MPE for WLAN

FCC ID: HFS-C500

RF Exposure Info

Download: PDF
FCCID_3629332

Report No.: E2/2017/90033 1 MAXIMUM PERMISSIBLE EXPOSURE (MPE) 1.1 Standard Applicable According to §1.1307(b)(1), systems operating under the provisions of this section shall be op- erated in a manner that ensure that the public is not exposed to radio frequency energy level in excess of the Commission’s guideline. This is a Mobile device, the MPE is required. According to §1.1310 and §2.1091 RF exposure is calculated. Limits for Maximum Permissive Exposure (MPE) Frequency Range Electric Field Magnetic Field Power Density Averaging Time (MHz) Strength (V/m) Strength (A/m) (mW/cm2) (minute) Limits for General Population/Uncontrolled Exposure 0.3-1.34 614 1.63 *(100) 30 1.34-30 824/f 2.19/f *(180/f2 ) 30 30-300 27.5 0.073 0.2 30 300-1500 / / F/1500 30 1500-15000 / / 1.0 30 F = frequency in MHz * = Plane-wave equipment power density Unless otherwise stated the results shown in this test report refer only to the sample(s) tested and such sample(s) are retained for 90 days only. 除非另有說明，此報告結果僅對測試之樣品負責，同時此樣品僅保留90天。本報告未經本公司書面許可，不可部份複製。 This document is issued by the Company subject to its General Conditions of Service printed overleaf, available on request or accessible at www.sgs.com/terms_and_conditions.htm and, for elec- tronic format documents, subject to Terms and Conditions for Electronic Documents at www.sgs.com/terms_e-document.htm. Attention is drawn to the limitation of liability, indemnification and jurisdiction issues defined therein. Any holder of this document is advised that information contained hereon reflects the Company’s findings at the time of its intervention only and within the limits of Client’s instructions, if any. The Company’s sole responsibility is to its Client and this document does not exonerate parties to a transaction from exercising all their rights and obligations under the transaction documents. This document cannot be reproduced except in full, without prior written approval of the Company. Any unauthorized alteration, forgery or falsification of the content or ap- pearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law. SGS Taiwan Ltd. No.134,WuKungRoad,NewTaipeiIndustrialPark,WukuDistrict,NewTaipeiCity,Taiwan24803/新北市五股區新北產業園區五工路 134 號 台灣檢驗科技股份有限公司 t (886-2) 2299-3279 f (886-2) 2298-0488 www.tw.sgs.com Member of SGS Group

Report No.: E2/2017/90033 1.2 Maximum Permissible Exposure (MPE) Evaluation 802.11b_MIMO Avg. Output Max. Avg. Output Max. Avg. Output Freq. Data Power include tune up include tune up CH (dBm) Limit RESULT (MHz) Rate tolerance Power tolerance Power (dBm) (mW) CH 0 CH 1 1 2412 1 10.51 11.24 13.91 24.55 1 Watt = 30.00 dBm PASS 6 2437 1 10.57 11.32 13.98 24.95 1 Watt = 30.00 dBm PASS 11 2462 1 10.55 11.27 13.95 24.75 1 Watt = 30.00 dBm PASS MPE Prediction (802.11b 2412~2462) Prediction of MPE limit at a given distance Equation from page 18 of OET Bulletin 65, Edition 97-01 S=PG/4πR2 Where: S = Power density P = Power input to antenna G = Power gain of the antenna in the direction of interest relative to an isotropic radiator R = Distance to the center of radiation of the antenna Max. output power including tune-up tolerancel: 13.98 (dBm) Max. output power including tune-up tolerancel: 25.003454 (mW) Duty cycle: 99.72 (%) Maximum Pav : 24.933444 (mW) Peak Antenna gain (Maximum): 4.1 (dBi) Peak Antenna gain (linear): 2.5703958 (numeric) Prediction distance: 20 (cm) Prediction frequency: 2437 (MHz) MPE limit for uncontrolled exposure at prediction frequency: 1 (mW/cm2) Power density at predication frequency at 20 (cm) distance 0.013 (mW/cm2) Measurement Result The predicted power density level at 20 cm is 0.013 mW/cm2. This is below the uncontrolled exposure limit of 1 mW/cm2 at 2437MHz. Unless otherwise stated the results shown in this test report refer only to the sample(s) tested and such sample(s) are retained for 90 days only. 除非另有說明，此報告結果僅對測試之樣品負責，同時此樣品僅保留90天。本報告未經本公司書面許可，不可部份複製。 This document is issued by the Company subject to its General Conditions of Service printed overleaf, available on request or accessible at www.sgs.com/terms_and_conditions.htm and, for elec- tronic format documents, subject to Terms and Conditions for Electronic Documents at www.sgs.com/terms_e-document.htm. Attention is drawn to the limitation of liability, indemnification and jurisdiction issues defined therein. Any holder of this document is advised that information contained hereon reflects the Company’s findings at the time of its intervention only and within the limits of Client’s instructions, if any. The Company’s sole responsibility is to its Client and this document does not exonerate parties to a transaction from exercising all their rights and obligations under the transaction documents. This document cannot be reproduced except in full, without prior written approval of the Company. Any unauthorized alteration, forgery or falsification of the content or ap- pearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law. SGS Taiwan Ltd. No.134,WuKungRoad,NewTaipeiIndustrialPark,WukuDistrict,NewTaipeiCity,Taiwan24803/新北市五股區新北產業園區五工路 134 號 台灣檢驗科技股份有限公司 t (886-2) 2299-3279 f (886-2) 2298-0488 www.tw.sgs.com Member of SGS Group

Report No.: E2/2017/90033 1.3 Maximum Permissible Exposure (MPE) Evaluation 802.11g_MIMO Avg. Output Max. Avg. Output Max. Avg. Output Freq. Data Power include tune up include tune up CH (dBm) Limit RESULT (MHz) Rate tolerance Power tolerance Power (dBm) (mW) CH 0 CH 1 1 2412 6 11.53 12.14 14.96 30.59 1 Watt = 30.00 dBm PASS 6 2437 6 11.36 11.91 14.76 29.20 1 Watt = 30.00 dBm PASS 11 2462 6 11.44 12.08 14.89 30.08 1 Watt = 30.00 dBm PASS MPE Prediction (802.11g 2412~2462) Prediction of MPE limit at a given distance Equation from page 18 of OET Bulletin 65, Edition 97-01 S=PG/4πR2 Where: S = Power density P = Power input to antenna G = Power gain of the antenna in the direction of interest relative to an isotropic radiator R = Distance to the center of radiation of the antenna Max. output power including tune-up tolerancel: 14.96 (dBm) Max. output power including tune-up tolerancel: 31.332857 (mW) Duty cycle: 97.55 (%) Maximum Pav : 30.565202 (mW) Peak Antenna gain (Maximum): 4.1 (dBi) Peak Antenna gain (linear): 2.5703958 (numeric) Prediction distance: 20 (cm) Prediction frequency: 2412 (MHz) MPE limit for uncontrolled exposure at prediction frequency: 1 (mW/cm2) Power density at predication frequency at 20 (cm) distance 0.016 (mW/cm2) Measurement Result The predicted power density level at 20 cm is 0.016 mW/cm2. This is below the uncontrolled exposure limit of 1 mW/cm2 at 2412MHz. Unless otherwise stated the results shown in this test report refer only to the sample(s) tested and such sample(s) are retained for 90 days only. 除非另有說明，此報告結果僅對測試之樣品負責，同時此樣品僅保留90天。本報告未經本公司書面許可，不可部份複製。 This document is issued by the Company subject to its General Conditions of Service printed overleaf, available on request or accessible at www.sgs.com/terms_and_conditions.htm and, for elec- tronic format documents, subject to Terms and Conditions for Electronic Documents at www.sgs.com/terms_e-document.htm. Attention is drawn to the limitation of liability, indemnification and jurisdiction issues defined therein. Any holder of this document is advised that information contained hereon reflects the Company’s findings at the time of its intervention only and within the limits of Client’s instructions, if any. The Company’s sole responsibility is to its Client and this document does not exonerate parties to a transaction from exercising all their rights and obligations under the transaction documents. This document cannot be reproduced except in full, without prior written approval of the Company. Any unauthorized alteration, forgery or falsification of the content or ap- pearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law. SGS Taiwan Ltd. No.134,WuKungRoad,NewTaipeiIndustrialPark,WukuDistrict,NewTaipeiCity,Taiwan24803/新北市五股區新北產業園區五工路 134 號 台灣檢驗科技股份有限公司 t (886-2) 2299-3279 f (886-2) 2298-0488 www.tw.sgs.com Member of SGS Group

