Operational Description.pdf

FCC ID: I88EMG2926Q10A

Operational Description

Download: PDF
FCCID_2197023

FCC ID: I88EMG2926Q10A




                   Operational Description
This device is a Dual-Band Wirless AC/N Gigabit Ethernet Gateway, which operates
in both of 2.4GHz and 5GHz bands; the maximum data rate could be up to
1300Mbps which OFDM technique. If the signal to noise radio is too poor which
could not support 1300Mbps, the 11Mbps data rate with DSSS technique will be
applied.


The transmitter of the EUT is powered by 12Vdc from AC adapter. The antenna is
PCB antenna with IPEX antenna connector.


The other instruction, please have a look at the user’s manual.


FCC 15.407(c) states: The device shall automatically discontinue transmission in
case of either absence of information to transmit or operational failure. These
provisions are not intended to preclude the transmission of control or signaling
information or the use of repetitive codes used by certain digital technologies to
complete frame or burst intervals.


Applicants shall include in their application for equipment authorization a description
of how this requirement is met”


Data transmission is always initiated by software, which is then pass down through
the MAC, through the digital and analog baseband, and finally to the RF chip.
Several special packets (ACKs, CTS, PSPoll, etc…) are initiated by the MAC. There
are the only ways the digital baseband portion will turn on the RF transmitter, which
it then turns off at the end of the packet. Therefore, the transmitter will be on only
while one of the aforementioned packets are being transmitted.




Report No.: RF140206C03



Document Created: 2014-02-17 12:00:53
Document Modified: 2014-02-17 12:00:53

© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC