User Manual

FCC ID: ELVATRJC

Users Manual

Download: PDF
FCCID_1341568

Model 09XR2PR Transmitter Programming Guide This transmitter is designed for use with your upgrade remote start unit and is programmed by using the remote start's program switch in combination with the transmitter button. This transmitter can be used with any Audiovox unit color coded with an Orange LED in the receiver. To program this transmitter into your remote start upgrade unit: 1) Turn the ignition to the on position. 2) Press and release the programming switch 3 times. 3) Press and hold, for 3 seconds, the button of the transmit- ter you wish to add until the parking light flashes indicating the transmitter has been learned. 4) Repeat step 3 for each transmitter up to a total of 4. Turn the ignition off to exit the program mode. NOTE: Do not allow more than 15 seconds to lapse between steps or the program mode will be automatically exited and you will have to start over. If you notice decreased operating range or if the LED fails to light when activating the unit, the batteries will need replace- ment. 1 128-8859 1 of 4

Battery Replacement After removing the two #0 point phillips screws shown, pry apart case with the edge of a finger nail or a small common screwdriver. Keep hold of the metal key ring loop to prevent its loss as it will separate from the transmitter case. Carefully remove the discharged batteries by sliding them out from under the clip in the direction indicated by the arrow in the diagram. Properly dispose of the exhausted batteries and insert two new CR2032 batteries, taking care to arrange them so that the + is facing up toward the + symbol on the battery clip. Reassemble in the reverse of above. This device complies with FCC Rules Part 15 Operation and is subject to the following two conditions: (1) This device may not cause harmful interference and (2) This device must accept any interference that may be received, including interference that may cause undesired operation. NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user’s authority to operate the equipment. 2 128-8859 2 of 4

ORDER FORM FOR TRANSMITTER 09XR2Pr Attention: T ransmitter Ordering Dep artment Important: To help us expedite your order, please print all of the information legibly and mail this form and your payment according to the instructions below. 1)Name: _____________________________________ 2) Address:_________________________________________ 3) City:________________State:________Zip Code:__________ 4) Telephone Number: ( )_____________________ 5) Total Number Of Transmitters Required:_______ Cost Per Transmitter is: $85.00 Multiply By Number Of Transmitters X 6) Enter Total Amount Enclosed _______ (New York State Residents must include the appropriate sales tax) 7) Method of Payment: Mastercard Visa Check or Money Order (do not send cash) Make Checks Payable To Audiovox Corporation Credit Card Number:___________________________________ Credit Card Expiration Date: ____/___/____ 8) Mail this form along with your payment to: Transmitter Ordering Dep artment Audiovox Corporation 150 Marcus Blvd., Haupp auge N.Y. 11788  Credit card purchasers can order additional or replacement transmitters by phone. Simply dial 1 - 800 - 645 - 4994, and follow the instructions from the operator interface. 3 128-8859 3 of 4

© 2010 Audiovox Electronics Corp., Hauppauge, N.Y. 11788 128-8859 128-8859 4 of 4


Document Created: 2010-09-02 17:43:35
Document Modified: 2010-09-02 17:43:35
© 2025 FCC.report
This site is not affiliated with or endorsed by the FCC