8

FCC ID: HBW1334

Users Manual

Download: PDF
FCCID_16196

6. OPERATING INSTRUCTIONS

v Receiver & Remote Control Programming L} NOTICE: To comply with FCC rules, adjustment or modification of this receiver and/or transmitter are prohibited, except for changing the coda setting or replacing the transmitter battery. THERE ARE NO OTHER USER SERVICEASLE ParTs. Children operating or playing with a garage Your garage door opener receiver and remote door opener can injure themselves or others. The garage door could close and cause control have been set at the factory to a matching serious infury or death. Do not allow children code. The opener will activate when the LARGE to operate the door controi(s) or remote button on the remote(s) is pressed. The multi— control transmitter(s). function remote(s) can also activate additional garage door openers and/or light control models A moving garage door could injure or kill andarson—. someone under it. Activate the opener only when you can see the door clearly, it is free of Below are instructions for programming your opener obstructions, and is properly adjusted. to match the other buttons on your multi—function remote and any additional remotes you may purchase. See available accessories on page 38. Figure 1 Your *Smart" garage door opener will operate with Multi—Function Remote Control up to four "*Smart" remote controls {with green indicator lights), a Keyless Entry System and code switch remote controls with red indicatorlights. Battery Indicator Light To Add A Remote Select a push button to operate the receiver, Select a Remota Figure 1. Push Button 1. Press and hold the remote push button. 2. Then press and release the "Smart" button on the right side panel! of the opener, Figure 2. The opener lights will fash once. 3. Release the remote push button. Now the opener will operate when the remote Figure 2 control push button is pressed. If you release the remote control push button Garage Door Opener before the opener lights flash, the opener will (With "Smart" Button) not accept the code. To Change the Selected Push Button On the Same Remote If you decide to use a different remote control button than originally programmed into the opener, you need to erase all the learned codes and reprogram each remote used to operate the garage door opener. To Erase Ail Remote Control Codes Code programming instructions are also located * Press and hold the *Smart" button on the opener on the opener panel, panel untif the indicator light turns off {about 6 seconds}. All the codes the opener has learned will be erased. * To reprogram, repeat Steps 1 — 3 for each remote control in use.


Document Created: 2001-07-12 07:57:55
Document Modified: 2001-07-12 07:57:55
© 2025 FCC.report
This site is not affiliated with or endorsed by the FCC