Modular Approval Letter

FCC ID: D6XWL5011S

Cover Letter(s)

Download: PDF
FCCID_598676

TECOM CO., LTD. FCC ID: D6XWL5011S Request for Transmitter Modular Approval Transmitter Module Characteristics per FCC public notice DA 00-1407 requirements Item Requirements EUT 1 Have its own RF Shielding Device is equipped with Metal shielding to cover RF section. Refer to external photos 2 Have buffered modulation/data inputs (if such inputs are All inputs to the modules are buffered provided) through logic or microprocessor inputs 3 Have it own power supply regulation Internal 1.8V power regulator. Refer to Schematic and Block diagrams. 4 Meet the antenna requirements of Section 15.203 Device is equipped with unique antenna connector. Refer to external photos 5 Be tested in a stand-alone configuration, i.e., the antenna, Device was tested outside the host AC or DC power and data input/output lines must be computer as stand-alone connected to the module but, the module must not be configuration. Refer to setup photos inside another case during testing 6 Be labeled with its own FCC ID number, and if the FCC The module will be labeled with its ID is not visible when the module is installed inside own FCC ID number, and when another device, then the outside of the device into which installed inside another device, the the module is installed must also display a label referring outside of the device will also display to the enclosed module a label referring to the enclosed module. 7 The modular transmitter must comply with any specific rule or operating requirements applicable to the transmitter The radio operates as an IEEE and the manufacturer must provide adequate instructions 802.11b/g compliant device. The along with the module to explain any such requirements. A operation protocol and timing meet copy of these instructions must be included in the operation requirements defined application for equipment authorization. For example, within FCC 15.247. there are very strict operational and timing requirements that must be met before a transmitter is authorized for operation under Section 15.231. For instance, data transmission is prohibited, except for operation under Section 15.231(e), in which case there are separate field strength level and timing requirements. Compliance with these requirements must be assured.

8 Address compliance with the Commission’s RF exposure The modular transmitter complies limits in Sections 1.1310 and 2.1093. with any applicable RF exposure In addition, spread spectrum transmitters operating under requirement specified in the FCC Section 15.247 are required to address RF exposure Rules 15.247(b)(4). Please refer to the compliance in accordance with Section 15.247(4) RF exposure evaluation.


Document Created: 2019-10-13 00:47:04
Document Modified: 2019-10-13 00:47:04
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC