Test Setup Photos

FCC ID: EWQ100GDLRS

Test Setup Photos

Download: PDF
FCCID_1926717

page 1 of 6 Contents Comb Generator: .......................................................................................................................................... 2 Double Ridge Waveguide 1 GHz to 9.28 GHz:............................................................................................... 3 Log periodic 200 MHz to 1 GHz:.................................................................................................................... 3 Log periodic 200 MHz to 1 GHz:.................................................................................................................... 4 Biconical 30 MHz to 200 MHz: ...................................................................................................................... 4 Loop 9 KHz to 30 MHz ................................................................................................................................... 5 Loop 9 KHz to 30 MHz ................................................................................................................................... 5 Conducted measurements ............................................................................................................................ 6 100gdlrs photos test setup.docx rev a

page 2 of 6 Comb Generator: Comb generator was used to check for correct sensitivity of measurement setup ` 100gdlrs photos test setup.docx rev a

page 3 of 6 Double Ridge Waveguide 1 GHz to 9.28 GHz: Double Ridge Waveguide with pre amp, to increase sensitivity, used to measure unintended emissions above 1 GHz. Log periodic 200 MHz to 1 GHz: Log periodic with pre amp, to increase sensitivity, for low level emissions and low power band edge measurements. 100gdlrs photos test setup.docx rev a

page 4 of 6 Log periodic 200 MHz to 1 GHz: Log periodic without pre amp, used to measure high power intended emissions and band edge measurements. Biconical 30 MHz to 200 MHz: Biconical with pre amp, for measurement of low power unintended emissions. 100gdlrs photos test setup.docx rev a

page 5 of 6 Loop 9 KHz to 30 MHz Loop antenna used for measuring unintended emission below 30 MHz. Loop 9 KHz to 30 MHz Loop antenna used for measuring unintended emission below 30 MHz was rotated to maximize emissions reading. 100gdlrs photos test setup.docx rev a

page 6 of 6 Conducted measurements HP 8593E serial number 3543A02032 as used for all measurements, except time interval measurements. 100gdlrs photos test setup.docx rev a


Document Created: 2013-03-01 05:43:18
Document Modified: 2013-03-01 05:43:18
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC