User Manual

FCC ID: K44501000

Users Manual

Download: PDF

FCCID_4390169

One or more of the following statements may be applicable:
Radio Frequency Energy Safety Information
FCC WARNING
This KENWOOD transceiver has been tested and complies with the This equipment generates or uses radio frequency energy. Changes or
standards listed below, in regards to Radio Frequency (RF) energy and modifications to this equipment may cause harmful interference unless
electromagnetic energy (EME) generated by the transceiver. the modifications are expressly approved by the party responsible/
• FCC RF exposure limits for Occupational Use Only. RF Exposure limits JVCKENWOOD. The user could lose the authority to operate this
adopted by the FCC are generally based on recommendations from equipment if an unauthorized change or modification is made.
the National Council on Radiation Protection and Measurements, & the
American National Standards Institute.
INFORMATION TO THE DIGITAL DEVICE USER REQUIRED BY THE
• FCC OET Bulletin 65 Edition 97-01 Supplement C
FCC
• American National Standards Institute (C95.1 – 1992)
• American National Standards Institute (C95.3 – 1992) This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
WARNING in a residential installation.
This KENWOOD transceiver generates RF EME while transmitting. RF This equipment generates, uses and can generate radio frequency energy
EME (Radio Frequency Electric & Magnetic Energy) has the potential and, if not installed and used in accordance with the instructions, may
to cause slight thermal, or heating effects to any part of your body less cause harmful interference to radio communications. However, there is
than the recommended distance from this radio transmitter’s antenna. no guarantee that the interference will not occur in a particular installation.
RF energy exposure is determined primarily by the distance to and the If this equipment does cause harmful interference to radio or television
power of the transmitting device.  In general, RF exposure is minimized reception, which can be determined by turning the equipment off and on,
when the lowest possible power is used or transmission time is kept to the user is encouraged to try to correct the interference by one or more of
the minimum required for consistent communications, and the greatest the following measures:
distance possible from the antenna to the body is maintained. The • Reorient or relocate the receiving antenna.
transceiver has been designed for and is classified for Occupational Use • Increase the separation between the equipment and receiver.
Only. Occupational/ controlled exposure limits are applicable to situations • Connect the equipment to an outlet on a circuit different from that to
in which persons are exposed to RF energy as a consequence of their which the receiver is connected.
employment, and such persons have been made aware of the potential • Consult the dealer for technical assistance.
for exposure and can exercise control over their exposure. This means
you can use the transceiver only if you are aware of the potential hazards
of operating a transceiver and are familiar in ways to minimize these SUPPLIER'S DECLARATION OF CONFORMITY
hazards. This transceiver is not intended for use by the general public in 47 CFR § 2.1077 Compliance Information
uncontrolled environments. Uncontrolled environment exposure limits are Trade name: KENWOOD
applicable to situations in which the general public may be exposed to RF Model(s): NX-1000 series
Responsible party: JVCKENWOOD USA Corporation 1440 Corporate Drive,
energy, or in which the persons who are exposed as a consequence of
Irving, TX 75038
their employment may not be fully aware of the potential for exposure or Telephone number: 972-819-0700
cannot exercise control over their exposure.

The following list provides you with the information required to ensure that you The RBRC Recycle seal found on KENWOOD lithium-ion
are aware of RF exposure and of how to operate this transceiver so that the (Li-ion) battery packs indicates KENWOOD’s voluntary
FCC RF exposure limitations are not exceeded. participation in an industry program to collect and recycle
Li-ion batteries after their operating life has expired.
• While transmitting (holding the PTT switch or speaking with VOX
enabled), always keep the antenna and the radio at least 3 cm (1.18 The RBRC program is an alternative to disposing Li-ion
inches) from your body or face, as well as from any bystanders. A LED batteries with your regular refuse or in municipal waste
on the top of the radio shows red when the transmitter is operating in streams, which is illegal in some areas.
both PTT and VOX modes. For information on Li-ion battery recycling in your area, call (toll free)
• Do not transmit for more than 50% of the total transceiver use time; 1-800-8-BATTERY (1-800-822-8837).
transmitting over 50% of the total use time may exceed the limits in
accordance to the FCC RF exposure requirements. Nominal transceiver KENWOOD’s involvement in this program is part of our commitment to
operation is 5% transmission time, 5% reception time, and 90% stand- preserve our environment and conserve our natural resources.
by time.
• Use only the specified antenna for this transceiver; this may be either
the antenna provided with the transceiver or another antenna authorized
by KENWOOD.
Use only KENWOOD authorized accessories (antennas, battery packs,
belt clips, Speaker/ Mics or headsets etc.): When worn on the body, always
place the radio in a KENWOOD recommended clip or carrying case meant
for this product. The use of other than recommended or approved body-
worn accessories may result in RF exposure levels which exceed the FCC’s
occupational/ controlled environment RF exposure limits.

CAUTION
To ensure that your exposure to RF EME is within the FCC limits for
occupational use, you must observe and adhere to the above points.

Electromagnetic Interference Compatibility
Electronic devices are susceptible to electromagnetic interference (EMI)
if they are not adequately shielded or designed for electromagnetic
compatibility. Because this transceiver generates RF energy, it can cause
interference to such equipment.
• Turn OFF your transceiver where signs are posted to do so.
Hospitals and health care facilities use equipment that is sensitive to
electromagnetic radiation.
• Turn OFF your transceiver while on board an aircraft when so instructed.
Use of the transceiver must be in accordance with airline regulations
and/or crew instructions.

© 2019

Document Created: 2019-06-04 17:48:38
Document Modified: 2019-06-04 17:48:38

© 2025 FCC.report
This site is not affiliated with or endorsed by the FCC