User Manual

FCC ID: BY35242-24RR

Users Manual

Download: PDF
FCCID_3865344

OPERATING INSTRUCTIONS FRONT WHEELS STEERING ADJUSTMENT 1. If the vehicle does not run straight forwards, adjust the lever for satisfactory alignment on the underside of the vehicle. (See Diagram 5) 1 KEEP PACKAGING AS IT CONTAINS IMPORTANT INFORMATION. 2. If the vehicle runs towards left, turn "Steering Alignment Lever" towards "R" BATTERY INSTALLATION 3. If the vehicle runs towards right, turn "Steering Alignment Lever" towards "L" BATTERY REQUIREMENT: Vehicle: Built-in Rechargeable Battery Keep packaging as it contains important information. Transmitter: 2 x AA batteries (included) *ALKALINE AA BATTERIES IS RECOMMENDED CAUTION: To prevent battery leakage: Be sure to insert batteries correctly and always follow the product and battery ATTENTION PARENTS manufacturers' instructions. It is recommended that this toy and all accessories be periodically examined for Never mix old and new batteries (replace all batteries at the same time). potential hazards and that any potentially hazardous parts be repaired or replaced. Never mix Alkaline, standard (Carbon Zinc) or rechargeable (Nickel-Metal Hydride) batteries. VEHICLE Only batteries of the same or equivalent type as recommended are to be used. The vehicle is powered by a built-in non-replaceable rechargeable battery. The Do not use RECHARGEABLE batteries, unless specified. included rechargeable battery is not charged prior to shipment and must be charged Non-rechargeable batteries are not to be recharged. before the first use. Rechargeable batteries are to be removed from the product before being charged. Rechargeable battery is only to be charged by adults or by children at least 8 years old. Charging The Vehicle Always remove exhausted or dead batteries from the product. 1. Make sure the vehicle’s ON/OFF switch is in the OFF position. (See Diagram 1.) Remove batteries from product before extended storage. 2. Plug the charging cable jack to the charging socket at the underside of the vehicle. The supply terminals are not to be short-circuited. (See Diagram 1.) Batteries are to be inserted with correct polarity. 3. Plug the charging cable USB socket to an USB certified port, i.e., desktop Batteries may explode or leak if misused. computer / laptop computer / smartphone charger / tablet charger / car changer ATTENTION: Battery / Batteries should be installed by an adult only. 4. Turn the vehicle's ON/OFF switch to "CHARGE" position. 2 3 ATTENTION: User should remove the battery from the item before disposal. 5. During recharging, the LED light on chassis will flash to show vehicle is charging. 6. Once the wheels lights turned OFF, the vehicle is fully charged. Unplug the USB This appliance is not intended for use by persons (including children) with reduced charging cable (See Diagram 1.) 2 x AA physical, sensory or mental capabilities, or lack of experience and knowledge, unless batteries they have been given supervision or instruction concerning use of the appliance by a TRANSMITTER LED person responsible for their safety. 1. Unscrew to open the battery lid. Insert a new 2 x AA batteries. (See Diagram 2) 2. Replace the battery cover. • The WEEE symbol if present indicates that this item contains electrical or electronic Note: Remove battery after you have finished using your vehicle. components which must be collected and disposed of separately. • Never dispose of electrical or electronic waste in general municipal waste. Collect Caution : Built-In Battery Safety Information and dispose of such waste separately. 1. The vehicle includes a non-replaceable battery. Do not open, disassemble or alter • Make use of the return and collection systems available to you, or your local the vehicle in anyway. recycling programme. Contact your local authority or place of purchase to find out 2. Adult supervision is required when charging the vehicle. what schemes are available. Battery cover Unscrew to open 3. Charge battery in isolated area. Keep away from flammable materials. • Electrical and electronic equipment contains hazardous substances which, when 4. Do not expose to direct sunlight. disposed of incorrectly, may leak into the ground. This can contribute to soil and water 5. Do not recharge the toy if it is hot. Allow it to cool before recharge. pollution which is hazardous to human health, and endanger wildlife. 6. Do not allow the batteries to get wet. • It is essential that consumers look to re-use or recycle electrical or electronic waste 7. Carefully read the instruction guide and use the batteries correctly. to avoid it going to landfill sites or incineration without treatment. 8. Rechargeable batteries are only to be charged under adult supervision. 9. Routine examination for damage to the plug, enclosure and other parts. In the event of any damage, the toy must not be used with USB port until the damage FCC Information has been repaired. This equipment has been tested and found to comply with the limits for a Class B 10. This toy is not intended for children under 3 years old. digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to 4 Left/Right provide reasonable protection against harmful interference in a residential installation. CARE This equipment generates, uses, and can radiate radio frequency energy and, if not Never drive the vehicle on a wet floor, on sand, grass, carpet, in mud, rain or snow. installed and used in accordance with the instructions, may cause harmful interference These can cause damage to the vehicle. Do not expose the vehicle to extreme to radio communications. However, there is no guarantee that interference will not temperatures. To protect the vehicle’s wheel mechanisms from lint and hair, do not occur in a particular installation. If this equipment does cause harmful interference to drive it on carpet. Occasionally wipe the vehicle with a damp cloth to remove any radio or television reception, which can be determined by turning the equipment off dirt/dust from wheels. Do not use harsh chemicals to clean the vehicle. Modifying or and on, the user is encouraged to try to correct the interference by one or more of Transmitter Vehicle tampering with the vehicle or the transmitter’s internal components can cause a the following measures: malfunction. • Reorient or relocate the receiving antenna. HELPFUL HINTS • Increase the separation between the equipment and receiver. Running the vehicle continuously for long periods of time generates high levels of • Connect the equipment into an outlet on a circuit different from that to which the Forwards/Backwards heat. Heat causes wear and tear on the motor. When the vehicle’s battery pack goes receiver is connected. flat, let the vehicle cool at least 10 minutes before installing a newly charged battery • Consult the dealer or an experienced radio/TV technician for help. pack. This helps keep heat levels down. If the vehicle’s motor runs but does not respond to the transmitter, move the transmitter closer to the vehicle and try again. If you cannot eliminate the interference, the FCC requires that you stop using your If a CB radio is used nearby, it might interfere with the control of the vehicle. If this equipment. Changes or modifications not expressly approved by the party responsible happens, move the vehicle and transmitter away from the CB radio. The vehicle for compliance could void the user’s authority to operate the equipment. This device cannot be operated near devices with transmitters that use the same frequency. complies with Part 15 of the FCC Rules. Operation is subject to the following two Check the packaging to see which frequency your vehicle uses. If the vehicle moves conditions: (1) this device may not cause harmful interference, and (2) this device slowly, and a recharged battery pack has been installed, check the wheel mechanisms must accept any interference received, including interference that may cause for lint, thread, hair or dust. undesired operation. 5 HOW TO PLAY START TO PLAY PAIRING TRANSMITTER WITH VEHICLE 1. Turn ON the vehicle (See Diagram 3). 2. Install 2 x AA battery in the transmitter, the pairing LED light on the transmitter ENGLISH will flash (See Diagram 2). 3. If pairing success, the pairing LED light will turn OFF Steering 4. You must pairing the transmitter with the vehicle within 45 seconds, after alignment 45 seconds you must push the control on the transmitter to pair again. lever 5. You must repeat pairing again when the transmitter needs to replace new batteries. OPERATION 1. Operate the vehicle with the transmitter (See Diagram 4). © 2018 SCIENTIFIC TOYS LTD. 1108, TOWER B, 2. Turn OFF the vehicle and the transmitter after playing and remove all batteries 14 SCIENCE MUSEUM ROAD, TSIMSHATSUI, HONG KONG. from the transmitter. PRINTED IN CHINA O.I. NO.6310 SIZE:210MM X 297MM PN#65-6310-000-0100


Document Created: 2018-04-18 16:22:12
Document Modified: 2018-04-18 16:22:12
© 2025 FCC.report
This site is not affiliated with or endorsed by the FCC