Radicom-Modular Approval--FCC_20150626

FCC ID: K7T-WIFIHU2S

Cover Letter(s)

Download: PDF
FCCID_2666928

Modular Approval Request Letter FCC ID: K7T-WIFIHU2S Data: June 26, 2015 Gentlemen: There’s that would like to have your authorization as a modular approval. The specific product as below, USB WiFi Module, with its designed features and specified description, meets special requirements for full modular approval on FCC Public Notice DA 00-1407 Released: June 26, 2000 by cross-reference list below. Company: Radicom Research, Inc__ Product Name: USB WiFi Module Model Number WiFiHU2s-a, WiFiHU2s-c FCC No.: K7T-WIFIHU2S Requirement of Public Notice DA00-1407 / part 15.212 Reference to WiFiHU2s-a, WiFiHU2s-c 1. The modular transmitter must have its own RF shielding. The module has its own RF shielding. Please see external photo.pdf 2. The modular transmitter must have buffered modulation/data inputs. The modular has buffered data inputs; it is integrated In chip RTL8192CU. Please see block diagram.pdf 3. The modular transmitter must have its own power supply regulation. All power lines derived from the host device are regulated before energizing other circuits internal to the WiFiHU2s-a and WiFiHU2s-c. Please see circuit.pdf 4. The modular transmitter must comply with the antenna requirements of Section The WiFiHU2s-a and WiFiHU2s-c meet the IC antenna 15.203 and 15.204(c). requirements. It has a unique connector. Please see internal photo.pdf 5. The modular transmitter must be tested in a stand-alone configuration, i.e., the The WiFiHU2s-a and WiFiHU2s-c were tested in a module must not be inside another device during testing. stand-alone configuration via an USB hub PCB. To remove the WiFiHU2s carefully remove it from the six pin headers on the USB interface board. 6. The modular transmitter must be labeled with its own FCC ID number, and, if the The label position of WiFiHU2s-a and WiFiHU2s-c are FCC ID is not visible when the module is installed inside another device, then the clearly indicated. Please see the label location.pdf outside of the device into which the module is installed must also display a label referring to the enclosed module. 7. The modular transmitter must comply with any specific rule or operating The module is compliant with all applicable FCC rules. requirements applicable to the transmitter and the manufacturer must provide Detail instructions are given in the Users Manual. Please adequate instructions along with the module to explain any such requirements. A see Installation guide.pdf copy of these instructions must be included in the application for equipment authorization. 8. The modular transmitter must comply with any applicable RF exposure The WiFiHU2s-a and WiFiHU2s-c comply with requirements. For example, FCC Rules in Sections 2.1091, 2.1093 and specific applicable RF exposure requirements. Please see MPE Sections of Part 15, including 15.319(i), 15.407(f), 15.253(f) and 15.255(g), require report. pdf that Unlicensed PCS, UNII and millimeter wave devices perform routine environmental evaluation for RF Exposure to demonstrate compliance. In addition, spread spectrum transmitters operating under Section 15.247 are required to address RF Exposure compliance in accordance with Section 15.247(b)(4). Yours truly, Roger Sheridan QA Manager Radicom Research Inc


Document Created: 2015-06-29 16:03:20
Document Modified: 2015-06-29 16:03:20
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC