Spectrum EMC Test Report Rev1

FCC ID: KBCIX260MPI350

Test Report

Download: PDF
FCCID_292435

EXHIBIT VI. Supplemental Test Report New Certification of Previously Certified OEM Module FCC ID: KBCIX260MPI350 IX260 with Integrated Compact Flash WLAN Certification Under Title 47 CFR, Part 15.247 Prepared On Behalf Of ITRONIX, Corporation South 801 Stevens St. Spokane, WA 99204 Prepared By Spectrum Technology, Inc. 209 Dayton Street, Suite 205 Edmonds, WA 98020 425 771-4482 Revised December 23, 2002 Exhibit VI

Applicant: ITRONIX, Corporation FCC ID: KBCIX260MPI350 Supplemental Test Report TABLE OF CONTENTS Cover Page 1 Table Of Contents 2 Exhibit 6 – Conducted RF Power Output Part 15.247 (b) 3 & Equivalent Isotropic Radiated Power Exhibit 6 – Radiated Harmonics and Spurious Emissions 4 & Radiated Field Strength For Three Channels Note: Please refer to the original Certification exhibits for all of the original test report data for the following Cisco Systems, Inc., Intentional Radiator referenced herein: 1.) FCC ID: LDK102042, IEEE 802.11(b), WLAN Compact Flash Card, Model: MPI-350 Series Exhibit VI 2

Applicant: ITRONIX, Corporation FCC ID: KBCIX260MPI350 EXHIBIT 6A TEST: CONDUCTED RF POWER OUTPUT FCC ID: KBCIX260MPI350 Applicant: ITRONIX, Corporation Model: IX260 with MPI350 WLAN Minimum Standard Specified: Part 15.247(b)(1) is 1 Watt for DSSS Test Results: The measured output power level shows compliance with the above limit and the power granted for the OEM module. Authorization Procedure: Part 2.1046 Maximum Conducted Power Output: 21.2 dBm Method of Measurement: 1. The output power levels above had been preset during production for this model. 2. The peak output power was measured 12/10/02 by Celltech with a Gigatronics 8652A Universal Power Meter (S/N: 1835272). The measured channels cover the low, middle and top of the operational frequency range previously approved for this Intentional Radiator of 2412 - 2462 MHz. 4. Both antenna ports were measured, the results below were the maximum level measured. Tabular Results of Conducted RF Output Power and EIRP WLAN Rangestar Serial No: Antenna VMS06180144 P/N 100929 Frequency Power Cable loss Ant. Gain EIRP GHz dBm dBi 2.412 21.2 -inc- 4.5 25.6 2.437 21.1 -inc- 4.5 25.6 2.462 21.1 -inc- 4.5 25.7 * max. The maximum WLAN EIRP is 25.7 dBm with the Rangestar Antenna, P/N 100929, peak antenna gain of 4.5 dBi. Exhibit VI 3

Applicant: ITRONIX, Corporation FCC ID: KBCIX260MPI350 EXHIBIT 6G TEST: RADIATED HARMONICS AND SPURIOUS EMISSIONS FCC ID: KBCIX260MPI350 Applicant: ITRONIX Corporation Model: IX260 with MPI350 WLAN Minimum Standard Specified: Part 15.247(c), 15.205 & 15.209(a) Test Results: Equipment complies with standard Authorization Procedure: Part 2.1053 Test Equipment Set Up: See Block Diagram in Exhibit 7 Frequency Range Observed: 0 to 25 GHz Operating Frequencies WLAN: 2412, 2437, & 2462 MHz (2412 - 2462 MHz band) Radiated Field Strength For Three Channels and Related Harmonics and Spurious WLAN Ant. Spectrum + - + = or Frequency in Vert/ Analyzer Reading Ant Amp Cable dBuV/m uV/m GHz Horz dBuV Factor Gain Loss @ 3 meters @ 3 meters Ch. 1 Low 2.412 V 83.17 28.37 0 1.33 112.87 440047.94 Ch. 6 Mid 2.437 V 83.50 28.37 0 1.33 113.20 457088.18 Ch.11 High 2.462 V 83.83 28.37 0 1.33 113.53 474788.29 WLAN Frequency in GHz Harmonics observed Limit 74 dBuV/m Peak & 54 dBuV/m Average Ch. 1 -Low Fo 2.412 2Fo - 10Fo 4.824 – 24.120 None, At or < noise floor @3m All emissions < 54 dBuV/m or 500 uV/m Ch. 6 -Mid Fo 2.437 2Fo – 10Fo 4.874 – 24.370 None, At or < noise floor @3m All emissions < 54 dBuV/m or 500 uV/m Ch. 11 -High Fo 2.462 2Fo - 10Fo 4.924 – 24.620 None, At or < noise floor @3m All emissions < 54 dBuV/m or 500 uV/m All harmonic and spurious emissions were below the limit. 2Fo and 3Fo were measurable during preliminary measurements at 1.0 meter with 100 kHz RBW only, but not at 3 meters with 1 MHz RBW. A HP preamplifier with over 20 dB of gain was used during the measurements of the harmonics. A high pass filter was used to reduce the fundamental signal and avoid the possibility of overloading the front end of the analyzer when using the preamp. Test Notes: 1.) All harmonics in the restricted bands listed in Part 15.205 are below the Part 15.209(a) limit. 2.) No peak emissions above 1 GHz are more than 20 dB above the average limit. 3.) Peak measurements made with 1 MHz RBW & VBW, Average made with 1MHz RBW & 10 Hz VBW. 4.) One set of measurements was made for each antenna. The highest levels reported above were emanating from the right antenna port. Exhibit VI 4


Document Created: 2019-11-10 18:18:28
Document Modified: 2019-11-10 18:18:28
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC