Test Report Part 2

FCC ID: H8NWLL3050

Test Report

Download: PDF
FCCID_497231

FCC ID: H8NWLL3050 4.5 POWER SPECTRAL DENSITY MEASUREMENT 4.5.1 LIMITS OF POWER SPECTRAL DENSITY MEASUREMENT The Maximum of Power Spectral Density Measurement is 8dBm. 4.5.2 TEST INSTRUMENTS Description & Manufacturer Model No. Serial No. Calibrated Until SPECTRUM ANALYZER FSEK30 100049 Aug. 12, 2005 NOTE: The calibration interval of the above test instruments is 12 months and the calibrations are traceable to NML/ROC and NIST/USA. Report No.: RF920624R01B 43 Issued: Dec. 07, 2004 Reference No.: RF920624R01

FCC ID: H8NWLL3050 4.5.3 TEST PROCEDURE The transmitter output was connected to the spectrum analyzer through an attenuator, the bandwidth of the fundamental frequency was measured with the spectrum analyzer using 3kHz RBW and 30kHz VBW, set sweep time=span/3kHz. The power spectral density was measured and recorded. The sweep time is allowed to be longer than span/3KHz for a full response of the mixer in the spectrum analyzer. 4.5.4 DEVIATION FROM TEST STANDARD No deviation 4.5.5 TEST SETUP EUT SPECTRUM ANALYZER 4.5.6 EUT OPERATING CONDITIONS Same as 4.3.6 Report No.: RF920624R01B 44 Issued: Dec. 07, 2004 Reference No.: RF920624R01

FCC ID: H8NWLL3050 4.5.7 TEST RESULTS (A) EUT Mini-PCI CARD MODEL WLL3050 INPUT POWER ENVIRONMENTAL 24deg. C, 64%RH, 120Vac, 60 Hz (SYSTEM) CONDITIONS 991hPa TESTED BY: Leo Hung CHANNEL RF POWER LEVEL MAXIMUM CHANNEL FREQUENCY IN3 kHz BW LIMIT PASS/FAIL (MHz ) (dBm) (dBm) 1 2412 -8.38 8 PASS 6 2437 -8.80 8 PASS 11 2462 -8.80 8 PASS Report No.: RF920624R01B 45 Issued: Dec. 07, 2004 Reference No.: RF920624R01

FCC ID: H8NWLL3050 CH1 Report No.: RF920624R01B 46 Issued: Dec. 07, 2004 Reference No.: RF920624R01

FCC ID: H8NWLL3050 CH6 Report No.: RF920624R01B 47 Issued: Dec. 07, 2004 Reference No.: RF920624R01

FCC ID: H8NWLL3050 CH11 Report No.: RF920624R01B 48 Issued: Dec. 07, 2004 Reference No.: RF920624R01

FCC ID: H8NWLL3050 4.5.8 TEST RESULTS (B) EUT Mini-PCI CARD MODEL WLL3050 INPUT POWER ENVIRONMENTAL 24deg. C, 64%RH, 120Vac, 60 Hz (SYSTEM) CONDITIONS 991hPa TESTED BY: Leo Hung CHANNEL RF POWER LEVEL IN MAXIMUM CHANNEL FREQUENCY 3 kHz BW LIMIT PASS/FAIL (MHz ) (dBm) (dBm) 1 2412 -12.19 8 PASS 6 2437 -12.49 8 PASS 11 2462 -11.75 8 PASS Report No.: RF920624R01B 49 Issued: Dec. 07, 2004 Reference No.: RF920624R01

FCC ID: H8NWLL3050 CH1 Report No.: RF920624R01B 50 Issued: Dec. 07, 2004 Reference No.: RF920624R01

FCC ID: H8NWLL3050 CH6 Report No.: RF920624R01B 51 Issued: Dec. 07, 2004 Reference No.: RF920624R01

FCC ID: H8NWLL3050 CH11 Report No.: RF920624R01B 52 Issued: Dec. 07, 2004 Reference No.: RF920624R01

FCC ID: H8NWLL3050 4.6 BAND EDGES MEASUREMENT 4.6.1 LIMITS OF BAND EDGES MEASUREMENT Below –20dB of the highest emission level of operating band (in 100KHz Resolution Bandwidth). 4.6.2 TEST INSTRUMENTS Description & Manufacturer Model No. Serial No. Calibrated Until SPECTRUM ANALYZER FSEK30 100049 Aug. 12, 2005 NOTE: The calibration interval of the above test instruments is 12 months and the calibrations are traceable to NML/ROC and NIST/USA. 4.6.3 TEST PROCEDURE The transmitter output was connected to the spectrum analyzer via a low lose cable. Set both RBW and VBW of spectrum analyzer to 100kHz and 100kHz with suitable frequency span including 100 MHz bandwidth from band edge. The band edges was measured and recorded. 4.6.4 DEVIATION FROM TEST STANDARD No deviation Report No.: RF920624R01B 53 Issued: Dec. 07, 2004 Reference No.: RF920624R01

FCC ID: H8NWLL3050 4.6.5 EUT OPERATING CONDITION Same as Item 4.3.6 4.6.6 TEST RESULTS The spectrum plots are attached on the following 8 pages. D2 line indicates the highest level, D1 line indicates the 20dB offset below D2. It shows compliance with the requirement in part 15.247(d). NOTE1: The band edge emission plot of CCK technique on the following 1~2 page shows 48.30dB delta between carrier maximum power and local maximum emission in restrict band (2.3886GHz). The emission of carrier strength list in the test result of channel 1 at the item 4.2.7 is 98.17dBuV/m, so the maximum field strength in restrict band is 98.17-48.30=49.87dBuV/m which is under 54dBuV/m limit. NOTE2: The band edge emission plot of CCK on the following 3~4 page shows 49.86dB delta between carrier maximum power and local maximum emission in restrict band (2.4872GHz ). The emission of carrier strength list in the test result of channel 11 at the item 4.2.7 is 99.08dBuV/m, so the maximum field strength in restrict band is 99.08-49.86=49.22dBuV/m which is under 54 dBuV/m limit. NOTE3: The band edge emission plot of OFDM technique on the following 5~6 page shows 42.79dB delta between carrier maximum power and local maximum emission in restrict band (2.3900GHz). The emission of carrier strength list in the test result of channel 1 at the item 4.2.8 is 95.56dBuV/m, so the maximum field strength in restrict band is 95.56-42.79=52.77dBuV/m which is under 54 dBuV/m limit. NOTE4: The band edge emission plot of OFDM on the following 7~8 page shows 43.72dB delta between carrier maximum power and local maximum emission in restrict band (2.4835GHz ). The emission of carrier strength list in the test result of channel 11 at the item 4.2.8 is 93.63dBuV/m, so the maximum field strength in restrict band is 93.63-43.72=49.91dBuV/m which is under 54dBuV/m limit. Report No.: RF920624R01B 54 Issued: Dec. 07, 2004 Reference No.: RF920624R01

+man 200 wite maskes 1 (91) *van 200 kare 6.77 aam mee 20 .8 asn taee 20 as sun 10 m 2.420000000 onz To ore ec o.3 as Hazkef][2 ( m —s2]10 dam 297200h00oxz| Lo —20 2 —hs.3 as —20 |—z0 |—co Genter 2.371 ons zo mie, Span 100 se B

*rem 200 kz masker 2 (2i ) *ven 200 knz ~42.50 dn mos 20.3 dam *ace 20 as s 2.2s a 22.5e0000000 onz Te offfec onf as or ¢.7 h on ne chs.3 an ~20 mao «60 70 Staze 2.5 onz 2.2s one7 stop 2s one B

® *ram 200 sate Mazker a [z j *vom 200 se 6. sa dn mee 20.5 amm *mee 20 as sez 10 ms 2.462e00000 one 2o offfec o.f as Harkes]2 {n <a7 as asn Lana 1 6.54) mm mari a —as s abn mazkes) a ( im [ _|~\ <ar don se \»13.45 abl 2:sov0t0 ouz —zo ~20— —10 —so |—so —70 # i Center 2.502 on 20 re, span 200 ame B

*mam 200 kz waskes a on a *vam 200 kiz ~12.39 aom nee 20.5 aon *ace 30 an sez 2225 8 21.850000000 onz To offfec onf as ho 1 6.54 ase in |—20 ne hs.46 ab —20 ~30 Start 2.5 onz 2.2s one/ stop 25 onz B

*aaw 200 kxz wmaskes a oo) rvow 200 kie 1027 dn res 20.5 asm tase so as sne 20 ns 2.107000000 oire 2 Giffec o.f an man(s 2 (m —zrlas asn 10 22200000 ce BW 1 1.17) anm >gurlez amn waskdel (as on |—10 —azlor a 2. reseooboo su( s se he.ss a ~co ~r0 m Center 2.372 onz 2o ame7 Span 200 ame B

® *rsw 200 ks aackes 2 Cfi 3 *vaw 100 Je —42.23 dan mez: 20.5 on tase o as sur 2.2s s 23.940000000 ons To orffec o. an 10 jnew c a 1.17) dn —ae mee se ho.03 cbe —so [«: & —10 Stare 2.5 ons 2.25 one7 stop 25 on

*mew 100 kus Mazker 2 (an ) *vem 200 ks 2.60 asm mee 20.5 abm *ase so as sez 10 ms 2.462100000 on To offfer o.f as Hazker] 2 t on carli2 aam 4s3500h00 one [R mazkes) s tz ~42}77 aom Hazker| a on w ~si}so amn 2:ssovnopoc ons se hec4 ast —s0 ~so —so # Center 2. 5o1 one 20 rare span 200 ane B

& mm ase es see #6i8 u9 Hmits ho merkere onThe ase es se se ue Brerus‘s Prprinpprets—smtmemmmessurge.mngorsommmmmmneonnmommm aie snsesoionle ns, To offfec o—} as s i0 CJ or 1.6 Fom e io ne ho. 4 asl —30— |—so L0 Staze 2.5 one 2.25 one, stop 25 on B

FCC ID: H8NWLL3050 4.7 ANTENNA REQUIREMENT 4.7.1 STANDARD APPLICABLE For intentional device, according to FCC 47 CFR Section 15.203, an intentional radiator shall be designed to ensure that no antenna other than that furnished by the responsible party shall be used with the device. And according to FCC 47 CFR Section 15.247 (b), if transmitting antennas of directional gain greater than 6dBi are used, the power shall be reduced by the amount in dB that the directional gain of the antenna exceeds 6dBi. 4.7.2 ANTENNA CONNECTED CONSTRUCTION The antenna type used in this product is PIFA antenna with UFL connector. The maximum Gain of this antenna is 1.65dBi. Report No.: RF920624R01B 63 Issued: Dec. 07, 2004 Reference No.: RF920624R01

FCC ID: H8NWLL3050 5 PHOTOGRAPHS OF THE TEST CONFIGURATION CONDUCTED EMISSION TEST Report No.: RF920624R01B 64 Issued: Dec. 07, 2004 Reference No.: RF920624R01


FCC ID: H8NWLL3050 RADIATED EMISSION TEST Report No.: RF920624R01B 66 Issued: Dec. 07, 2004 Reference No.: RF920624R01

PRj931130L05_ 931130L05

FCC ID: H8NWLL3050 6 INFORMATION ON THE TESTING LABORATORIES We, ADT Corp., were founded in 1988 to provide our best service in EMC, Radio, Telecom and Safety consultation. Our laboratories are accredited and approved by the following approval agencies according to ISO/IEC 17025: USA FCC, NVLAP, UL, A2LA Germany TUV Rheinland Japan VCCI Norway NEMKO Canada INDUSTRY CANADA , CSA R.O.C. CNLA, BSMI, DGT Netherlands Telefication Singapore PSB , GOST-ASIA(MOU) Russia CERTIS(MOU) Copies of accreditation certificates of our laboratories obtained from approval agencies can be downloaded from our web site: www.adt.com.tw/index.5/phtml. If you have any comments, please feel free to contact us at the following: Linko EMC/RF Lab: Hsin Chu EMC/RF Lab: Tel: 886-2-26052180 Tel: 886-3-5935343 Fax: 886-2-26052943 Fax: 886-3-5935342 Hwa Ya EMC/RF/Safety/Telecom Lab: Linko RF Lab. Tel: 886-3-3183232 Tel: 886-3-3270910 Fax: 886-3-3185050 Fax: 886-3-3270892 Email: service@adt.com.tw Web Site: www.adt.com.tw The address and road map of all our labs can be found in our web site also. Report No.: RF920624R01B 68 Issued: Dec. 07, 2004 Reference No.: RF920624R01


Document Created: 2004-12-10 17:54:07
Document Modified: 2004-12-10 17:54:07
© 2025 FCC.report
This site is not affiliated with or endorsed by the FCC