User Manual

FCC ID: I28-M6ENANO

Users Manual

Download: PDF
FCCID_4177204

Installation Guide M6E-NANO Compliance and Regulatory Statements FCC Compliance Statement (USA) This device complies with Part 15 rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for Class B Digital Devices, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a residential environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the product manuals, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, the user is encouraged to do one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced RF service technician for help. The end product must be labeled, in a visible area, with the following: Contains FCC ID: I28-M6ENANO Modification Warning The user is cautioned that any changes or modifications not expressly approved by Zebra Technologies could void the user s authority to operate the equipment. To ensure compliance, this printer must be used with fully shielded communication cables. RF Exposure Statement This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

Canadian DOC Compliance Statement Cet appareil numerique de la classe B est conforme a la norme NMB-003 du Canada. This Class B digital apparatus complies with Canadian ICES-003. Industry Canada (IC) Warning Le present appareil est conforme aux CNR d Industrie Canada applicables aux appareils radio exempts de licence. L exploitation est autorisee aux deux conditions suivantes : (1 appareil ne doit pas produire de brouillage, et (2 l utilisateur de l appareil doit accepter tout brouillage radioelectrique subi, meme si le brouillage est susceptible n compromettre le fonctionnement. This device complies with Industry Canada license-exempt RSS standard(s. Operation is subject to the following two conditions: 1 This device may not cause interference., 2 This device must accept any interference, including interference that may cause undesired operation of the device. The end product must be labeled, in a visible area, with the following: Contains IC: 3798B-M6ENANO Approved Antenna information Only the antenna tested with this module is allowed and cannot be user replaceable. This radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication. General The M6ENANO module has been certified as a Single Modular. Additional evaluation is required for use in all host devices. The following describes the installation procedures for the various hosts in which the module has been evaluated. Installation Instructions for Zebra Printers The M6E-NANO is not intended for OEM integrators or end users. It can only be installed in the Zebra printers at the grantee manufacturing facility.


Document Created: 2019-02-15 12:26:40
Document Modified: 2019-02-15 12:26:40
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC