Exhibit D Users Manual per 2 1033 b3

FCC ID: HBW2281

Users Manual

Download: PDF
FCCID_660874

Single-Button Remote Control Model 300MC *For use with 300 MHz Multi-Code™ compatible receivers including Chamberlain Tri-Code Receivers. WARNING To prevent possible SERIOUS INJURY or DEATH from a moving gate or garage door: CAUTION • ALWAYS keep remote controls out of reach of children. NEVER permit children to operate, or play with remote controls. • Activate gate or door ONLY when it can be seen clearly, is properly adjusted, and there are no obstructions to door travel. • ALWAYS keep gate or garage door in sight until completely closed. NEVER permit anyone to cross path of moving gate or door. Locating your code switches To match or change the code in the remote control Slide the battery compartment cover back to access the code switches in the remote control (Figure 1). Locate the code switches in both the new and the original remote controls, either by removing the case screw and cover or by sliding the battery compartment cover back. Place remote controls side by side as shown (Figure 2) Figure 1 and set switches in all remote controls to matching Model 300MC positions (ON/OFF). Use a pen or screwdriver to slide the code switches. N O 1– 0 + 2 3 4 5 6 7 8 9 10 Figure 2 N O N O N O 1 1 2 2 3 3 1 4 4 5 5 6 6 7 7 8 8 2 9 10 9 10 3 Match code switches (1-10) 4 between old remote control 5 and new remote control 6 N O 1 N O N O 2 1 1 7 3 2 2 4 3 3 5 4 4 6 5 5 7 6 6 8 7 7 8 9 10 8 8 9 10 9 10 9 10 Match code switches (1-10) Match code switches (2-10) between old remote control between old remote control and and new remote control new remote control Code Switches (1-10) *Multi-Code™ is the trademark of The Linear Corporation

Match the remote control to the The Remote Control Batteries receiver: 1. Check the code switch settings on the O WARNING N H receiver. 1 2 3 4 5 6 7 8 9 10 I G H N OR To prevent possible SERIOUS INJURY or DEATH: 2. Use a pen or screw driver to set the • NEVER allow small children near batteries. code switches on the back of the remote CAUTION • If battery is swallowed, immediately notify doctor. O control to match the code switches on N 1 2 3 4 5 6 7 8 9 10 the back of the receiver. Locate the battery by sliding the 3. Once the code switches have been set battery compartment cover. push the remote control button to activate your unit. Dispose of old batteries properly. NOTICE: To comply with FCC and or Industry Canada (IC) rules, adjustment or modifications of this receiver and/or transmitter are prohibited, except for changing the code setting or replacing the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS. Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Contact us at www.chamberlain.com © 2006 The Chamberlain Group, Inc. 114A3264 All Rights Reserved


Document Created: 2006-05-12 07:50:12
Document Modified: 2006-05-12 07:50:12
© 2025 FCC.report
This site is not affiliated with or endorsed by the FCC