Description

FCC ID: HYQ12BZE

Operational Description

Download: PDF
FCCID_318965

1. Description of manufacturer
1.1. Trade mark
                                     :


1.2. Name and address of manufacturer
         - Name                      :DENSO CORPORATION
         - Address                   :1-1 Showa-cho, Kariya-city, Aichi-prefecture,
                                     448-8661, Japan




1.3. Name and address of applicant
         - Name                      : DENSO CORPORATION
         - Address                   : 1-1 Showa-cho, Kariya-city, Aichi- prefecture,
                                     448-8661, Japan


2. Technical description of the system
2.1. Type number
         - Transmitter                         : 12BZE


2.2. Specifications of transmitter
         - Nominal frequency                   : 314.00 MHz
         - oscillator frequency                : 314.00 MHz SAW resonator
         - Radio frequency output power        : 75.6dBμV/m or less at 3m (*)
         - Type of modulation                  : A1D
         - Power Supply
                   - Nominal supply voltage    : 3 VDC
                   - Type of Battery           : One lithium battery
         - Antenna                                       : Built-in type (Fixed)



         ∗ Note: Calculation of Voltage Average Level
                   A transmitter has the one complete pulse train

                   Voltage Average Level( µV) = (Epeak × Tt) ÷ T
                                            = (Epeak × 89.6msec) ÷ 179.2msec

                   Epeak = Voltage peak level
                   T = One complete pulse train time including blanking interval
                   Tt = Total pulse of transmitter in one complete pulse train


3. Outline of the system
3.1. Description of the system operation
This system is mainly used for locking or unlocking the doors of the vehicle.
The transmitter send a radio wave signal while the button is pushed.
The receiver becomes active in response to the signal from the transmitter.


3.2. Installation in vehicle
The receiver is installed inside the vehicle.




             Remote Keyless Entry System

                                                           Installation in vehicle
              Driver
        Transmitter                             Receiver            ECU              Actuator




                                     Fig Outline of the System


6. Component listing
 Transmitter


               Part Name                  Description   Number of Units
       IC                  -                                  1
       SAW Resonator       314.00MHz                          1
       LED                 -                                  1
       Transistor          -                                  2
       Resistor     (a)    2.2-4.7k ohm                       1
       Resistor     (b)    2.2-4.7k ohm                       1
       Resistor     (c)    100-330 ohm                        1
       Capacitor    (d)    0.5-5pF                            1
       Capacitor     (e)   0.5-6pF                            1
       Capacitor    (f)    0.5-14pF                           1
       Capacitor    (g)    0.5-2pF                            1
       Capacitor    (h)    0-40pF                             1
       Capacitor     (i)   0-40pF                             1
       Capacitor    (j)    0-40pF                             0
       Inductor     (k)    22-37nH                            1
       Switch              -                                3 or 2
       Battery             3V                                 1



Document Created: 2003-03-04 16:57:16
Document Modified: 2003-03-04 16:57:16

© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC