Modular Approval Letter

FCC ID: I28-M6ENANO

Cover Letter(s)

Download: PDF
FCCID_4177180

(Company Letter head) 1/28/2019 (Product name) FCC ID I28-M6ENANO is seeking FCC Authorization as a �Single Modular transmitter ID Single Limited Modular Approval (Please check one) The EUT meets the requirements for �Single Modular approval/ □ Single Limited Modular Approval (please check one) as detailed in KDB 996369. Compliance to each of the requirements is described below: Item Modular requirement Yes No Please provide a detailed explanation if the answer is 11 No." 1 Have its own RF shielding y 2 Have buffered modulation/data inputs (if such inputs are provided) y The modular transmitter must have its own power supply 3 regulation. y 4 Meet the antenna requirements of section 15.203 y Be tested in a stand-alone configuration, i.e., the antenna, AC or DC power and data input/output lines must be connected to the 5 module but, the module must not be inside another case during y testinq. Be labeled with its own FCC ID number, and if the FCC ID is not visible when the module is installed inside another device, then 6 the outside of the device into which the module is installed must y also display a label referrinq to the enclosed module. The modular transmitter is manufactured so that the user can not 7 influence the operation of the transmitter that will operate outside y of the scope of the requlations. Address compliance with the Commission's RF exposure limits 8 in Sections 1.1310 and 2.1093. y Note: (1) LMA may be granted when one or more of the requirements in the table above cannot be demonstrated. LMA will also be issued in those instances where applicants can demonstrate that they will retain control over the final installation of the device, such that compliance of the end product is assured. In such cases, an operating condition on the LMA for the module must state that the module is only approved for use when installed in devices produced by a specific manufacturer. When LMA is sought, the application for equipment certification must specifically state how control of the end product into which the module will be installed, and will be maintained, such that full compliance of the end product is always ensured. (2) Please provide Clear and specific instructions describing the conditions, limitations and procedures for third-parties to use and/or integrate the module into a host device. (3) For non-Software Defined Radio transmitter modules where software is used to ensure compliance of the device, technical description of how such control is implemented to ensure prevention of third party modification must be provided (see KDB 594280). Note 1: Compliance of a module in its final configuration is the responsibility of the applicant. A host device will not be considered certified if the instructions regarding antenna configuration provided in the original description, of one or more separately certified modules it contains, were not followed. Example: A separately certified low-power transceiver module using Bluetooth technology which is housed in a desktop computer, laptop or peripheral does not require the overall system to be recertified, if the desktop computer, laptop or peripheral, as a stand-alone unit, complies with all applicable technical standards. Client's signature: {!�----;;----,_ Client's name/ title: Charles A. Derrow - Director, Compliance Engineering Contact information/ add ress: 3 Overlook Point, Lincolnshire, IL 60069 USA SCS-F26 Modular Approval Letter Page 2 of 3 Rev 11.0


Document Created: 2019-02-06 13:21:35
Document Modified: 2019-02-06 13:21:35
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC