RF Exposure Info

FCC ID: KA2T1130

RF Exposure Info

Download: PDF
FCCID_349874

RF EXPOSURE REPORT REPORT NO.: RF920617R08 MODEL NO.: GL2454MP-0T ACCORDING: FCC Guidelines for Human Exposure IEEE C95.1 APPLICANT: D-Link Corporation ADDRESS: No.8, Li-Hsin VII Road Science Based Industrial Park, Hsin-Chu,Taiwan ISSUED BY: Advance Data Technology Corporation LAB LOCATION: 47 14th Lin, Chiapau Tsun, Linko, Taipei, Taiwan, R.O.C. 0528 ILAC MRA Lab Code: 200102-0 Report No: 920617R08 1

RF Exposure Measurement (Mobile Device) 1. Introduction In this document, we try to prove the safety of radiation harmfulness to the human body for our product. The limit for Maximum Permissible Exposure (MPE) specified in FCC 1.1310 is followed. The Gain of the antenna used in this product is measured in a Fully Anechoic Chamber (FAC) calibrated for antenna measurement in ADT, and also the maximum total power input to the antenna is measured. Through the Friis transmission formula and the maximum gain of the antenna, we can calculate the distance, away from the product, where the limit of MPE is reached. Although the Friis transmission formula is a far field assumption, the calculated result of that is an over-prediction for near field power density. We will take that as the worst case to specify the safety range. 2. RF Exposure Limit According to FCC 1.1310: The criteria listed in the following table shall be used to evaluate the environmental impact of human exposure to radio-frequency (RF) radiation as specified in 1.1307(b) LIMITS FOR MAXIMUM PERMISSIBLE EXPOSURE (MPE) Frequency Electric Field Magnetic Field Power Density Average Time 2 Range Strength (V/m) Strength (A/m) (mW/cm ) (minutes) (MHz) (A)Limits For Occupational / Control Exposures 300-1500 … … F/300 6 1500-100,000 … … 5 6 (B)Limits For General Population / Uncontrolled Exposure 300-1500 … … F/1500 6 1500-100,000 … … 1.0 30 F = Frequency in MHz Report No: 920617R08 2

3. Friis Formula Friis transmission formula : Pd = (Pout*G) / (4*pi*r2) where Pd = power density in mW/cm2 Pout = output power to antenna in mW G = gain of antenna in linear scale Pi = 3.1416 R = distance between observation point and center of the radiator in cm If we know the maximum Gain of the antenna and the total power input to the antenna, through the calculation, we will know the MPE value at distance r. Ref. : David K. Cheng, Field and Wave Electromagnetics, Second Edition, Page 640, Eq. (11-133). 4 EUT Operating condition The software provided by Manufacturer enabled the EUT to transmit and receive data at lowest, middle and highest channel individually. 5. Classification This modular is specified to be installed in access point or router which is connected with host through wire. So it is easy to be re-located in the place where at least 20cm far away from the body of the user. Warning statement to the user for keeping at least 20cm or more separation distance with the antenna should be included in users manual. So, this device is classified as Mobile Device. Report No: 920617R08 3

6 Test Results 6.1 Antenna Gain The maximum Gain measured in Fully Anechoic Chamber are 5dBi or 3.16 (numeric). 6.2 Output Power Into Antenna & RF Exposure value at distance 20cm: for CCK technique Channel Limit of Output Power to Power Density Channel Frequency Power Density Antenna (mW) (mW/cm2) (MHz) (mW/cm2) 1 2412 93.756 0.059 1.0 6 2437 96.383 0.061 1.0 11 2462 94.624 0.060 1.0 for OFDM technique Channel Limit of Output Power to Power Density Channel Frequency Power Density Antenna (mW) (mW/cm2) (MHz) (mW/cm2) 1 2412 76.559 0.048 1.0 6 2437 76.207 0.048 1.0 11 2462 76.559 0.048 1.0 Report No: 920617R08 4


Document Created: 2003-08-17 16:13:28
Document Modified: 2003-08-17 16:13:28
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC