test report 15C part 3

FCC ID: KA2DWL3200APA1

Test Report

Download: PDF
FCCID_511535

The Measurement of Conducted Spurious Emissions CONDUCTED SPURIOUS EMISSIONS MEASUREMENT 1. LIMITS OF CONDUCTED SPURIOUS EMISSIONS EASUREMENT Below 20dB of the highest emission level of operating band (in 100KHz Resolution Bandwidth, see Section 15.247(c)). Emissions which fall in the restricted bands, as defined in Section 15.205(a), must also comply with the limits specified in Section 15.209(a) (see Section 15.205(c)). 2. TEST INSTRUMENTS Description & Manufacturer Model No. Serial No. Calibrated Until R&S SPECTRUM ANALYZER FSP40 100036 Nov. 27, 2005 WHK3.1/18G- High pass filter 2.4G SN4 Jun. 08, 2005 10SS NOTE: 1.The calibration interval of the above test instruments is 12 months and the calibrations are traceable to NML/ROC and NIST/USA. 3. TEST PROCEDURE The transmitter output was connected to the spectrum analyzer via a low lose cable. Set both RBW and VBW of spectrum analyzer to 100 kHz with suitable frequency span including 100 kHz bandwidth from band edge. The band edges was measured and recorded. Report No. 931214H02 1

4. TEST SETUP SPECTRUM EUT ANALYZER 5. EUT OPERATING CONDITIONS The software provided by client to enable the EUT under transmission condition continuously at lowest, middle and highest channel frequencies individually. Report No. 931214H02 2

TEST RESULTS – For 802.11b The spectrum plots are attached on the following 2 pages. It shows compliance with the requirement in part 15.247(C),.15.205 and 15.209. Report No. 931214H02 3

Ch1 Report No. 931214H02 4

Ch11 Report No. 931214H02 5

TEST RESULTS – For 802.11g The spectrum plots are attached on the following 2 pages. It shows compliance with the requirement in part 15.247(C),.15.205 and 15.209. Report No. 931214H02 6

Ch1 Report No. 931214H02 7

Ch11 Report No. 931214H02 8


Document Created: 2005-01-24 19:24:52
Document Modified: 2005-01-24 19:24:52
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC