Users Manual - Flood

FCC ID: CFS8DL6SHK

Users Manual

Download: PDF
FCCID_3764595

ETL DRAFT SiXFLOOD Quick Installation Guide / Guide d'installation rapide Guía Rápida de Instalación / Guia rápido de instalação The SiXFLOOD is a wireless flood sensor Ceci est une détecteur de porte / fenêtre sans fil à Este es un sensor de puerta / ventana Este é um sensor de porta / janela sem fio with external probe (FP280) intended for deux zones avec couvercle et mural interrupteurs inalámbrico de dos zonas con tamper de de duas zonas com tampa e tamper de use with Honeywell controls that support anti-sabotage. Il est conçu pour être utilisé avec cubierta y pared. Diseñado para usarse con parede. Deve ser usado com painéis de SiX™ series devices. The sensor sends an les panneaux de commande Honeywell qui los controles Honeywell compatibles con los alarme Honeywell compatíveis com alarm or trouble signal (depending on zone type selected; ex. Monitor Zone or 24hr supportent les dispositifs de la série SIXMC. dispositivos de la serie SiX™. dispositivos da série SiX™.. Aux) when the probe contacts water. The sensor also features a cover tamper switch. A Terminal Block A Bloque de terminales B Tamper B Manipulación C LED C LED A Bornier A Bloco terminal B Antisabotage B Tamper C DEL C LED After enrolling, verify adequate signal strength by conducting For Lyric™ Controller / Pour le contrôleur LyricMC / Una vez registrado, verifique la intensidad de señal adecuada Go/No Go tests (see the controller’s instructions) with the realizando pruebas Go / No Go (ver las instrucciones del controlador) Para el Controlador Lyric™ / Para o Controlador Lyric™ device in its intended mounting location. Adjust the device con el dispositivo en la ubicación deseada. Ajuste la ubicación y location and orientation as necessary. orientación del dispositivo según sea necesario. Signal Strength: Range of 1-4 bars (green); Should be Intensidad de la señal: Rango de 1-4 barras (verde); Debe ser minimum 1 green bar for the zone being programmed. mínimo 1 barra verde para la zona que se está programando. Once enrolled, the device cannot be used with another system Una vez registrado, el dispositivo no se puede usar con otro sistema hasta until it is removed from the current controller. See the que sea removido del controlador actual. Ver las instrucciones del controller’s instructions. controlador. NOTE: After mounting you can use the Sensor Location feature NOTA : Después de montar el sensor, puede utilizar la pantalla de to confirm device location. In programming mode, select a zone localización de sensores para confirmar la ubicación del dispositivo. and the respective sensor LED lights. En el modo de programación, seleccione una zona y el respectivo LED de sensor se encenderá. Après l'enrôlement, vérifiez la puissance du signal adéquate en effectuant des tests Go / No Go (voir les instructions du Após o registro, verifique a intensidade do sinal adequado ao realizar panneau de commande) avec le dispositif dans son testes Go / No Go (consulte as instruções do controlador) com o emplacement de montage prévu. Au besoin, modifiez dispositivo na localização de montagem pretendida. Ajuste, se l'emplacement ou l'orientation du dispositif. necessário, o posicionamento e a orientação do dispositivo. Force du signal: devrait avoir au minimum 1 barre verte pour Força do Sinal: intervalo de 1-4 barras (verde); deve ter, no mínimo, la zone programmée. uma barra verde para a zona em programação. Une fois enrôlé, le dispositif ne peut pas être utilisé avec un Uma vez registrado, o dispositivo não pode ser usado com outro sistema autre système avant d'avoir été supprimé du panneau actuel. até que seja removido do controlador atual. Consulte as instruções do Reportez-vous aux instructions du panneau. controlador. NOTE : Après le montage, vous pouvez utiliser la fonction NOTA: Após a montagem, você pode usar o recurso Sensor Location d'emplacement du détecteur pour confirmer l'emplacement du para confirmar a localização do dispositivo. No modo de programação, détecteur. En mode programmation, sélectionnez une zone et selecione uma zona e a luz LED do respectivo sensor acenderá. le voyant du capteur respectif s'allume. Enroll / Enrôlement / Enrolar / Registrar MC For Lyric™ Gateway Pour la Gateway Lyric Para Lyric™ Gateway Para o Gateway Lyric™ Enroll and program using AlarmNet 360™. Enrôlez et programmez le système au moyen Registro y programación usando AlarmNet 360™ Faça o registro e programe usando o MC d’AlarmNet 360

AlarmNet 360™. BATTERY CAUTION: Risk of fire, explosion and burns. Attention de batterie: Risque d'incendie, d'explosion et de Precauciones con respecto a las baterías: Riesgo de FUEGO, Precauções com a bateria: Risco de incêndio, explosão e Do not recharge, disassemble, heat above 212°F brûlures. Ne rechargez pas, démonter, chauffer au-dessus de explosión y quemaduras. No recargar, desarmar, calentar por queimaduras. Não recarregar, não desmontar, não aquecer mais de (100°C) or incinerate. Dispose of used batteries properly. 212°F (100°C), ou incinérer. Débarrassez-vous des batteries encima de 100°C (212°F), o incinerar. Descarte Apropiadamente las 100°C (212ºF) nem incinerar. Descarte as baterias usadas Keep away from children. utilisées de façon appropriée. Gardez à partir des enfants. baterías usadas. Manténgalas fuera del alcance de los niños. apropriadamente. Mantenha fora do alcance de crianças. NOTE: Constant exposure to high or low temperature NOTE : Une exposition constante à des températures élevées NOTA: Exposición constante a altas o bajas temperaturas o alta NOTA: A exposição constante a temperatura alta ou baixa ou alta or high humidity may reduce battery life. ou basses ou à un taux d'humidité élevée peut réduire la durée humedad puede reducir la vida útil de la batería. umidade podem reduzir a vida útil da batería de vie de la pile. FEDERAL COMMUNICATIONS COMMISSION & INDUSTRY CANADA STATEMENTS The user shall not make any changes or modifications to the equipment unless authorized by the Installation Instructions or User's Manual. Unauthorized changes or modifications could void the user's authority to operate the equipment. CLASS B DIGITAL DEVICE STATEMENT This equipment has been tested to FCC requirements and has been found acceptable for use. The FCC requires the following statement for your information: This equipment generates and uses radio frequency energy and if not installed and used properly, that is, in strict accordance with the manufacturer's instructions, may cause interference to radio and television reception. It has been type tested and found to comply with the limits for a Class B computing device in accordance with the specifications in Part 15 of FCC Rules, which are designed to provide reasonable protection against such interference in a residential installation. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • If using an indoor antenna, have a quality outdoor antenna installed. • Reorient the receiving antenna until interference is reduced or eliminated. • Move the radio or television receiver away from the receiver/control. • Move the antenna leads away from any wire runs to the receiver/control. • Plug the receiver/control into a different outlet so that it and the radio or television receiver are on different branch circuits. • Consult the dealer or an experienced radio/TV technician for help. INDUSTRY CANADA CLASS B STATEMENT This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada. FCC / IC STATEMENT This device complies with Part 15 of the FCC Rules, and Industry Canada’s license-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Cet appareil est conforme à la partie 15 des règles de la FCC et exempt de licence RSS d’Industrie Canada. Son fonctionnement est soumis aux conditions suivantes: (1) Cet appareil ne doit pas causer d’interférences nuisibles. (2) Cet appareil doit accepter toute interférence reçue y compris les interférences causant une réception indésirable. RF EXPOSURE Warning – The antenna(s) used for this transmitter must be installed to provide a separation distance of at least 7.8 in (20 cm) from all persons and must not be co-located or operated in conjunction with any other transmitter except in accordance with FCC and ISED multi-transmitter product procedures. Mise en Garde Exposition aux Fréquences Radio: La/les antenne(s) utilisée(s) pour cet émetteur doit/doivent être installée(s) à une distance de séparation d'au moins 20 cm (7,8 pouces) de toute personne et ne pas être située(s) ni fonctionner parallèlement à tout autre transmetteur ou antenne, excepté en conformité avec les procédures de produit multi transmetteur FCC et ISED. DECLARACIÓN IFETEL DECLARAÇÃO ANATEL La operación de este equipo está sujeta a las siguientes dos condiciones Este equipamento não tem direito à proteção contra interferência prejudicial e não 1. Es posible que este equipo o dispositivo no cause interferencia perjudicial y pode causar interferência em sistemas devidamente autorizados. Para maiores 2. Este equipo debe aceptar cualquier interferencia, incluyendo la que pueda causar su informações, consulte o site da ANATEL www.anatel.gov.br. operación no deseada. Support / Soutien / Soporte / Suporte Approval Listings / https://mywebtech.honeywell.com/ Approbations Homologations / Listas de aprobaciones / U.S. warranty / U.S. garantie / U.S. garantie / U.S. garantia Listagens de aprovação: www.honeywell.com/security/hsc/resources/wa FCC / IC Patents / Brevets / Patentes / Patentes ETL Listed to UL 634 Replace Battery / Remplacement des piles / www.honeywell.com/patents MyWebTech Warranty Patents cETL Listed to ULC/ORD-C634 Other Standards: Cambiar batería / Substituir bateria RoHS REFER TO THE POUR LES LIMITES CONSULTE LAS PARA SABER MAIS SOBRE Specifications / Spécifications / Especificaciones / Especificações: INSTALLATION DU SYSTÈME INSTRUCCIONES DE AS LIMITAÇÕES DE TODO O Battery / Pile / Batería / Bateria: 1 x 3V, Lithium; Honeywell 466, Panasonic CR123A, Duracell DL123A, INSTRUCTIONS FOR THE D’ALARME AU INSTALACIÓN PARA EL SISTEMA DE ALARME, Huiderui CR123A CONTROL WITH WHICH COMPLET, CONTROLADOR CON EL CONSULTE AS INSTRUÇÕES Tamper / Interrupteurs antisabotage / Manipulación / Tamper: Cover / Couvercle / Tapa / Tampa THIS DEVICE IS USED, REPORTEZ-VOUS AU CUAL SE UTILIZA ESTE DE INSTALAÇÃO DO RF Frequency / Fréquence RF / Frecuencia de RF / Frequência RF: 2.4GHz FOR DETAILS GUIDE DISPOSITIVO, PARA CONTROLE COM O QUAL REGARDING D’INSTALLATION DU OBTENER DETALLES CON ESTE DISPOSITIVO É USADO. Operating Temperature / Température de fonctionnement / Temperatura de funcionamiento / Temperatura LIMITATIONS OF THE PANNEAU DE RESPECTO A LAS de operação: 32° – 122°F / 0° – 50°C (Agency Compliance 32° – 120°F / 0° – 49°C) O produto deve ser ENTIRE ALARM SYSTEM. COMMANDE. LIMITACIONES DE TODO EL Relative Humidity / Humidité relative / Humedad relativa / Umidade relativa: 95% max. (Agency Compliance - SISTEMA DE ALARMA. testado pelo menos uma 93% max.), non-condensing / sans condensation / sin-condensación / sem condensação Product must be Le fonctionnement du produit doit être El producto debe ser vez por ano Dimensions / Dimensions / Dimensiones / Dimensões: 1” H x 3.13” L x 1.61” W / 25.5 mm H x 79.5 mm L x 41 tested at least once mm W each year vérifié au moins une probado al menos una fois par année vez al año  2017 Honeywell International Inc. Honeywell is a registered trademark of Honeywell International Inc. All other trademarks are the properties of their respective owners. All rights reserved 2 Corporate Center Drive, Suite 100 P.O. Box 9040, Melville, NY 11747 Ê800-15959)Š www.honeywell.com/security SiXFLOOD 800-23852 11/17 Rev 99


Document Created: 2017-11-16 14:16:19
Document Modified: 2017-11-16 14:16:19
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC