User Manual

FCC ID: BY35148-24GR

Users Manual

Download: PDF
FCCID_3013912

OPERATING INSTRUCTIONS: HOW TO PLAY PERFORMANCE TIPS: This device complies with Part 15 of the FCC Rules. O.1. NO. 5957 AD11444 PAIRING TRANSMITTER WITH VEHICLE — Don‘t go through water. Operation is subject to the following two conditions: ATTENTION PARENTS: ToYsfuUS® 1. Turn ON the vehicle (See Diagram 5). — Use fresh alkaline batteries. (1) this device may not cause harmful interference, and IT IS RECOMMENDED THAT THIS TOY AND ALL 2. Install 2 x AA battery in the transmitter, the pairing — Be sure to rest your vehicle for at least 30 minutes (2) this device must accept any interference received, ACCESSORIES BE PERIODICALLY EXAMINED FOR after every 15 minutes of operation. including interference that may cause undesired operation. LED light on the transmitter will flash POTENTIAL HAZARDS AND THAT ANY POTENTIALLY — Make sure ON/OFF switch on your vehicle is OFF Waming: Changes or modifications to this unit not expressly (See Diagram 3 & 4). when not in use. approved by the party responsible for compliance could void HAZARDOUS PARTS BE REPAIRED OR REPLACED. E+ CONFORMS TO THE SAFETY 3. If pairing success, the pairing LED light will turn — Don‘t bend antenna. the user‘s authority to operate the equipment. OFF. NOTE: This equipment has been tested and found to comply REQUIREMENTS OF ASTM F963. — Electrical, CB interference, mobile phones, air C__ BATTERY LOADING: 4. You must pairing the transmitter with the vehicle conditioning, elevators and steel girders in building with the limits for a Class B digital device, pursuant to (FOR MAXIMUM PERFORMANCE, USE ALKALINE within 45 seconds, after 45 seconds you must push will affect the operation of your vehicle. Part 15 of the FCC Rules. These limits are designed to g’ 3 Contents and colors may vary. BATTERIES) — Don‘t leave the vehicle or transmitter near sources provide reasonable protection against harmful interference the control on the transmitter to pair again. Batteries are demonstration purposes only. Remember to take out all batteries from the vehicle of heat or under direct sunlight for long periods of in a residential installation. This equipment generates, uses 5. You must repeat pairing again when the transmitter NOTINCLUDED ney should be replaced upon purchase for time. and can radiate radio frequency energy and, if not installed and transmitter after playing. needs to replace new batteries. optimal performance. — Remove the batteries from the vehicle and and used in accordance with the instructions, may cause 1. Do not mix old and new batteries. harmful interference to radio communications. transmitter when not in use. I Do not mix old and new batteries. 2. Do not mix alkaline, standard (Carbon—Zinc), or Notes: However, there is no guarantee that interference will not occur Do not mix alkaling, standard (carbon—zinc), rechargeable (nickel metal hydride) batteries. 1. If pairing failed, reinstall the battery of transmitter, in a particular installation. If this equipment does cause harmful or rechargeable batteries. move closer and then try again. interference to radio or television reception, which can be i(€4lzl HOW TO INSTALL BATTERIES IN VEHICLE determined by tuming the equipment off and on, the user is 2. If more then one vehicle are pairing at the same encouraged to try to correct the interference by one or more 1. Turn over the vehicle and push the ON/OFF to time, pair each vehicle one by one. of the following measures: FAST LANE IS A MARK OF (EST UNE MARQUE DE/ "OFF" position. (See Diagram 1) * Reorient or relocate the receiving antenna. ES UNA MARCA DE) GEOFFREY, LLC, A SUBSIDIARY OF 2. Open the battery cover. (See Diagram 1) Vehicle has memory to store the paired data, no Increase the separation between the equipment (UNE FILIALE DE/UNA SUBSIDIARIA DE) TOYS"R"US, INC. 3. Insert 3 x "AAA" alkaline batteries by matching the need to pair each time play until replace the battery and receiver. © 2016 GEOFFREY, LLC _ l\:/IADE IN CHINA (FABRIQUEE EN CHINE/FABRICADO EN FLX AHACEAR (+) and (—) signs as indicated in the battery compartment (See Diagram 2) in transmitter «+ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. HINA) J 4. Replace the battery cover. +« Consult the dealer or an experienced radio/TV technician DISTRIBUTED IN THE UNITED STATES BY (DISTRIBUEE NOTE: USE ONLY ALKALINE AAA BATTERIES for help. AUX ETATS—UNIS PAR/DISTRIBUIDO EN LOS ESTADOS OPERATION UNIDOS POR) 1. Operate the vehicle with the transmitter TOYS"R"US, INC., WAYNE, NJ 07470 HOW TO INSTALL BATTERY IN TRANSMITTER (See Diagram 6). IMPORTANT IMPORTED BY (IMPORTE PAR/IMPORTADO EM) 1. Unscrew to open the battery lid. Insert 2 x AA 2. Turn OFF the vehicle after playing and remove all If you experience any problems or issues with TOYS"R"US (CANADA) LTD. (LTEE), batteries. (See Diagram 3) batteries from the transmitter and the car. this item do not take it back to the store where 2777 LANGSTAFF ROAD, CONCORD, ON L4KAM5 2. Replace the battery cover. you purchased. Please email DISTRIBUTED IN AUSTRALIA BY (DISTRIBUEE EN 3. To adjust steering alignment, adjust the "Steering service @scientific.com.hk and we will be happy AUSTRALIE PAR/ NOTE: REMOVE BATTERY AFTER YOU HAVE to assist you in resolving any issues you may DISTRIBUIDO EN AUSTRALIA POR) TOYS"R"US FINISHED USING YOUR VEHICLE. Alignment Lever" on the underside of the vehicle have. We thank you for your purchase. (AUSTRALIA (AUSTRALIE)) PTY LTD.(LTEE), REGENTS when the vehicle does not run straight forward PARK NSW 2143 (See Diagram 7). www.toysrus.com www.toysrus.ca | 2 x AA Batteries Battery cover D/L) Bottom Panel of transmitter /A Unscrew to open DIAGRAM 1 DIAGRAM 3 DIAGRAM 5 LED X DIAGRAM L Trigger DIAGRAM 2 DIAGRAM 4 DIAGRAM 6


Document Created: 2016-03-15 11:22:18
Document Modified: 2016-03-15 11:22:18
© 2025 FCC.report
This site is not affiliated with or endorsed by the FCC