Users Manual

FCC ID: EW4-WC40

Users Manual

Download: PDF
FCCID_3848462

Page 1 of 9 WML-C40_User_Manual 15.March, 2018 WML- C40 User Manual The purpose of this manual is to explain correct way how to integrate module WML-C40 to the end product. It includes procedures that shall assist you to avoid unforeseen problems. This manual presents information that shows how module and OEM product, where module integrated, complies with regulations in certain regions. Any modifications, not expressly approved by the manufacturer could void the authority to operate in these regions. Content 1. General 2. Description 3. FCC Regulatory Information 4. Canada, Industrie Canada (IC) 1. General This Bluetooth radio module has to be installed and used in accordance with the technical description/installation instructions provided by the manufacturer. This Bluetooth radio module is intended to be placed on the market in all States, where the Bluetooth™ technology and the used frequency band is released. For detail information concerning type approval of this module (e.g. where this module is already pre-approved) please contact the manufacturer. The system may only be implemented in the configuration that was authorized. Note that any changes or modifications to this equipment not expressly approved by the manufacturer could void the user’s authority to operate this equipment. COMMERCIAL IN CONFIDENCE This material may not in whole or part be copied, stored electronically or communicated to third parties without MITSUMI ELECTRIC CO., LTD’s prior agreement in writing.

Page 2 of 9 M I T WML—C40_User_Manual 15.March, 2018 2.DESCRIPTION. 2.1 HVIN and PMN HVIN : WML—C40 PMN _: WML—C40AH, WML—C40AB, WML—C40AS 2.2 Hardware: Version 1 This document describes the reference design for application as follows. 2.3 FEATURES m Bluetooth Ver2.1 + EDR m Host Interface : UART ® Frequency: 2402—2480MHz (World Wide) m RF Channel band: 1MHz RF Channel number: 79ch m Data Rate: GFSK 1Mbps, x/4—DQPSK 2Mbps, SDPSK 3Mbps m Output Power: 12 dBm{MAX) Sensitivity: —82dBm m Supply Voltage: 3.3V+0.1V m Current Consumption Tx: 120mA(MAX), Rx: 70mA(MAX) m Operating temperature: —40 to +70 degree C m Module size: 13.2mm x 24.8mm x 2.05mm 2.4 APPLICATIONS Notebook PCs, mobile phones, digital cameras, PC peripherals, PDA, Car. 2.5 ARCHITECTONICS WML—C40 has Bluetooth chip, Flash ROM and Crystal inside. UART HCI interface and PCM interface are used for customer‘s application. Following figure shows Software Stack for WML—C40 and customer‘s application as example. COMMERCIAL IN CONFIDENCE This material may not in whole or part be copied, stored electronically or communicated to third parties without MITSUMI ELECTRIC CO., LTD‘s prior agreementin writing.

Page 3 of 9 M I T WML—C40_User_Manual 15.March, 2018 2.6 SOFTWARE LAYERS COMMERCIAL IN CONFIDENCE This material may not in whole or part be copied, stored electronically or communicated to third parties without MITSUMI ELECTRIC CO., LTD‘s prior agreementin writing.

Page 4 of 9 M I T WML—C40_User_Manual 15.March, 2018 2.7 DIMENSIONS cup antenna 04103z 2—00.3 — 13 a) |F & 3 § ; ]_______________ |_| f MaRkING + 3 + <i 2.0-5-%2 12 2—RO.3 43 18.6 s 8 1 No: _EF’I_d NALS No. TERMINA L S 1 GND 16 LART_CTS 2 SPI_MOSI T_| USB_D+ 3 PIQ[6] 18 USB_D— 4 PQLTl 19 |_PIQ (2 1USB_PLLL _UP 5 RESET 0| P0 [3 T uSB_REsUME 6 sSPI_CLK 21 PO[S] 7 PCM_CLK 22 PIQ[4 1 &8 PCM_SYNC 23 SPILCSE 9 F‘CMTI.D. 24 SPI_MISO 10 |_PCM_OUT 25 GND 11_| wDD ~| 26 N.CJRE_ TeES—ANT: 12 _|_GND 27 GND 13 UART _RX _| 28 gho 14 UART_TX 29 GND 15 UART_RTS COMMERCIAL IN CONFIDENCE This material may not in whole or part be copied, stored electronically or communicated to third parties without MITSUMI ELECTRIC CO., LTD‘s prior agreementin writing.

MITSUMI Page 5 of 9 WML—C40_User_Manual 15.March, 2018 2.8 Spec *Transmission/Reception Frequencies : unit [ MHz ] GFSK 1Mbps, t/4—DQPSK 2Mbps, 8DPSK 3Mbps ch Freq. ch Freq. 1 2402 21 2444 2 2406 22 2446 3 2408 23 2448 4 2410 24 2450 5 2412 25 2453 6 2414 26 2454 7 2416 27 2456 8 2418 28 2458 9 2420 29 2460 10 2422 30 2462 11 2424 31 2464 12 2426 32 2466 13 2428 33 2468 14 2430 34 2470 15 2492 35 2472 16 2434 36 2474 17 2436 37 2476 18 2438 38 2478 19 2440 39 2480 20 2442 Transmission power(at each ante!nna connector) : unit [ dBm ] TYP. GFSK 1Mbps, t/4—DQPSK 2Mbps, SDPSK 3Mops ch Freq. 1Mbps 2Mbps 3Mbps ch Freq. 1Mbps 2Mbps 3Mbps 1 2402 9 8 8 21 2444 9 8 8 2 2406 9 8 8 22 2446 9 8 8 3 2408 9 8 8 23 2448 9 8 8 4 2410 9 8 8 24 2450 9 8 8 5 2412 9 8 8 25 2453 9 8 8 6 2414 9 8 8 26 2454 9 8 8 7 2416 9 8 8 27 2456 9 8 8 8 2418 9 8 8 28 2458 9 8 8 9 2420 9 8 8 29 2460 9 8 8 10 2422 9 8 8 30 2462 9 8 8 11 2424 9 8 8 31 2464 9 8 8 12 2426 9 8 8 32 2466 9 8 8 13 2428 9 8 8 33 2468 9 8 8 14 2430 9 8 8 34 2470 9 8 8 15 2492 9 8 8 35 2472 9 8 8 16 2494 9 8 8 36 2474 9 8 8 17 2436 9 8 8 37 2476 9 8 8 18 2438 9 8 8 38 2478 9 8 8 19 2440 9 8 8 39 2480 9 8 8 20 2442 9 8 8 COMMERCIAL IN CONFIDENCE This material may not in whole or part be copied, stored electronically or communicated to third parties without MITSUMI ELECTRIC CO., LTD‘s prior agreementin writing.

Page 6 of 9 M I T WML—C40_User_Manual 15.March, 2018 Receive Sensitivity: unit [ dBm] TYP. GFSK 1Mbps, t/4—DQPSK 2Mbps, SDPSK 3Mops Band g?;a Max Min Unit BER 240>MHz |_ 1_ NMbps 20 72 dbm| 01 % — 2 Mbps 20 70 dBm 0.01__% 2480MHz 3 Mops 20 70 dbm 0.01 % 2.9 Note in terms of designing y rees as 5 == lecate any parts or GND plone / _ Patiems on surfsce or intemal ~~_ F9 layer \ 5 1. Please don‘t place any solid GND and line on below blue line‘s area. (with the exception of SMT land for this module.) Because red line‘s area is the antenna, it should be put on your PCB material. gop m Please don‘t place any GND and line to the upper/lower side of the antenna. If you can, please don‘t place any metal parts around 15mm from antenna.(indicated by green line‘s area) Because 2.4GHz is affected of the water, please have distance between the antenna(red line‘s area) and the human body as possible as 6. On your system, please don‘t use metal for cover of this evaluation board. COMMERCIAL IN CONFIDENCE This material may not in whole or part be copied, stored electronically or communicated to third parties without MITSUMI ELECTRIC CO., LTD‘s prior agreementin writing.

Page 7 of 9 WML—C40_User_Manual 15.March, 2018 2. 10 Recommended Reflow Condition 1) Pre heat : 170 — 190 degree 60 ~ 120sec 2) Peek Temperature : MAX 250 degree : 220 degree 30 ~ 60 sec 3) Reflow number of times : MAX 1 time Recommended Reflow Profile Temperature ((C) 250 220 Time COMMERCIAL IN CONFIDENCE This material may not in whole or part be copied, stored electronically or communicated to third parties without MITSUMI ELECTRIC CO., LTD‘s prior agreement in writing.

Page 8 of 9 WML-C40_User_Manual 15.March, 2018 3. FCC Regulatory Information This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC CAUTION Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines. This equipment has very low levels of RF energy that is deemed to comply without testing of specific absorption rate(SAR). Labelling. MITSUMI module WML-C40 labelled as below. FCC Regulatory information. OEM devise should contain labelling that: Approved in accordance to FCC rules transmitter module marked by FCC-ID:EW4-WC40 label, manufactured by MITSUMI incorporated to OEM product. When its not possible, in user manual should be included such information. This equipment should be installed and operated with minimum distance 10mm between the radiator & your body. COMMERCIAL IN CONFIDENCE This material may not in whole or part be copied, stored electronically or communicated to third parties without MITSUMI ELECTRIC CO., LTD’s prior agreement in writing.

Page 9 of 9 M I T M I WML—C40_User_Manual 15.March, 2018 4.Canada, Industrie Canada (IC) The following information must be indicated on the host device of this module; Model Name : WML—C40 Contains IC: 4250A—WC40 The following statements must be described on the user manual of the host device of this module; This device complies with Industry Canada‘s applicable licence—exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause interference; and (2) This device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d‘Industrie Canada applicables aux appareils radio exempts de licence. L‘exploitation est autorisée aux deux conditions suivantes : 1) ‘appareil ne doit pas produire de brouillage; 2) l‘utilisateur de l‘appareil doit accepter tout brouillage radioélectrique subi, méme si le brouillage est susceptible d‘en compromettre le fonctionnement. This equipment complies with FCC/IC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines and RSS—102 of the IC radio frequency (RF) Exposure rules. This equipment has very low levels of RF energy that is deemed to comply without testing of specific absorption rate (SAR). Cet équipement est conforme aux limites d‘exposition aux rayonnements énoncées pour un environnement non contrdlé et respecte les régles les radioglectriques (RF) de la FCC lignes directrices d‘exposition et d‘exposition aux fréquences radioélectriques (RF) CNR—102 de I‘IC. Cet équipement émet une énergie RF tres faible qui est considérée comme conforme sans évaluation du débit d‘absorption spécifique (DAS). This equipment should be installed and operated with minimum distance 20mm between the radiator & your body. Cet appareil doit étre installé et utilisé avec une distance minimale de 20 mm entre le radiateur et le corps humain. COMMERCIAL IN CONFIDENCE This material may not in whole or part be copied, stored electronically or communicated to third parties without MITSUMI ELECTRIC CO., LTD‘s prior agreementin writing.


Document Created: 2018-05-11 18:46:48
Document Modified: 2018-05-11 18:46:48
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC