Test Setup Photos

FCC ID: EWQ100TGGRD

Test Setup Photos

Download: PDF
FCCID_1905944

TEL‐5013‐001 – photos ‐ test setup page 1 of 6 Contents Unit orientation during Testing: ................................................................................................................... 2 Comb Generator: .......................................................................................................................................... 2 Double Ridge Waveguide 1 GHz to 9.28 GHz:............................................................................................... 3 Log periodic 200 MHz to 1 GHz:.................................................................................................................... 3 Log periodic 200 MHz to 1 GHz:.................................................................................................................... 4 Biconical 30 MHz to 200 MHz: ...................................................................................................................... 4 Loop 9 KHz to 30 MHz ................................................................................................................................... 5 Loop 9 KHz to 30 MHz ................................................................................................................................... 6 Conducted measurements ............................................................................................................................ 6 gg test setup.docx rev a

TEL‐5013‐001 – photos ‐ test setup page 2 of 6 Unit orientation during Testing: The Gas Gate Disconnect module was tested in the three possible installable positions. Comb Generator: Comb generator was used to check for correct sensitivity of measurement setup gg test setup.docx rev a

TEL‐5013‐001 – photos ‐ test setup page 3 of 6 Double Ridge Waveguide 1 GHz to 9.28 GHz: Double Ridge Waveguide with pre amp, to increase sensitivity, used to measure unintended emissions above 1 GHz. Log periodic 200 MHz to 1 GHz: Log periodic with pre amp, to increase sensitivity, for low level emissions and low power band edge measurements. gg test setup.docx rev a

TEL‐5013‐001 – photos ‐ test setup page 4 of 6 Log periodic 200 MHz to 1 GHz: Log periodic without pre amp, used to measure high power intended emissions and band edge measurements. Biconical 30 MHz to 200 MHz: Biconical with pre amp, for measurement of low power unintended emissions. gg test setup.docx rev a

TEL‐5013‐001 – photos ‐ test setup page 5 of 6 Loop 9 KHz to 30 MHz Loop antenna used for measuring unintended emission below 30 MHz. gg test setup.docx rev a

TEL‐5013‐001 – photos ‐ test setup page 6 of 6 Loop 9 KHz to 30 MHz Loop antenna used for measuring unintended emission below 30 MHz was rotated to maximize emissions reading. Conducted measurements HP 8593E serial number 3543A02032 as used for all measurements, except time interval measurements. gg test setup.docx rev a


Document Created: 2013-02-07 14:06:28
Document Modified: 2013-02-07 14:06:28
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC