MA letter

FCC ID: GT3FC020

Cover Letter(s)

Download: PDF
FCCID_2623189

Telephone number: SMIK CORPO RAT'ON Facsimile number: 81—3— 3785—1111 5—5, Togoshi 6—chome, Shinagawa—ku, Tokyo 142—8511, Japan 81—3—3785—1878 Request for Modular Transmitter Approval May 19, 2015 FCC ID : GT3FCO20 Applicant: SMK Corporation This transmitter, model: FDOO0O1 is designed by us. It complies with the modular transmitters basic requirements (Item 1 to 8) in FCC Part 15 Subpart C Section 15.212 as indicated below: Modular Approval Checklist: Modular approval requirement X{ | KX K Hz 0 0 0 0 O# (1) Have its own RF shielding. (2) Have buffered modulation/data inputs. (3) Have its own power supply regulation. (4) Comply with the antenna and transmission system requirements of § 15.203, 15.204(b) and 15.204(c). (5) Tested in a stand—alone configuration. Unless the transmitter module will be battery powered, it must comply with the AC line conducted requirements found in FCC § 15,207. AC or DC power lines and data input/output lines connected to the module must not contain ferrites, unless they will be marketed with the module. The length of these lines shall be the length typical of actual use or, if that length is unknown, at least 10 centimeters to insure that there is no coupling between the case of the module and supporting equipment. Any accessories, peripherals, or support equipment connected to the module during testing shall be unmodified and commercially available. (6) Equipped with either a permanently affixed label or must be capable of electronically displaying its FCC ID. If the FCC ID is not visible when the module is installed inside another device, then the outside of the device into which the module is installed must also display a label referring to the enclosed module. (7) Comply with any specific rules or operating requirements that ordinarily apply to a complete transmitter and the manufacturer must provide adequate instructions along with the module to explain any such requirements. (8) Comply with any applicable RF exposure requirements in its final configuration: The modular transmitter complies with FCC radiation exposure requirement. /. 6z Mitsuhiko Goto SMK Corporation


Document Created: 2015-05-21 18:02:26
Document Modified: 2015-05-21 18:02:26
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC