letter(s)

Download: PDF
FCCID_390738

                                                                        Jim Nicholson
                                                                        EMC Compliance Engineer
                                                                        Cisco Systems, Inc.
                                                                        4125 Highlander Parkway
                                                                        Richfield, OH 44286




December 11, 2003



Federal Communications Commission
Equipment Authorization branch
7435 Oakland Mills Road
Columbia, MD 21046

Re:   FCC ID LDK102052: Request for Modular Transmitter Approval



To Whom It May Concern:

Cisco Systems, Inc. hereby requests Modular Transmitter Approval for the above listed FCC
submittal. In support of this request, please note the declarations listed below.

       1.   The modular transmitter has its own RF shielding and does not rely upon the shielding
            provided by the device into which it is installed in order to comply with Part 15 limits.

       2.   The modular transmitter has buffered modulation/data inputs and will comply with Part
            15 requirements under conditions of excessive data rates or over-modulation.

       3.   The modular transmitter has its own power supply regulation, and will comply with Part
            15 requirements regardless of the design of the power supplying circuitry in the device
            into which the module is installed.

       4.   The modular transmitter complies with the antenna requirements of Section 15.203 and
            15.204(c). The modular transmitter employs a “unique” antenna coupler, and all
            antennas used with the module are being approved with the module.

       5.   The modular transmitter was tested in a stand-alone configuration, and is capable of
            complying with Part 15 emission limits regardless of the device into which it is
            eventually installed.

       6.   The modular transmitter will be labeled with its own FCC ID number, and the outside
            of the device into which the module is installed will also display a label referring to the
            enclosed module.

       7.   The modular transmitter complies with the rules and operating requirements defined
            by Part 15.247.

       8.   The modular transmitter complies with all applicable RF exposure requirements.




Phone: (330) 523-2094                 Fax:    (330) 523-2002            E-Mail: jimnicho@cisco.com


                                                  Jim Nicholson
                                                  EMC Compliance Engineer
                                                  Cisco Systems, Inc.
                                                  4125 Highlander Parkway
                                                  Richfield, OH 44286




Best Regards,



Jim Nicholson
EMC Compliance Engineer
Cisco Systems, Inc.




Phone: (330) 523-2094     Fax:   (330) 523-2002   E-Mail: jimnicho@cisco.com



Document Created: 2003-12-11 08:46:05
Document Modified: 2003-12-11 08:46:05

© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC