Exhibit D Users Manual per 2 1033 b3

FCC ID: HBW2028

Users Manual

Download: PDF
FCCID_495091

134. 53753 Mocdelamtii@tistQ®e — CRAFTSMAN 315 MHz Security** 3—Function Remote Control Owner‘s Manual Only for use with 315 MHz Security4® garage door openers and universal receivers that have an orange "learn" button. Instructions are Described and lIllustrated Below or garage door: * ALWAYS keep remote controls out of reach of children. NEVER permit children to operate, or play with remote control transmitters. * Activate gate or door ONLY when it can be seen clearly, is properly adjusted, and there are no obstructions to door travel. * ALWAYS keep gate or garage door in sight until completely closed. NEVER permit anyone to cross path of moving gate or door. The Remote Control Batteries To prevent possible SERIOUS INJURY or DEATH: *« NEVER allow small children near batteries. 1. Press and release the "Learn" * If battery is swallowed, immediately notify doctor. button. The learn indicator light will glow steadily for 30 seconds. The lithium batteries should produce power for up to 5 years. To replace, pry open case with visor clip or Open this end 2. Within 30 seconds, press and hold the button on the hand—held remote. screwdriver, as shown. Insert batteries matching polarity housing instructions inside the remote cover 3. Release the button when the light blinks. It ~ 1z or on the printed circuit board. has learned the code. —— — Dispose of old batteries properly. To Erase All Codes From Motor Unit Memory NOTICE: To comply with FCC and or Industry Canada {IC) rules, adjustment or modifications of this receiver and/or transmitter are prohibited, except for changing the code setting or replacing the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS. To deactivate any unwanted remote, first erase all codes: Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must Press and hold the "learn" button until accept any interference received, including interference that may cause undesited operation. the learn indicator light goes out (approximately 6 seconds). All To order replacement parts call... previous codes are now erased. 1—800—4—MY—HOME® (1—800—469—4663) Reprogram each remote or keyless entry you wish to use. To Control the Opener Lights NOTE: Not available with universal receiver., With 315 MHz Security«k® transmitters, a remote push button can be programmed to operate the opener lights without opening the door. 1. With the door closed, press and hold the remote button that you want to control the light. 2. Press and hold the Light button on the door control. 3. Press and hold the Lock button on the door control. 4. After the opener lights flash, release all buttons. Test by pressing the remote push button. The opener lights should turn on or off but the door should not move. © 2004, Sears, Roebuck and Co./ ® Registered Trademark / * Trademark / " Service Mark of Sears, Roebuck and Co. 114A3018 ® Marca Registrada / "Marca de Fabrica / *" Marca de Servicio de Sears, Roebuck and Co. Printed in Mexico


Document Created: 2019-10-11 03:50:21
Document Modified: 2019-10-11 03:50:21
© 2025 FCC.report
This site is not affiliated with or endorsed by the FCC