MPE Calculation

FCC ID: JQ6-OK5127CKMINI

RF Exposure Info

Download: PDF
FCCID_2574015

MPE CALCULATION _____________________________________________________________________________________________________________________ RF Exposure Requirements: 47 CFR §1. 1307(b) RF Radiation Exposure Limits: 47 CFR §1. 1310 RF Radiation Exposure Guidelines: FCC OST/OET Bulletin Number 65 EUT Frequency Band: 2402 - 2480 MHz Limits for General Population/Uncontrolled Exposure in the band of: 1500 - 100,000 MHz Power Density Limit: 1 mW / cm2 Equation: S = PG / 4R2 or R = √PG / 4S Where, S = Power Density P = Power Input to Antenna G = Antenna Gain R = distance to the center of radiated antenna ______________________________________________________________________________________________________________________ Prediction distance 20cm Power = 1.009 mW (Maximum peak output power), Antenna Gain = 3 dBi (Numerical Antenna; equal to 4.0 dBi) Power density = 0.00057 mW/ cm2 Mode Prediction Target Tune up power Max Tune up Max Antenna Power density distance (cm) Power (dBm) tolerance (dB) Power (dBm) Gain (dBi) (mW/ cm2) DTS band BT LE 20 0.04 1.5 1.54 3 0.00057 Note: The MPE value is calculated on the channel with the worst case scenario. In this case low channel is investigated. In conclusion, SAR is not required. The maximum power density is 0.00057 mW/ cm2, which is less than 1 mW/ cm2. The Above Result had shown that the Device complied with MPE requirement. Completed By: Osvaldo Casorla SIEMIC, Inc 775 Montague Expressway, Milpitas, CA 95035 Phone: (408) 526-1188 Date: April 01, 2015


Document Created: 2015-04-01 16:31:15
Document Modified: 2015-04-01 16:31:15
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC