Test Rpt-colocated

FCC ID: KA2AP1665A1

Test Report

Download: PDF
FCCID_2090378

FCC Test Report Report No. : FR380810 1 CO-LOCATION 1.1 Transmitter Unwanted Emissions 1.1.1 Transmitter Unwanted Emissions Limit Restricted Band Emissions Limit Frequency Range (MHz) Field Strength (uV/m) Field Strength (dBuV/m) Measure Distance (m) 0.009~0.490 2400/F(kHz) 48.5 - 13.8 300 0.490~1.705 24000/F(kHz) 33.8 - 23 30 1.705~30.0 30 29 30 30~88 100 40 3 88~216 150 43.5 3 216~960 200 46 3 Above 960 500 54 3 Note 1: Test distance for frequencies at or above 30 MHz, measurements may be performed at a distance other than the limit distance provided they are not performed in the near field and the emissions to be measured can be detected by the measurement equipment. When performing measurements at a distance other than that specified, the results shall be extrapolated to the specified distance using an extrapolation factor of 20 dB/decade (inverse of linear distance for field-strength measurements, inverse of linear distance-squared for power-density measurements). Note 2: Test distance for frequencies at below 30 MHz, measurements may be performed at a distance closer than the EUT limit distance; however, an attempt should be made to avoid making measurements in the near field. When performing measurements below 30 MHz at a closer distance than the limit distance, the results shall be extrapolated to the specified distance by either making measurements at a minimum of two or more distances on at least one radial to determine the proper extrapolation factor or by using the square of an inverse linear distance extrapolation factor (40 dB/decade). The test report shall specify the extrapolation method used to determine compliance of the EUT. Un-restricted Band Emissions Limit RF output power procedure Limit (dB) Peak output power procedure 20 Average output power procedure 30 Note 1: If the peak output power procedure is used to measure the fundamental emission power to demonstrate compliance to requirements, then the peak conducted output power measured within any 100 kHz outside the authorized frequency band shall be attenuated by at least 20 dB relative to the maximum measured in-band peak PSD level. Note 2: If the average output power procedure is used to measure the fundamental emission power to demonstrate compliance to requirements, then the power in any 100 kHz outside of the authorized frequency band shall be attenuated by at least 30 dB relative to the maximum measured in-band average PSD level. 1.1.2 Measuring Instruments Refer a test equipment and calibration data table in this test report. SPORTON INTERNATIONAL INC. Page No. : 1 of 9 TEL : 886-3-327-3456 Report Version : Rev. 01 FAX : 886-3-327-0973

FCC Test Report Report No. : FR380810 1.1.3 Test Procedures Test Method Measurements may be performed at a distance other than the limit distance provided they are not performed in the near field and the emissions to be measured can be detected by the measurement equipment. When performing measurements at a distance other than that specified, the results shall be extrapolated to the specified distance using an extrapolation factor of 20 dB/decade (inverse of linear distance for field-strength measurements, inverse of linear distance-squared for power-density measurements). For the transmitter unwanted emissions shall be measured using following options below: Refer as ANSI C63.10, clause 4.2.3.2.3 (Reduced VBW). VBW ≥ 1/T, where T is pulse time. Refer as KDB 558074, clause 12.2.3 measurement procedure peak limit. For radiated measurement, refer as ANSI C63.10, Refer as ANSI C63.10, clause 6.4 for radiated emissions from below 30 MHz. Refer as ANSI C63.10, clause 6.5 for radiated emissions from 30 MHz to 1000 MHz. Refer as ANSI C63.10, clause 6.6 for radiated emissions from above 1 GHz. SPORTON INTERNATIONAL INC. Page No. : 2 of 9 TEL : 886-3-327-3456 Report Version : Rev. 01 FAX : 886-3-327-0973

FCC Test Report Report No. : FR380810 1.1.4 Test Setup Transmitter Radiated Unwanted Emissions Magnetic field tests shall be performed in the frequency range of 9 kHz to 30 MHz using a calibrated loop antenna. Electric field tests shall be performed in the frequency range of 30 MHz to 1000 MHz using a calibrated bi-log antenna and the frequency range of 1 GHz to 40 GHz using a calibrated horn antenna. Note: Test distance is 3m. Transmitter Conducted Unwanted Emissions . 1.1.5 Transmitter Radiated Unwanted Emissions (Below 30MHz) All amplitude of spurious emissions that are attenuated by more than 20 dB below the permissible value has no need to be reported. SPORTON INTERNATIONAL INC. Page No. : 3 of 9 TEL : 886-3-327-3456 Report Version : Rev. 01 FAX : 886-3-327-0973

FCC Test Report Report No. : FR380810 1.1.6 Results of Radiated Emissions (30MHz~1GHz) Transmitter Radiated Unwanted Emissions Operating Mode AC Power & Radio link Polarization H (WLAN), Adapter 1 Operating Function WLAN 5GHz and 2.4GHz Note 1: “>20dB” means spurious emission levels that exceed the level of 20 dB below the applicable limit. Note 2: “N/F” means Nothing Found spurious emissions (No spurious emissions were detected.) Note 3: Measurement receive antenna polarization: H (Horizontal), V (Vertical) SPORTON INTERNATIONAL INC. Page No. : 4 of 9 TEL : 886-3-327-3456 Report Version : Rev. 01 FAX : 886-3-327-0973

FCC Test Report Report No. : FR380810 Transmitter Radiated Unwanted Emissions Operating Mode AC Power & Radio link Polarization V (WLAN), Adapter 1 Operating Function WLAN 5GHz and 2.4GHz Note 1: “>20dB” means spurious emission levels that exceed the level of 20 dB below the applicable limit. Note 2: “N/F” means Nothing Found spurious emissions (No spurious emissions were detected.) Note 3: Measurement receive antenna polarization: H (Horizontal), V (Vertical) SPORTON INTERNATIONAL INC. Page No. : 5 of 9 TEL : 886-3-327-3456 Report Version : Rev. 01 FAX : 886-3-327-0973

FCC Test Report Report No. : FR380810 1.1.7 Results for Radiated Emissions (1GHz~10th Harmonic) Transmitter Radiated Unwanted Emissions Operating Mode AC Power & Radio link Polarization H (WLAN), Adapter 1 Operating Function WLAN 5GHz and 2.4GHz Note 1: “>20dB” means spurious emission levels that exceed the level of 20 dB below the applicable limit. Note 2: “N/F” means Nothing Found spurious emissions (No spurious emissions were detected.) Note 3: Measurement receive antenna polarization: H (Horizontal), V (Vertical) SPORTON INTERNATIONAL INC. Page No. : 6 of 9 TEL : 886-3-327-3456 Report Version : Rev. 01 FAX : 886-3-327-0973

FCC Test Report Report No. : FR380810 Transmitter Radiated Unwanted Emissions Operating Mode AC Power & Radio link Polarization V (WLAN), Adapter 1 Operating Function WLAN 5GHz and 2.4GHz Note 1: “>20dB” means spurious emission levels that exceed the level of 20 dB below the applicable limit. Note 2: “N/F” means Nothing Found spurious emissions (No spurious emissions were detected.) Note 3: Measurement receive antenna polarization: H (Horizontal), V (Vertical) SPORTON INTERNATIONAL INC. Page No. : 7 of 9 TEL : 886-3-327-3456 Report Version : Rev. 01 FAX : 886-3-327-0973

FCC Test Report Report No. : FR380810 1.1.8 Results for Conducted Emissions (30MHz~40GHz) Conducted Emission Plots of Antenna port 1 Conducted Emission Plots of Antenna port 2 SPORTON INTERNATIONAL INC. Page No. : 8 of 9 TEL : 886-3-327-3456 Report Version : Rev. 01 FAX : 886-3-327-0973

FCC Test Report Report No. : FR380810 2 TEST EQUIPMENT AND CALIBRATION DATA Instrument Manufacturer Model No. Serial No. Characteristics Calibration Date Remark Conduction EMC Receiver R&S ESCS 30 100174 9 kHz ~ 2.75 GHz Mar. 26, 2013 (CO04-HY) SCHWARZBECK Conduction LISN MESS-ELEKTRO NSLK 8127 8127-477 9kHz – 30MHz Jan. 21, 2013 (CO04-HY) NIK LISN Conduction EMCO 3810/2NM 9703-1839 9 kHz ~ 30 MHz Apr. 18, 2013 (Support Unit) (CO04-HY) Conduction RF Cable-CON HUBER+SUHNER RG213/U 07611832010001 9 kHz ~ 30 MHz Nov. 09, 2012 (CO04-HY) Note: Calibration Interval of instruments listed above is one year. Instrument Manufacturer Model No. Serial No. Characteristics Calibration Date Remark Spectrum Radiation R&S FSV40 101499 9Kz – 40GHz Jan. 28, 2013 Analyzer (03CH08-HY) Radiation Receiver R&S ESR3 101657 9KHz – 3GHz Jan. 30,2013 (03CH08-HY) 10MHz ~ Radiation Amplifier COM-POWER PA-103 161241 Feb. 26, 2013 1000MHz (03CH08-HY) Radiation Amplifier Agilent 83017A MY39501308 1GHz – 26.5 GHz Dec. 18, 2012 (03CH08-HY) BBHA 9120 D Radiation Horn Antenna SCHWARZBECK BBHA 9120 D 1GHz~18GHz Feb. 18, 2013 1096 (03CH08-HY) Radiation Horn Antenna SCHWARZBECK BBHA 9170 BBHA 9170517 18GHz~40GHz Jan. 14, 2013 (03CH08-HY) SHF-EHF Horn Radiation SCHWARZBECK BBHA 9170 BBHA 9170517 15GHz~40GHz Sep. 28, 2012 Antenna (03CH08-HY) Radiation Bilog Antenna SCHAFFNER CBL6111C 2725 30 MHz - 1 GHz Oct. 06, 2012 (03CH08-HY) Note: Calibration Interval of instruments listed above is one year. Instrument Manufacturer Model No. Serial No. Characteristics Calibration Date Remark AMF-7D-001018 26.5GHz ~ Radiation Amplifier MITEQ 9121372 Feb. 27, 2013 00-30-10P 40GHz (03CH08-HY) Radiation Loop Antenna R&S HFH2-Z2 860004/0001 9 kHz - 30 MHz Jul. 03, 2012 (03CH08-HY) Note: Calibration Interval of instruments listed above is two year. SPORTON INTERNATIONAL INC. Page No. : 9 of 9 TEL : 886-3-327-3456 Report Version : Rev. 01 FAX : 886-3-327-0973


Document Created: 2013-09-30 16:05:09
Document Modified: 2013-09-30 16:05:09
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC