FCC Part 95 Test Report

FCC ID: IPH-02337

Test Report

Download: PDF
FCCID_4160229

Test Report Prepared for: Garmin International, Inc. Model: A02337 Description: Short Range Transceiver Serial Number: 55F002841 FCC ID: IPH-02337 IC:1792A-02337 To 47 CFR Part 95C ISED RSS-210 A.2 ANSI C63.26-2015 Date of Issue: December 18, 2018 On the behalf of the applicant: Garmin International, Inc. 1200 E. 151st Street Olathe, KS 66062 Attention of: William H. Pertner, Lead Compliance Engineer Ph: (913) 440-5471 Email: bill.pertner@garmin.com Prepared By: Compliance Testing, LLC 1724 S. Nevada Way Mesa, AZ 85204 (480) 926-3100 phone / (480) 926-3598 fax www.compliancetesting.com Project No: p1880024 Christian Pawlak Project Test Engineer This report may not be reproduced, except in full, without written permission from Compliance Testing. All results contained herein relate only to the sample tested. p1880024_FCC_Part 95_Rev 1.0 Page 1 of 16

Test Report Revision History Revision Date Revised By Reason for Revision 1.0 November 7, 2018 Christian Pawlak Original Document p1880024_FCC_Part 95_Rev 1.0 Page 2 of 16

Table of Contents Description Page Standard Test Conditions and Engineering Practices 6 Test Result Summary 8 Transmitter Power 9 Authorized Bandwidth 10 Unwanted Emissions – In-Band Mask 12 Unwanted Emissions – Out of Band Spurious 14 Frequency Accuracy 15 Test Equipment Utilized 16 p1880024_FCC_Part 95_Rev 1.0 Page 3 of 16

ILAC / A2LA Compliance Testing, LLC, has been accredited in accordance with the recognized International Standard ISO/IEC 17025:2005. This accreditation demonstrates technical competence for a defined scope and the operation of a laboratory quality management system (refer joint ISO-ILAC-IAF Communiqué dated January 2009). The tests results contained within this test report all fall within our scope of accreditation, unless noted below. Please refer to http://www.compliancetesting.com/labscope.html for current scope of accreditation. Testing Certificate Number: 2152.01 FCC Site Reg. #349717 IC Site Reg. #2044A-2 Non-accredited tests contained in this report: N/A p1880024_FCC_Part 95_Rev 1.0 Page 4 of 16

The Applicant has been cautioned as to the following: 15.21: Information to the User The user’s manual or instruction manual for an intentional radiator shall caution the user that changes, or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. 15.27(a): Special Accessories Equipment marketed to a consumer must be capable of complying with the necessary regulations in the configuration in which the equipment is marketed. Where special accessories, such as shielded cables and/or special connectors are required to enable an unintentional or intentional radiator to comply with the emission limits in this part, the equipment must be marketed with, i.e. shipped and sold with, those special accessories. However, in lieu of shipping or packaging the special accessories with the unintentional or intentional radiator, the responsible party may employ other methods of ensuring that the special accessories are provided to the consumer, without an additional charge. Information detailing any alternative method used to supply the special accessories for a grant of equipment authorization or retained in the verification records, as appropriate. The party responsible for the equipment, as detailed in § 2.909 of this chapter, shall ensure that these special accessories are provided with the equipment. The instruction manual for such devices shall include appropriate instructions on the first page of text concerned with the installation of the device that these special accessories must be used with the device. It is the responsibility of the user to use the needed special accessories supplied with the equipment. p1880024_FCC_Part 95_Rev 1.0 Page 5 of 16

Test and Measurement Data All tests and measurement data shown were performed in accordance with FCC 47 CFR Parts 2 and 90. Measurement results, unless otherwise noted, are worst-case measurements. Standard Test Conditions and Engineering Practices Except as noted herein, the following conditions and procedures were observed during the testing. Unless otherwise indicated in the specific measurement results, the ambient temperature of the actual EUT was maintained within the range of 10 to 40C (50 to 104 F) unless the particular equipment requirements specified testing over a different temperature range. Also, unless otherwise indicated, the humidity levels were in the range of 10% to 90% relative humidity. Environmental Conditions Temp Humidity Pressure (ºC) (%) (mbar) 24.9 48.5 960.2 p1880024_FCC_Part 95_Rev 1.0 Page 6 of 16

Accessories: None Cables: None Modifications: Unit #1 - Unmodified Unit #2 - SMA Connector and battery eliminator installed on unit used for Occupied Bandwidth and Frequency Stability tests. p1880024_FCC_Part 95_Rev 1.0 Page 7 of 16

Test Result Summary Pass, Specification Test Name Comments Fail, N/A 47 CFR 95.767 47 CFR 2.1046 Transmitter Power Pass RSS-210 A.2.1(c) 47 CFR 95.773 47 CFR 2.1049 Authorized Bandwidth Pass RSS-210 A.2.1(e) 47 CFR 95.779 47 CFR 2.1053 Unwanted Emissions Pass RSS-210 A.2.1(g) 47 CFR 95.765 47 CFR 2.1055 Frequency Accuracy Pass RSS-210 A.2.1(f) p1880024_FCC_Part 95_Rev 1.0 Page 8 of 16

Transmitter Power Engineer: Christian Pawlak Test Date: 10/16/2018 Standards: 47 CFR 95.767, RSS-210 A.2.1(c) Test Procedure The Method of Measurement was C63.26 5.2.4.3. The EUT was measured in a radiated configuration with the manufacturer’s antenna attached. Emissions were maximized per C63.26 5.5.3.2. ERP was computed as follows: 𝐹𝑆𝑃𝐿 = 20 log(𝐹) + 20 log(𝐷) − 27.5 𝐸𝑅𝑃 (π‘‘π΅π‘š) = π‘ƒπ‘šπ‘’π‘Žπ‘  − 𝐺𝑅 + 𝐿𝐢 + 𝐹𝑆𝑃𝐿 − 2.15 𝐸𝑅𝑃 (π‘‘π΅π‘š)−30 𝐸𝑅𝑃 (π‘Š) = 10 10 Where: F = emission frequency in MHz D = measurement distance in meters Pmeas = power measured at the spectrum analyzer GR = RX antenna gain in dBi LC = RX cable loss in dB Test Setup Receiving Spectrum EUT Antenna Analyzer Limits Operating Frequency Mean Power Limit (MHz) (W) 27.255 25 26.995 4 27.045 4 27.095 4 27.145 4 27.195 4 Test Results Frequency Measured Power Cable Loss RX Gain FSPL ERP Limit Margin (MHz) (dBm) (dB) (dBi) (dB) (mW) (W) (W) 27.045 -28.50 0.40 -17.62 4.66 0.16 4 3.84 p1880024_FCC_Part 95_Rev 1.0 Page 9 of 16

Authorized Bandwidth Engineer: Christian Pawlak Test Date: 10/16/2018 Standards: 47 CFR 95.773, RSS-210 A.2.1(e) Test Procedure The Method of Measurement was C63.26 5.4.4, with no deviations. The EUT was modulated to produce maximum deviation. Test Setup Spectrum EUT Analyzer Limits 8 kHz for any emission type Test Results Frequency 99% Bandwidth (MHz) (kHz) 27.045 7.15 p1880024_FCC_Part 95_Rev 1.0 Page 10 of 16

Authorized Bandwidth – 27.045 MHz p1880024_FCC_Part 95_Rev 1.0 Page 11 of 16

Unwanted Emissions – In-Band Mask Engineer: Christian Pawlak Test Date: 10/16/2018 Standards: 47 CFR 95.779, RSS-210 A.2.1(g) Test Procedure The Method of Measurement was C63.26 5.5.4, with no deviations. The EUT was modulated to produce maximum deviation. Emission masks were based on Transmitter Output Power data presented previously in this report. Test Setup Receiving Spectrum EUT Antenna Analyzer Limits Band of Operation Limit Reference (MHz) 47 CFR 95.779(a)(1) 26 – 28 47 CFR 95.779(a)(2) Test Results Results meet Requirements. See plots below. p1880024_FCC_Part 95_Rev 1.0 Page 12 of 16

Unwanted Emissions – In-Band Mask – 27.045 MHz p1880024_FCC_Part 95_Rev 1.0 Page 13 of 16

Unwanted Emissions – Out of Band Spurious Engineer: Christian Pawlak Test Date: 10/16/2018 Standards: 47 CFR 95.779, RSS-210 A.2.1(g) Test Procedure The Method of Measurement was C63.26 5.5.4, with no deviations. The EUT was modulated to produce maximum deviation. Emission masks were based on Transmitter Output Power data presented previously in this report. Test Setup Receiving Spectrum EUT Antenna Analyzer Limits Unwanted emissions in any frequency band removed from the channel center frequency by more than 20 kHz shall be attenuated below the transmitter output power by 43 dB + 10 log10 (transmitter power in watts) Test Results TX Emission Emission TX Output Emission Antenna Limit Margin Frequency Frequency ERP Power ERP Polarity (dBc) (dB) (MHz) (MHz) (dBm) (mW) (dBc) 27.045 N/A 0.189 -49.82 0.16 21.45 5.03 16.42 27.045 N/A 27.070 -62.42 0.16 33.92 5.03 28.89 27.045 H 54.100 -59.15 0.16 29.51 5.03 24.47 27.045 V 54.100 -51.09 0.16 22.14 5.03 17.10 27.045 H 270.430 -69.31 0.16 32.82 5.03 27.78 27.045 H 297.530 -67.24 0.16 30.42 5.03 25.38 *Six highest emissions relative to applicable limit are reported. Other emissions were >20 dB from limit. p1880024_FCC_Part 95_Rev 1.0 Page 14 of 16

Frequency Accuracy Engineer: Christian Pawlak Test Date: 10/16/2018 Standards: 47 CFR 95.765, RSS-210 A.2.1(f) Test Procedure The Method of Measurement was C63.26 5.6, with no deviations. Test Setup Frequency 10 MHz EUT Counter Reference Limits Band of Operation (MHz) Transmitter Qualifications Limit (ppm) 26 – 28 None ±50 Mean transmitter power of 2.5 W or less Used solely by the operator to turn on and/or off a 26 – 28 ±100 device at a remote location, other than a device used solely to attract attention Test Results Temperature Voltage Frequency Error Limit Margin (°C) (VDC) (MHz) (ppm) (ppm) (ppm) +50 3.7 27.0446 33.28 50 16.72 +40 3.7 27.0447 29.58 50 20.42 +30 3.7 27.0453 7.39 50 42.61 3.7 27.0455 0.00 50 50.00 +20 3.4 27.0455 0.00 50 50.00 +10 3.7 27.0450 18.49 50 31.51 0 3.7 27.0446 33.28 50 16.72 -10 3.7 27.0461 -22.18 50 27.82 -20 3.7 27.0466 -40.67 50 9.33 -30 3.7 27.0461 -22.18 50 27.82 p1880024_FCC_Part 95_Rev 1.0 Page 15 of 16

Test Equipment Utilized CT Asset Description Manufacturer Model Number Last Cal Date Cal Due Date # Power Supply GW GPX-3030D i00495 NCR NCR Multimeter Fluke 87 III i00319 05/01/2018 05/01/2019 Rohde & Spectrum Analyzer FSU26 i00501 03/27/2018 03/27/2019 Schwarz 3 Meter Semi-Anechoic Anechoic Chamber Panashield i00428 08/15/2016 08/15/2019 Chamber Spectrum Analyzer Agilent E7405A i00379 02/13/2018 02/13/2019 Antenna – Bilog Chase CBL6111C i00267 03/08/2018 03/08/2020 Antenna - Loop EMCO 6507 I00326 09/25/2017 09/25/2019 Temperature Chamber Tenney Tenney Jr i00027 NCR NCR Hydra Data Logger Fluke i00343 05/23/2018 05/23/2019 Data Bucket Frequency Counter HP 5334B i00019 NCR NCR 10 MHz Reference Fluke 910R i00541 NCR NCR Environmental Gauge Newport iBTHX-W/N i00282 06/29/2018 06/29/2019 In addition to the above listed equipment standard RF connectors and cables were utilized in the testing of the described equipment. Prior to testing these components were tested to verify proper operation. END OF TEST REPORT p1880024_FCC_Part 95_Rev 1.0 Page 16 of 16


Document Created: 2018-12-18 11:37:35
Document Modified: 2018-12-18 11:37:35
Β© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC