Modular Approval Letter

FCC ID: GT3FC003

Cover Letter(s)

Download: PDF
FCCID_784993

                             Company: SMK Corporation
                                  FCC ID: GT3FC003
                        Request for transmitter modular approval

                           Transmitter Module Characteristics

Item                     Requirements                             Does the EUT meet the
                                                                       requirement?
 1     Have its own RF shielding                             Device is equipped with Metal
                                                             shielding to cover RF section.
                                                                 Refer to external photos
 2     Have buffered modulation/data inputs (if such          All inputs to the modules are
       inputs are provided),                                      buffered through logic
                                                                  (MC9S08QG8) inputs.
 3     Have it own power supply regulation                   Internal power regulators are
                                                               in RF Transceiver Chipset.
                                                                 Refer to Block diagram
                                                                          page 2.
 4     Meet the antenna requirements of Section                  Device is equipped with
       15.203                                                      pattern antenna. Any
                                                             connector isn’t used. Refer to
                                                                      external photos
 5     Be tested in a stand-alone configuration, i.e., the    Device was tested outside of
       antenna, AC or DC power and data input/output             the PC for full modular
       lines must be connected to the module but, the            approval. Refer to setup
       module must not be inside another case during                      photos.
       testing
 6     Be labeled with its own FCC ID number, and if         The proposed FCC ID label
       the FCC ID is not visible when the module is          format is to be placed on the
       installed inside another device, then the outside       module. If FCC ID is not
       of the device into which the module is installed       visible when the module is
       must also display a label referring to the              installed into the system,
       enclosed module.                                             “Contains FCC
                                                                ID:GT3FC003” shall be
                                                             placed on the outside of final
                                                             host system. “GT3FC003” is
                                                                 the ID of the module.
 7     The modular transmitter is manufactured so that         Refer to “User’s Guide”
       the user cannot influence the operation of the                   Exhibit.
       transmitter that will operate outside of the scope
       of the regulations.
 8     Address compliance with the Commission's RF           Meet RF exposure compliance
       exposure limits in Sections 1.1310 and 2.1093.        requirement
       In addition, spread spectrum transmitters
       operating under Section 15.247 are required to
       address RF exposure compliance in accordance
       with Section 15.247(b)(4).





Document Created: 2007-04-13 08:34:27
Document Modified: 2007-04-13 08:34:27

© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC