User Manual

FCC ID: INGTG-98TA

Users Manual

Download: PDF

FCCID_3763457

FCC Statement
FCC INFORMATION
The equipment has been tested and found to comply with the limits for a Class B
Digital Device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instruction, may cause harmful interference to radio
communication. However, there is no grantee that interference will not occur in a particular
installation. If this equipment dose cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on , the user is
encouraged to try to correct the interference by one or more of the following measures:

--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
--Consult the dealer or an experienced radio/TV technician for help.

Notice:
The changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.

IMPORTANT NOTE:
To comply with the FCC RF exposure compliance requirements, no change to the antenna or
the device is permitted. Any change to the antenna or the device could result in the device
exceeding the RF exposure requirements and void user’s authority to operate the device.

TG-98R/TG-98RA
Frequency Preparation PLL Synthesized Control
Carrier Frequency Range 470MHz~960MHz
Controls Channel Power On/Off,
Channel selection Volume control,
Group selection, Limiter, Auto OFF,
Important Caution Low Batt Warning, Key Lock, Mute,
Audio Frequency Response 40~18,000Hz
 Do not leave the devices in a place with high Output connector 1/8” Dummy stereo Phone Jack
temperature or high humidity. Battery life 10 hours typical
 Keep the devices away from fire and heat sources. Battery Rechargeable NIMH AA
 Please fully charge the battery 8 hours before (1.2V,2000mAh)
Dimension(mm) 62mm(W)* 20mm(D)* 97mm(H)
first operation, and recharge if no use for over
three months. TG-98T/TG-98TA
Internal Microphone Omni-directional Condenser
Feature Microphone
Frequency Preparation PLL Synthesized Control
TG-98T/TA Carrier Frequency Range 470MHz~960MHz
TG-98R/RA  TG-98 is designed on the base of the TG-10 10mW
WIRELESS RF Outputs
TOUR GUIDE SYSTEM
successful experience plus JTS very recent Stability ±10kHz
innovative ideas Frequency Deviation ±48kHz

TG-98R/98T  Use rechargeable AA battery
TG-98 is a wide band tour guide system with 36
Controls Power On/Off, Channel selection,
Volume control, Group selection,

TG-98RA/98TA
 RF Booster, Key Lock, Mute
MHz bandwidth Spurious Emissions <-50 dBC
Audio Frequency Response 40~18,000 Hz
 Preset 6 groups each of up to 23 channels.
WIRELESS TOUR GUIDE SYSTEM Microphone input 1/8” Mono Phone Jack
 Transmission power selectable connector
Built in limit switch of audio output Battery life 10 hours typical
 Line In at Transmitter and Line Out at Receiver, Battery Rechargeable NIMH AA
(1.2V, 2000mAh)
 ready for video camera
Dimension(mm) 62mm(W)* 20mm(D)* 97mm(H)
 Built in speaker at Receiver and microphone at
Transmitter TG-64CH36 / TG-64CH18 / TG-64CH2
 Adjustable Power Auto Off at Receiver to save Number of charging slot
battery power TG-64CH36 : 36(receiver or transmitter)
 Low battery alarm TG-64CH18 : 18(receiver or transmitter)
TG-64CH2 : 2 (receiver or transmitter)
 RF Strength gauge
Power requirement
 Panel lock TG-64CH36 : Input : AC100~240V, 2.8A ,max
 Mute Function (Transmitter ) Output : DC 12V, 16A
 Compatible with stationary transmitter TG-64CH18 : Input : AC100~240V, 1.6A ,max
Output : DC 12V, 7A
TG-98GSTX and receiver TG-98GSRX
TG-64CH2 : Input : 12~18VDC, 600mA
LED Indicator Power connected: Flash Green
Charging : Green
Full Charged:Turn off
Dimensions(mm)
TG-64CH36 : 561(W)* 399.77(D)* 230(H)
TG-64CH18 : 361.4(W)* 422(D)* 189(H)
1856 TG-64CH2 : 85(W)* 75(D)* 41(H)
59516-007
1 2

Wearing and Operating Charge Battery
CH
MIC

TG-64CH2 Use the “Neck-Strap”
and the

TT
TG-98R/TG-98RA Plug the TG-98T/TG-98R (Charger Connector faces
Charger Slot “Built-in Microphone” down) into “Charger Slot” in TG-64CH2.The “Charging

testing, and then show green light when charging. It
TG-9
8T
TG
Wir -9
MIC
eless 8T
Tour
Guide
Transmi
tter

T
12V 600mA

Charging Indicator DC input (12V)

Use the “Neck-Strap”
and the
“Mono Earphone”
Adaptor (100-240V input, 600mA 12V output) Use the “Neck-Strap”
and the
“external Microphone”

98

Accessories
Notice 1 : As soon as AC power is connected, the
T Notice 2 :
Use the “Belt-Clip” and for selt-testing during charging to protect batteries
WM-10TG the “external Microphone” from being damaged.
Mono Earphone ( For TG-98R/RA)

Use the “Belt-Clip”
Earhook Microphone
CM-801S
98 and the “Mono Earphone”

Optional : CM-201S omnidirectional
Lavaliere Microphone
(For TG-98T/TA)

T
CM-801S omnidirectional
Earhook Microphone
(For TG-98T/TA)

Neck-Strap

TG-98R(A)/TG-98T(A) WIRELESS TOUR GUIDE SYSTEM

7 8 9 10

Document Created: 2018-02-22 14:47:24
Document Modified: 2018-02-22 14:47:24

© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC