Modular Approval Letter

FCC ID: FBZ-GWT154-1T1R

Cover Letter(s)

Download: PDF
FCCID_1498989

                                                 GTECH
                                                         Architects of Gaming




DATE: 5/17/2011

Re: Modular Transmitter Approval
FCC ID: FBZ—GWTIS4—1TIR
IC: 17064—GWT1S41TIR

To Whom it May Concern:

The following information is being provided per the requirements of 15.212 regarding modular approval of Part
15 devices:

This transceiver is a complete RF module with an integral reference oscillator.

External connections are provided for power and data communication.

The following numbered items correspond to similarly numbered paragraphs in 15.212. Eachitemis a response
to the requirements of that document.

1. The module has integral RF shielding to isolate it from surrounding equipment and the larger environmentin
general.

2. All inputs are processed as data by the on—board microcontroller. The outside user has no direct control of
transmit modulation.

3. There is a 1.8V voltage regulator that powers the radio circuits other than the power amplifier. The
microcontroller monitors the power supply voltage on a continuous basis. Should the supply voltage be found
to be greater than the specified maximum of 3.6 volts, the unit will refuse to transmit. The minimum operating
voltage is declared as 2.7 volts.

4. A 2.4 GHz Dipole 2dBi antenna (ModFLEX by LS Research P/N: 001—0001) for reverse polarity SMA with a
U.FL connector with reverse polarity SMA Bulkhead female connector and 105 mm cable assembly
(ModFLEX P/N: 080—0001) is used with this module. This is in accordance with Part 15.203.

5. The module was tested in a stand—alone configuration and found to be compliant with Part 15 regulations.

6. An FCC ID label is affixed to each unit at the time of manufacture. Information is also clearly presented in
the user guide about labeling requirements for the final assembly.

7. This unit is compliant with Part 15.247. Installation and other requirements are presented in the user guide to
allow the unit to be correctly installed.

8. The unit is compliant with the RF exposure requirements of Parts 15.247 and 2.1091.


Further information may be obtained from @TECH Corporation.

Sincerely,


L hecofone f Crann J
Theodore R. Carr Jr.
Sr. Product Compliance Specialist
GTECH Corporation



Document Created: 2011-07-11 13:33:22
Document Modified: 2011-07-11 13:33:22

© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC