modular approval

FCC ID: K660H464X10

Cover Letter(s)

Download: PDF
FCCID_1477832

                                                                   Date: May 18, 2011
                   Modular Approval Request Letter

                            Vertex Standard Co., Ltd
                               FCC ID: K660H464X10
                                  Model No: BU-2
Dear Sir/Madame:
We would like to declare that our transmitter module comply with modular
approval requirement in accordance with FCC 15.212 as below;
No. Requirement                              Description of compliance manners
1   The module has its own RF shielding. The device is equipped with metal shielding
                                             to cover RF section.
                                             Refer to external photos.
2   All modulation and data input(s) are The device has buffered data inputs. It is
    buffered.                                indicated parts number “U7” on the circuit
                                             diagrams.
3   The module has its own power supply      The device has internal 4.0V power
    regulation and local reference           regulator. Refer to block diagram.
    oscillator.
4   The module complies with the antenna The device is equipped with chip antenna.
    requirements of section 15.203 and       Any connector is not used. Refer to external
    15.204(c).                               photos.
5   The module must be tested in a           The device was tested outside of PC for full
    stand-alone configuration, i.e., the modular approval. Refer to test setup
    module must not be inside another device photos.
    during testing.
6   The module must be labeled with its own The proposed FCC ID label format is to be
    FCC ID number, and if the FCC ID is not placed on the module. If FCC ID label is not
    visible when the module is installed visible when module is install into the
    inside another device, then the outside system, “Contains FCC ID: K660H464X10”
    of the device into which the module is shall be placed on the outside of final
    installed must also display a label      product.
    referring to the enclosed module.
7   The module is manufactured so that the The detail instructions for maintaining
    user cannot influence the operation of compliance are given in the users’ manual.
    the transmitter that will operate
    outside of the scope of the regulations.
8   The module must comply with any          The device complies with the RF exposure
    applicable RF exposure requirements. compliance requirement.
                                             Refer to the test report.
THIS PRODUCT SHOULD NOT BE USED AS A FINAL PRODUCT.
Sincerely Yours,




Shigemitu Takahashi Chief Test Engineer          Engineering Division
Telephone Number: +81-3-5725-6111
Fax Number: +81-3-5725-6225        E-mail: shige.takahashi@vxstd.com



Document Created: 2011-05-24 14:23:03
Document Modified: 2011-05-24 14:23:03

© 2025 FCC.report
This site is not affiliated with or endorsed by the FCC