TEST REPORT

FCC ID: K6630323X30

Test Report

Download: PDF
FCCID_917718

849 NW STATE ROAD 45 NEWBERRY, FL 32669 USA PH: 888.472.2424 OR 352.472.5500 FAX: 352.472.2030 EMAIL: INFO@TIMCOENGR.COM HTTP://WWW.TIMCOENGR.COM FCC PART 80 CLASS II PERMISSIVE CHANGE TEST REPORT APPLICANT VERTEX STANDARD CO., LTD. 4-8-8 NAKAMEGURO, MEGURO-KU TOKYO 153-8644 JAPAN FCC ID K6630323X30 IC CEERTIFICATION 511B-30323X30 MODEL NUMBER HX750S, HX760S PRODUCT DESCRIPTION HANDHELD MARINE TRANSCEIVER DATE SAMPLE RECEIVED 2/13/2008 DATE TESTED 2/29/2008 TESTED BY JOSEPH SCOGLIO APPROVED BY MARIO DE ARANZETA TIMCO REPORT NO. 319AUT8TestReport.doc TEST RESULTS PASS FAIL THE ATTACHED REPORT SHALL NOT BE REPRODUCED EXCEPT IN FULL WITHOUT THE WRITTEN APPROVAL OF TIMCO ENGINEERING, INC. TABLE OF CONTENTS Certificate # 0955-01

TABLE OF CONTENTS GENERAL REMARKS......................................................................................................... 3 TEST PROCEDURES ......................................................................................................... 4 FIELD STRENGTH OF SPURIOUS EMISSIONS................................................................... 5 EMC EQUIPMENT LIST ..................................................................................................... 7 RADIATED TEST SET UP PHOTO....................................................................................... 8 INTERNAL PHOTOS ........................................................................................................... 9 Applicant: VERTEX STANDARD CO.. LTD. FCC ID: K6630323X30 MODEL: HX760S Report: X:\V\VERTEX_STANDARD\319AUT8\319AUT8TestReport.doc Page 2 of 10

GENERAL REMARKS The attached report shall not be reproduced except in full without the written permission of Timco Engineering Inc. The test results relate only to the items tested. A bluetooth module has been added to the PCB of the originally approved device; we have performed the intermods testing and there is no degradation in the test results and no additional spurious emissions were found. With the bluetooth module added, the model number HX750S becomes model number HX760S. Summary The device under test does: fulfill the general approval requirements as identified in this test report not fulfill the general approval requirements as identified in this test report Attestations This equipment has been tested in accordance with the standards identified in this test report. To the best of my knowledge and belief, these tests were performed using the measurement procedures described in this report. All instrumentation and accessories used to test products for compliance to the indicated standards are calibrated regularly in accordance with ISO 17025 requirements. Testing Certificate # 0955-01 I attest that the necessary measurements were made, under my supervision, at: Timco Engineering Inc. 849 NW State Road 45 Newberry, Fl 32669 Authorized Signatory Name: Mario de Aranzeta C.E.T. Compliance Engineer/ Lab. Supervisor Date: 2/29/2008 Applicant: VERTEX STANDARD CO.. LTD. FCC ID: K6630323X30 MODEL: HX760S Report: X:\V\VERTEX_STANDARD\319AUT8\319AUT8TestReport.doc Page 3 of 10

TEST PROCEDURES Power Line Conducted Interference: The procedure used was ANSI/TIA 603-C:2004 using a 50uH LISN. Both lines were observed with the DUT transmitting. The bandwidth of the spectrum analyzer was 10 kHz with an appropriate sweep speed. Bandwidth 20 dB: The measurements were made with the spectrum analyzer's resolution bandwidth (RBW) = 1 MHz and the video bandwidth (VBW) = 3 MHz and the span set as shown on plot. Power Output: The RF power output was measured at the antenna feed point using a peak power meter. Antenna Conducted Emissions: The RBW = 100 kHz, VBW = 300 kHz and the span set to 10.0 MHz and the spectrum was scanned from 30 MHz to the 10th harmonic of the fundamental. Above 1 GHz the resolution bandwidth was 1 MHz and the VBW = 3 MHz and the span to 50 MHz. Radiation Interference: The test procedure used was ANSI C63.4-2004 using an Agilent spectrum receiver with pre-selector. The bandwidth (RBW) of the spectrum receiver was 100 kHz up to 1 GHz and 1 MHz above 1 GHz with an appropriate sweep speed. The VBW above 1 GHz was 3 MHz. The analyzer was calibrated in dB above a micro volt at the output of the antenna. Applicant: VERTEX STANDARD CO.. LTD. FCC ID: K6630323X30 MODEL: HX760S Report: X:\V\VERTEX_STANDARD\319AUT8\319AUT8TestReport.doc Page 4 of 10

FIELD STRENGTH OF SPURIOUS EMISSIONS Rule Parts. No.: FCC Part 2.1053 METHOD OF MEASUREMENT: The tabulated data shows the results of the radiated field strength emissions test. The spectrum was scanned from 30 MHz to at least the tenth harmonic of the fundamental. This test was conducted per ANSI/TIA 603-C:2004 using the substitution method. Measurements were made at the test site of TIMCO ENGINEERING, INC. located at 849 NW State Road 45, Newberry, FL 32669. Test Setup Diagram: Transmitter Spectrum under Test Analyzer 3 meters Signal Generator Applicant: VERTEX STANDARD CO.. LTD. FCC ID: K6630323X30 MODEL: HX760S Report: X:\V\VERTEX_STANDARD\319AUT8\319AUT8TestReport.doc Page 5 of 10

Test Data: Tuned Emission Meter Ant. Coax Correction Field Frequency Frequency Reading Polarity Loss Factor Strength MHz MHz dBuV dB dB/m dBuV/m 157.4 162.6 6.2 V 0.75 15.11 22.06 171 3.7 H 0.78 15.14 19.62 171 12.4 V 0.78 16.22 29.4 314.8 41.3 V 1.11 14.91 57.32 314.8 43.2 H 1.11 15.1 59.41 472.3 28.9 H 1.27 17.32 47.49 472.3 30.4 V 1.27 17.15 48.82 480 7.4 V 1.28 17.3 25.98 480 10.5 H 1.28 17.7 29.48 495.9 7 H 1.3 17.74 26.04 495.9 8.3 V 1.3 17.82 27.42 511.9 9.6 H 1.34 18.82 29.76 511.9 11 V 1.34 18.46 30.8 528 8.4 H 1.38 18.58 28.36 528 10.2 V 1.38 17.82 29.4 544 8.1 H 1.43 18.42 27.95 544 10.1 V 1.43 18.1 29.63 629.6 7 H 1.63 19.6 28.23 629.6 8.1 V 1.63 19.3 29.03 994.5 7.4 V 2.09 23.25 32.74 994.5 10.5 H 2.09 24.14 36.73 1,620.00 19.4 V 2.6 28.77 50.77 1,620.00 19.8 H 2.6 28.77 51.17 2,440.00 53.4 V 3.21 32.34 88.95 2,440.00 57.3 H 3.21 32.34 92.85 4,880.00 11.9 V 4.94 34.1 50.94 4,880.00 13.6 H 4.94 34.1 52.64 Applicant: VERTEX STANDARD CO.. LTD. FCC ID: K6630323X30 MODEL: HX760S Report: X:\V\VERTEX_STANDARD\319AUT8\319AUT8TestReport.doc Page 6 of 10

EMC EQUIPMENT LIST Device Manufacturer Model Serial Cal/Char Due Date Number Date 3-Meter Panashield N/A N/A Listed 5/10/10 Semi- 5/11/07 Anechoic Chamber 3-Meter TEI N/A N/A Listed 1/10/09 OATS 1/11/06 3-10 Meter TEI N/A N/A Listed 3/19/10 OATS 3/20/07 Analyzer HP 8566B Opt 3138A07786 CAL 11/30/09 Tan Tower 462 3144A20661 11/30/07 Spectrum Analyzer Analyzer HP 85685A 3221A01400 CAL 11/30/09 Tan Tower 11/30/07 RF Preselector Analyzer HP 85650A 3303A01690 CAL 11/30/09 Tan Tower 11/30/07 Quasi-Peak Adapter Analyzer HP 8449B-H02 3008A00372 CAL 11/30/09 Tan Tower 11/30/07 Preamplifier Antenna: Electro- BIA-25 1171 CAL 7/18/09 Biconnical Metrics 7/18/07 Antenna: Electro- LPA-25 1122 CAL 12/1/08 Log- Metrics 12/1/06 Periodic Antenna: Electro- RGA-180 2319 CAL 7/18/09 Double- Metrics 7/18/07 Ridged Horn LISN Electro- ANS-25/2 2604 CAL 10/5/08 Metrics 10/5/06 Termaline Bird 611 16405 CAL 3/15/09 Wattmeter Electronic 3/15/07 Corporation Applicant: VERTEX STANDARD CO.. LTD. FCC ID: K6630323X30 MODEL: HX760S Report: X:\V\VERTEX_STANDARD\319AUT8\319AUT8TestReport.doc Page 7 of 10

T I M G 0 E N G I N E E R I N G , I nc .

INTERNAL PHOTOS Applicant: VERTEX STANDARD CO.. LTD. FCC ID: K6630323X30 MODEL: HX760S Report: X:\V\VERTEX_STANDARD\319AUT8\319AUT8TestReport.doc Page 9 of 10

Applicant: VERTEX STANDARD CO.. LTD. FCC ID: K6630323X30 MODEL: HX760S Report: X:\V\VERTEX_STANDARD\319AUT8\319AUT8TestReport.doc Page 10 of 10


Document Created: 2008-03-20 18:26:16
Document Modified: 2008-03-20 18:26:16
© 2025 FCC.report
This site is not affiliated with or endorsed by the FCC