Report No.: E2/2017/90033 1.4 Maximum Permissible Exposure (MPE) Evaluation 802.11n_HT20M MIMO Peak Output Total Peak Total Peak Freq. Power Data CH Output Power Output Power Limit RESULT (MHz) (dBm) Rate CH 0 CH 1 (dBm) (mW) 1 2412 MCS8 18.47 18.62 21.56 143.09 1 Watt = 30.00 dBm PASS 6 2437 MCS8 18.05 18.52 21.30 134.95 1 Watt = 30.00 dBm PASS 11 2462 MCS8 18.35 18.57 21.47 140.34 1 Watt = 30.00 dBm PASS 802.11n_HT20M MIMO Avg. Output Max. Avg. Output Max. Avg. Output Freq. Data Power include tune up include tune up CH Limit RESULT (MHz) Rate (dBm) tolerance Power tolerance Power CH 0 CH 1 (dBm) (mW) 1 2412 MCS8 11.59 11.86 14.97 29.77 1 Watt = 30.00 dBm PASS 6 2437 MCS8 11.39 11.75 14.81 28.73 1 Watt = 30.00 dBm PASS 11 2462 MCS8 11.51 11.82 14.91 29.36 1 Watt = 30.00 dBm PASS MPE Prediction (802.11n20 2412~2462) Prediction of MPE limit at a given distance Equation from page 18 of OET Bulletin 65, Edition 97-01 S=PG/4πR2 Where: S = Power density P = Power input to antenna G = Power gain of the antenna in the direction of interest relative to an isotropic radiator R = Distance to the center of radiation of the antenna Max. output power including tune-up tolerance: 14.97 (dBm) Max. output power including tune-up tolerancel: 31.405087 (mW) Duty cycle: 94.89 (%) Maximum Pav : 29.800287 (mW) Peak Antenna gain (Maximum): 4.1 (dBi) Peak Antenna gain (linear): 2.5703958 (numeric) Prediction distance: 20 (cm) Prediction frequency: 2412 (MHz) MPE limit for uncontrolled exposure at prediction frequency: 1 (mW/cm2) Power density at predication frequency at 20 (cm) distance 0.015 (mW/cm2) Measurement Result The predicted power density level at 20 cm is 0.015 mW/cm2. This is below the uncontrolled exposure limit of 1 mW/cm2 at 2412MHz. Unless otherwise stated the results shown in this test report refer only to the sample(s) tested and such sample(s) are retained for 90 days only. 除非另有說明，此報告結果僅對測試之樣品負責，同時此樣品僅保留90天。本報告未經本公司書面許可，不可部份複製。 This document is issued by the Company subject to its General Conditions of Service printed overleaf, available on request or accessible at www.sgs.com/terms_and_conditions.htm and, for elec- tronic format documents, subject to Terms and Conditions for Electronic Documents at www.sgs.com/terms_e-document.htm. Attention is drawn to the limitation of liability, indemnification and jurisdiction issues defined therein. Any holder of this document is advised that information contained hereon reflects the Company’s findings at the time of its intervention only and within the limits of Client’s instructions, if any. The Company’s sole responsibility is to its Client and this document does not exonerate parties to a transaction from exercising all their rights and obligations under the transaction documents. This document cannot be reproduced except in full, without prior written approval of the Company. Any unauthorized alteration, forgery or falsification of the content or ap- pearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law. SGS Taiwan Ltd. No.134,WuKungRoad,NewTaipeiIndustrialPark,WukuDistrict,NewTaipeiCity,Taiwan24803/新北市五股區新北產業園區五工路 134 號 台灣檢驗科技股份有限公司 t (886-2) 2299-3279 f (886-2) 2298-0488 www.tw.sgs.com Member of SGS Group


Document Created: 2017-11-02 08:40:44
Document Modified: 2017-11-02 08:40:44
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC