Test Setup Pictures

FCC ID: IYZDC08

Test Setup Photos

Download: PDF
FCCID_1199274

FCC ID: IYZDC08 5.2 Field strength of the fundamental wave For test instruments and accessories used see section 6 Part CPR 1. 5.2.1 Description of the test location Test location: OATS1 Test distance: 3 metres 5.2.2 Photo documentation of the test set-up 5.2.1 Applicable standard According to FCC Part 15C, Section 15.209: The emissions from intentional radiators shall not exceed the effective field strength limits. 5.2.2 Description of Measurement The magnetic field strength from the EUT is measured in an open area test site in the frequency range of 9 kHz to 30 MHz using a tuned receiver and a shielded loop antenna. The set up of the Equipment under test is in accordance to ANSI C63.4. The shielded loop antenna was turned to locate the maximum of the emissions. In the case where larger measuring distances are required the results are extrapolated based on the values measured on the closer distances according to Section 15.31(f)(2)(2). The final measurement is performed with an EMI Receiver set to quasi peak detector except for the frequency bands 9 kHz to 90 kHz and 110 to 490 kHz where an average detector will be used according to Section 15.209(d)(2). mikes-testingpartners gmbh File No. T32837-02-00HS, page 9 of 16 Ohmstrasse 2-4 x 94342 Strasskirchen Tel.:+49(0)9424-94810 x Fax:+49(0)9424-9481240 Rev. No. 1.1, 23.7.2008

FCC ID: IYZDC08 5.3 Spurious emissions (magnetic field) 9 kHz – 30 MHz For test instruments and accessories used see section 6 Part SER 1. 5.3.1 Description of the test location Test location: OATS1 Test distance: 3 metres 5.3.2 Photo documentation of the test set-up 5.3.3 Applicable standard According to FCC Part 15C, Section 15.209: The emissions from intentional radiators shall not exceed the effective field strength limits. 5.3.4 Description of Measurement The spurious emission from the EUT is measured on an open area test site in the frequency range of 9 kHz to 30 MHz using a tuned receiver and a shielded loop antenna. The set up of the equipment under test is in accordance to ANSI C63.4. The shielded loop antenna was turned to locate the maximum of the emissions. In the case where larger measuring distances are required the results are extrapolated based on the values measured on the closer distances according to Section 15.31(f)(2)(2). The final measurement is performed with an EMI Receiver set to quasi peak detector except for the frequency bands 9 kHz to 90 kHz and 110 to 490 kHz where an average detector will be used according to Section 15.209(d)(2). mikes-testingpartners gmbh File No. T32837-02-00HS, page 11 of 16 Ohmstrasse 2-4 x 94342 Strasskirchen Tel.:+49(0)9424-94810 x Fax:+49(0)9424-9481240 Rev. No. 1.1, 23.7.2008

FCC ID: IYZDC08 5.4 Emission Bandwidth For test instruments and accessories used see section 6 Part MB. 5.4.1 Description of the test location Test location: Anechoic Chamber A1 Test distance: 3 metres 5.4.2 Photo documentation of the test set-up 5.4.3 Test result of the door antenna Center 20dB 20dB Measured LIMIT frequency Bandwidth Bandwidth Bandwidth Fundamental (kHz) f1 (kHz) f2 (kHz) (kHz) 21.845 16.3 26.4 10.1 - 5.4.4 Test result of the trunk antenna Center 20dB 20dB Measured LIMIT frequency Bandwidth Bandwidth Bandwidth Fundamental (kHz) f1 (kHz) f2 (kHz) (kHz) 21.845 16.8 26.5 9.7 - Remarks: There is no limit according to FCC Part 15C Subpart 15.209. For detailed results, please see the test protocol below. mikes-testingpartners gmbh File No. T32837-02-00HS, page 13 of 16 Ohmstrasse 2-4 x 94342 Strasskirchen Tel.:+49(0)9424-94810 x Fax:+49(0)9424-9481240 Rev. No. 1.1, 23.7.2008


Document Created: 2009-11-10 16:14:12
Document Modified: 2009-11-10 16:14:12
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC