02 FCC MA Letter

FCC ID: GT3FC024

Cover Letter(s)

Download: PDF
FCCID_3443888

                                                         SmMK
                                         Request for Modular Transmitter Approval
                                                                                                                       June 14, 2017
         FCC ID :GT3FCO24
         Applicant: SMK Corporation

         This transmitter, model: FC9303M is designed by us.
         It complies with the modular transmitters basic requirements (Item 1 to 8) in FCC Part 15 Subpart C Section
         15.212 as indicated below:

         Modular Approval Checklist:
          Modular approval requirement




                                                                                    X{ H K X Kz

                                                                                                  0 0 0 0 O¥
          (1) Have its own RF shielding.

          (2) Have buffered modulation/data inputs.

          (3) Have its own power supply regulation.

          (4) Comply with the antenna and transmission system requirements
          of § 15.203, 15.204(b) and 15.204(c).
          (5) Tested in a stand—alone configuration.
          Unless the transmitter module will be battery powered, it must
          comply with the AC line conducted requirements found in FCC §
          15.207. AC or DC power lines and data input/output lines
          connected to the module must not contain ferrites, unless they will
          be marketed with the module. The length of these lines shall be the
          length typical of actual use or, if that length is unknown, at least 10
          centimeters to insure that there is no coupling between the case of
          the module and supporting equipment. Any                   accessories,
          peripherals, or support equipment connected to the module during
          testing shall be unmodified and commercially available.
          (6) Equipped with either a permanently affixed label or must be              [X            []
          capable of electronically displaying its FCC ID.
          If the FCC ID is not visible when the module is installed inside
          another device, then the outside ofthe device into which the module
          is installed must also display a label referring to the enclosed
          module.
          (7) Comply with any specific rules or operating requirements that            M             [
          ordinarily apply to a complete transmitter and the manufacturer
          must provide adequate instructions along with the module to
          explain any such requirements.
          (8) Comply with any applicable RF exposure requirements in its               [X]           []
          final configuration: The modular transmitter complies with FCC
          radiation exposure requirement.




         A A/MZM: shi
         Akio Nakanishi
         SMK Corporation




SMK Corporation
5—5 Tugoshi 6 Chome, Shinagawa—Kiug,             Tokyo   142—8     , Japan                                     CREATIVE CONNECTIVITY
Phoné:   +81+3—3785—1111



Document Created: 2017-06-25 15:40:33
Document Modified: 2017-06-25 15:40:33

© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC