Test report Part 2

FCC ID: EJM-AP310

Test Report

Download: PDF
FCCID_158168

FCC ID: EJM-AP310 4.6 BAND EDGES MEASUREMENT 4.6.1 LIMITS OF BAND EDGES MEASUREMENT Below –20dB of the highest emission level of operating band (in 100KHz Resolution Bandwidth). 4.6.2 TEST INSTRUMENTS Description & Manufacturer Model No. Serial No. Calibrated Until ROHDE & SCHWARZ TEST 848926/005 ESMI Dec 28, 2001 RECEIVER 846839/018 HP ATTENUATOR 8496B 3247A18505 Cal. on use HP PLOTTER 7475A 2641V27755 N/A NOTE: 1. The measurement uncertainty is less than +/- 2.6dB, which is calculated as per the NAMAS document NIS81. 2. The calibration interval of the above test instruments is 12 months and the calibrations are traceable to NML/ROC and NIST/USA. 4.6.3 TEST PROCEDURE The transmitter output was connected to the spectrum analyzer via a low lose cable. Set both RBW and VBW of spectrum analyzer to 100 kHz with suitable frequency span including 100 kHz bandwidth from band edge. The band edges was measured and recorded. Report No.: RF900702R01 42 Issued: July 3, 2001

FCC ID: EJM-AP310 4.6.4 EUT OPERATING CONDITION Same as Item 4.3.5 4.6.5 TEST RESULTS The spectrum plots are attached on the following 2 pages. D2 line indicates the highest level, D1 line indicates the 20dB offset below D2. It shows compliance with the requirement in part 15.247(C). NOTE: The band edge emission plot on the following 2 pages shows 47.39dB delta between carrier maximum power and local maximum emission in restrict band (2484.84GHz). The emission of carrier strength list in the test result of channel 11 at the item 4.2.6 (Page 25) is 94.4dBuV/m, so the maximum field strength in restrict band is 94.9-46.67=48.23 dBuV/m which is under 54 dBuV/m limit. Report No.: RF900702R01 43 Issued: July 3, 2001

OTEdV—WIX ‘CI D LONZOZL0064X ~oN uodey LVLOFF ?ESLBy 100.0 kHZ[EdE] ¥id.Bw 100 kHz Date 11.Jun.‘01 Time 23: 32: 04 Ref.Lv1 Marker -4455 cdBm CF.Stp 2.037 GHz AF.Att 0 d 20.50 dBm 6 GHz Unit [(dBm F1 OFF —17.25 dBa F2 2. 4&350000000 GHz DE‘g.75 dBm »4p—"=—“‘"”MT“‘“""’" 20.00 _T_qm:eoe. dB hy olmmmm ssmrtfns ns mmom onlm neme mrfnerrme m P¥ kg: > i Center _ _ Sweep Lo0g ‘s Ainp :penssq 2. 45 GHz 1000 MHz 2.5 GHz 100 ns o lx\/

OTEdV—WIX ‘CI D LONZOZL0064X ~oN uodey LVLOFF Res.Bw 100.0 kHz[3dB] ¥id . Bw Date 12.Jun.‘04 Time 00: 10: 08 G.Lyl Ref .Lvl Marker —32.82 dBm 2. 037 GHz BF.Att 20.50 dBm 2.3978 GHz Unit Fi 2. 40000000000 6Hz D1 —18.069 dBm F2 OFF D2 1.31 cBm F2—F1 OFF 01—D2 20.00 dB 20.0 10.0 0 JIJd" hi D2 —10.0 j (fl —“\ { —20.0 S¢ —30.0 —40 .0 MhhdhnflhUHfifiWH#NflUHMfl\Qg3gw!Nbfi#ApMW!?flflfléfiihfl*dhnfll“fflaJl‘hkf —50.0 —60 .0 —70.0 FA Start Span Sweep LO0Z ‘g 4inp :penssq 2.33 GHz 100 MHz 2.38 GHz 100 ms uoo 10v C[G [

FCC ID: EJM-AP310 4.7 ANTENNA REQUIREMENT 4.7.1 STANDARD APPLICABLE For intentional device, according to FCC 47 CFR Section 15.203, an intentional radiator shall be designed to ensure that no antenna other than that furnished by the responsible party shall be used with the device. And according to FCC 47 CFR Section 15.247 (b), if transmitting antennas of directional gain greater than 6dBi are used, the power shall be reduced by the amount in dB that the directional gain of the antenna exceeds 6dBi. 4.7.2 ANTENNA CONNECTED CONSTRUCTION The antenna used in this product is monopole antenna. The antenna connector type is MCX. And the maximum Gain of this antenna is only 1dBi. Report No.: RF900702R01 46 Issued: July 3, 2001

FCC ID: EJM-AP310 5 PHOTOGRAPHS OF THE TEST CONFIGURATION CONDUCTED EMISSION TEST Report No.: RF900702R01 47 Issued: July 3, 2001

FCC ID: EJM-AP310 RADIATED EMISSION TEST Report No.: RF900702R01 48 Issued: July 3, 2001

FCC ID: EJM-AP310 6 INFORMATION ON THE TESTING LABORATORIES We, ADT Corp., were founded in 1988 to provide our best service in EMC and Safety consultation. Our laboratories are accredited and approved by the following approval agencies according to ISO/IEC 17025, Guide 25 or EN 45001: USA FCC, NVLAP Germany TUV Rheinland Japan VCCI New Zealand MoC Norway NEMKO R.O.C. BSMI, DGT, CNLA Copies of accreditation certificates of our laboratories obtained from approval agencies can be downloaded from our web site: www.adt.com.tw/index.5/phtml. If you have any comments, please feel free to contact us at the following: Lin Kou EMC Lab: Hsin Chu EMC Lab: Tel: 886-2-26052180 Tel: 886-35-935343 Fax: 886-2-26052943 Fax: 886-35-935342 Lin Kou Safety Lab: Lin Kou RF&Telecom Lab Tel: 886-2-26093195 Tel: 886-3-3270910 Fax: 886-2-26093184 Fax: 886-3-3270892 Email: service@mail.adt.com.tw Web Site: www.adt.com.tw The address and road map of all our labs can be found in our web site also. Report No.: RF900702R01 49 Issued: July 3, 2001


Document Created: 2001-07-04 17:42:06
Document Modified: 2001-07-04 17:42:06
© 2025 FCC.report
This site is not affiliated with or endorsed by the FCC