Modular Approval Letter rev

FCC ID: E2K-DWRFID1803

Cover Letter(s)

Download: PDF
FCCID_4196955

Dell Inc.
One Dell Way, Round Rock
Texas 78682 United States

Confidentiality Modular Approval Request FCC (KDB 996369 D01 & Part 15.212)

FCC ID: E2K-DWRFID1803

 Items to be covered by Limited single modular transmitters.                                     Answer from applicant
 1. The modular transmitter must have its own RF shielding.                                      No.

 2.   The modular transmitter must have buffered modulation/data inputs (if such inputs are      Yes.
      provided) to ensure that the module will comply with Part 15 requirements under
      conditions of excessive data rates or over-modulation.
 3.   The modular transmitter must have its own power supply regulation.                         Yes.

 4.   The modular transmitter must comply with the antenna requirements of Section 15.203        Yes.
      and 15.204(b)(c). The antenna must either be permanently attached or employ a
      “unique” antenna coupler (at all connections between the module and the antenna,
      including the cable).

 5.   The modular transmitter must be tested in a stand-alone configuration, i.e., the module    The module is tested inside
      must not be inside another device during testing. This is intended to demonstrate that     of a host device,
      the module is capable of complying with Part 15 emission limits regardless of the          Convertible PC. (Brand:
      device into which it is eventually installed.                                              DELL, Model: P110G)

 6.   The modular transmitter must be equipped with either a permanently affixed label or        Yes.
      must be capable of electronically displaying its FCC identification number in
      accordance with 15.212 (a)(1)(vi)(A) / (B).

 7.   The modular transmitter must comply with any specific rule or operating requirements       Yes.
      applicable to the transmitter and the manufacturer must provide adequate instructions
      along with the module to explain any such requirements. A copy of these instructions
      must be included in the application for equipment authorization. For example, there are
      very strict operational and timing requirements that must be met before a transmitter is
      authorized for operation under Section 15.231. For instance, data transmission is
      prohibited, except for operation under Section 15.231(e), in which case there are
      separate field strength level and timing requirements. Compliance with these
      requirements must be assured.

 8.   The modular transmitter must comply with any applicable RF exposure                        Yes.
      requirements. For example, FCC Rules in Sections 1.1310, 2.1091, 2.1093, and
      specific Sections of Part 15, including 15.319(i), 15.407(f), 15.253(f) and 15.255(g),
      require that Unlicensed PCS, UNII and millimeter wave devices perform routine
      environmental evaluation for RF Exposure to demonstrate compliance. In addition,
      spread spectrum transmitters operating under Section 15.247 are required to address
      RF Exposure compliance. Modular transmitters approved under other Sections of
      Part 15, when necessary, may also need to address certain RF Exposure concerns,
      typically by providing specific installation and operating instructions for users,
      installers and other interested parties to ensure compliance.

Note: A limited modular approval (LMA) may be granted for single or split modular transmitters that comply partially
with the requirements above.




______________________________
William Wei / Regulatory Compliance Engineer
Dell Inc.
Tel: +886 2 23766556
E-mail: William.Wei@Dell.com



Document Created: 2018-11-30 19:56:49
Document Modified: 2018-11-30 19:56:49

© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC