TCB Q and a

FCC ID: LDK102047P

Cover Letter(s)

Download: PDF
FCCID_323917

From: Tom Cokenias [tom@tncokenias.org]
Sent: Wednesday, May 07, 2003 9:29 AM
To: Mike Kuo
Subject: Re: FW: Cisco Systems Inc., FCC ID:LDK102047P, AN03T2822

>Hi Mike,

The revised user manual is a more recent version and should answer
the questions you have about the manual - detailed answers to
questions below.

>
>Notice_content
> -------------
>Since the standard antenna connector is used and professional installation
>is required per the instruction given in the user manual. There are total
>of three types of antenna will be used with this device. By using the Dish
>antenna, the output power needs to be reduced to comply bandedge
>requirements. Based upon above review, please address the following
>questions :
>
>Question #1: Please provide information to inform the installer which
>antenna is for Point to Point and Point to Multipoint operation.


ANS 1 See page C2 of the attached manual (pdf document page 82)

>
>Question #2: If the compliance with the EIRP limit is achieved for various
>antennas by adjusting the transmit power at the time of installation. The
>installation manual must contain adequate instruction such that the correct
>transmit power can be chosen for any antenna being used. Such information
>can not be found in the user manual.


ANS 2   See page C2 of the attached manual (pdf document page 82)

>
>Question #3: The FCC ID number listed in the proposed FCC ID label format is
>LDK102047 which is for separate TCB application under assessment
>no:AN03T2824. Please provide FCC ID label for this application.


ANS 3   Label attached

>
>Question #4: Appendix C and D of user manual contains information which are
>not associated with the EUT. Please modify or harmonize the information to
>address the regulatory information for this device. The user manual does
>not provide information clearly about non co-located requirement for this
>device. Please address this issue in the user manual.


ANS 4 The current manual is correct. The previous version I sent
still had "leftovers" from the document they were modifying, now this
irrelevant information has been eliminated.


>
>Question #5: Please confirm which FCC ID number is for Integral antenna and
>which FCC ID number is for bridge with external antenna. ( In the test
>report, it refers FCC ID:IDK102047 is for integral antenna but the proposed
>FCC ID number indicates otherwise.)


ANS 5 FCC ID:IDK102047 is for the integral antenna.
       FCC ID:IDK102047P has the N connector for the external antennas

>
>Best Regards
>
>Mike Kuo
>The items indicated above must be submitted before processing can continue
>on the above referenced application. Failure to provide the requested
>information within 60 days of the original e-mail date may result in
>application dismissal and forfeiture of the filing fee. Also, please note
>that partial responses increase processing time and should not be submitted.
>Any questions about the content of this correspondence should be directed to
>the e-mail address listed below the name of the sender.



Document Created: 2003-05-07 14:13:39
Document Modified: 2003-05-07 14:13:39

© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC