Test Report Regulatory

FCC ID: EO9FC200A

Test Report

Download: PDF
FCCID_485545

              Engineering Test Services

      FCC Part 15.231(e) / RSS-119 Sec. 6.1.1(e)
                     transmitter
                 952MHz - 960MHz

                       Device Model: FC200
       Device Description: Magnum 900MHz raptor handheld

        Rule                      Description             Max. Reading Pass/Fail
FCC 15.203              Antenna Requirement                    N/A       Pass
15.207                  Powerline Conducted Emissions      40.74 dBuV    Pass
15.231(e) /             Transmitter Field Strength Limits 73.8 dBuV/m    Pass
RSS-119 Sec. 6.1.1(e)
15.231(c) /             20dB Bandwidth                          3.047 kHz    Pass
RSS-119 Sec. 6.1.1(c)
15.231(e) /             Periodic Operation (with waiver)       1.5 seconds   Pass
RSS-119 Sec. 6.1.1(e)


                                Cognizant Personnel


               Drew Rosenberg                         Regulatory Engineer
                   Name                                      Title

                Mark Kvamme                            Senior Technician
                   Name                                      Title


Test 1: FCC Part 15.203                   What is done to ensure that no antenna
          Antenna Requirements            other than the one furnished by the
                                          responsible part will be used with the
                                          device?


The device has a reverse SMA connector.


Test 2: FCC Part 15.207
       Powerline Conducted Emissions
                                                  Equipment Used      Asset
                                                                     Number
Measure the AC powerline conducted
                                                       LISN           8921
emissions from 150kHz to 30 MHz
                                                 Spectrum Analyzer   2064147
using a 50µH/50Ω line impedance
stabilization network (LISN). Verify              Date     Temp/Humidity   Tested by
that no emissions exceed the following                        ºF / %
limits:                                         08/27/2004    78 / 74        Drew
                     Quasi-                                                Rosenberg
      Frequency       Peak       Average
        (MHz)        (dBuV)      (dBuV)
                              *           *
       0.15-0.5     66 to 56 56 to 46
         0.5-5          56          46
          5-30          60          50
  *
    Decreases with the logarithm of frequency



Place screen captures of the powerline conducted measurements below:

                         Ambient environment – device unpowered


L1 – No transmit:




 L1 – Transmit:


L1 (transmit) – 150kHz-500kHz




      L2 (No transmit)


        L2 (Transmit)




L2 (transmit) – 150kHz-500kHz


Test 3: FCC Part 15.231(e) /
        RSS-210 Sec. 6.1.1(e)                         Equipment Used       Asset
      Transmitter Field Strength Limits                                   Number
                                                  Roberts Dipole Ant.      6294
Measure the field strength of all                   Horn Antenna           6412
transmitter emissions according to the                (>1GHz)
procedure in appendix A. The                      Spectrum Analyzer      2064147
maximum field strength of emissions                   Amplifier         MiniCircuits
may not exceed:                                       (< 2GHz)          D021000-23
  Field Strength of    Field Strength of              Amplifier            JCA
                                                      (>2GHz)               103
    Fundamental       Spurious emissions
       (µV/m)               (µV/m)                    Date  Temp/Humidity  Tested by
        5,000                 500                              ºF / %
                                                 08/20/2004    64 / 57    Mark Kvamme
                                                 08/31/2004    73 / 72        Drew
                                                                           Rosenberg




                        P                                        Corrected
  Frequency            QP Reading Reading             Cable Amp.   level
    (MHz)     Polarity NF* (dBm)      (dB∪V)   ACF    Loss Gain (dB∪V/m)     Limit Margin
     954.5        V     P    -63.3     43.7    28.5    1.6   0.0   73.8      74.0   0.2
     1909         V     P    -87.4     19.6    35.8    2.5  30.1   27.8      54.0 26.2
    2863.5        -    NF    -78.4     28.6    39.3    3.5  41.6   29.8      54.0 24.2
     3818         -    NF    -78.9     28.1    41.8    3.8  43.1   30.6      54.0 23.4
    4772.5        -    NF    -78.8     28.2    43.8    4.7  42.5   34.2      54.0 19.8
*NF=Noise floor, QP=Quasi Peak, P=Peak


Test 4: FCC Part 15.231(c) /
        RSS-210 Sec. 6.1 (c)           Equipment Used      Asset
           20dB Bandwidth                                 Number
                                          Antenna          6294
                                      Spectrum Analyzer   2064147
Measure the 20dB bandwidth. The
20dB bandwidth may not exceed 0.5%     Date    Temp/Humidity    Tested by
of the center frequency.                          ºF / %
                                     8/30/2004    73 / 55    Drew Rosenberg


Test 5: FCC Part 15.231(e) /
                                                Verify that the maximum transmission
        RSS-210 Sec. 6.1(e)
            Periodic Operation
                                                length does not exceed 1.5 seconds.



        Maximum message length has been extended for this product family from 1
second to 1.5 seconds per FCC waivers dated September 23, 2002 and November 5,
1990. The 2002 waiver was specifically for the raptor radio, which is the same radio that
is used in this device. The message length has not changed since the waiver was written.

        The FCC has granted these waivers in order to avoid requiring a 30 second delay
in the middle of each transmission. The FCC has acknowledged that such a requirement
would be burdensome to meter installers as well as increase interference potential.

          Copies of both waivers are provided in appendix B of this document.


            Appendix A – Field Strength Measurement Procedure

     This test measures the field strength of radiated emissions using a spectrum analyzer
and a receiving antenna in accordance with ANSI C63.4-2003. During the test, the EUT
is to be placed on a non-conducting support at 80 cm above the horizontal ground plane
of the OATS. The horizontal distance between the antenna and the DUT is to be exactly
3 meters. Levels below 1 GHz are to be measured with the spectrum analyzer resolution
bandwidth at 120 kHz and levels at or above 1 GHz are to be measured with the spectrum
analyzer resolution bandwidth at 1 MHz.

1) Monitor the frequency range of interest at a fixed antenna height and EUT
azimuth.
2) If appropriate, manipulate the system cables to produce the highest amplitude
signal relative to the limit. Note the amplitude and frequency of the suspect
signal.
3) Rotate the EUT 360° to maximize the suspected highest amplitude signal. If
the signal or another at a different frequency is observed to exceed the
previously noted highest amplitude signal by 1 dB or more, go back to the
azimuth and repeat step b). Otherwise, orient the EUT azimuth to repeat the
highest amplitude observation and proceed.
4) Move the antenna over its fully allowed range of travel to maximize the
suspected highest amplitude signal. If the signal or another at a different
frequency is observed to exceed the previously noted highest amplitude signal by
1 dB or more, return to step b) with the antenna fixed at this height. Otherwise,
move the antenna to the height that repeats the highest amplitude observation
and proceed.
5) Change the polarity of the antenna and repeat step b), step c), and step d).
Compare the resulting suspected highest amplitude signal with that found for the
other polarity. Select and note the higher of the two signals. This signal is termed
the highest observed signal with respect to the limit for this EUT operational
mode.



                       EUT                                     3 M.                                            Mast

                                           Styrofoam
                                             Block
               80 cm                                                    Roberts Dipole,
                                                                        Bi - conical, and
                                                                        Log Periodic antennae
                                                                        below 1 GHz.
                                                                        Double Ridged Guide antenna
                                                                        above 1 GHz.




                        Power
                        Supply


                       Spectrum
                                                                  [1]
                       Analyzer




                                                                               [1] Indicates a change in
                                                       [1]                         connection, not an actual
                        Signal                                                     switch.
                                   10 dB                       40 dB
                       Generator

                                   Coax
                        Power                                Reference Level Set
                        Meter


Appendix B – FCC part 15.231(e) waivers



      original waiver.pdf   2nd waiver.pdf



Document Created: 2004-11-04 15:14:44
Document Modified: 2004-11-04 15:14:44

© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC