User Manual

FCC ID: BY35058-49P

Users Manual

Download: PDF

FCCID_3003158

OPERATING INSTRUCTIONS Keep packaging as it contains important information.
CAUTION: To prevent battery leakage:
Be sure to insert batteries correctly and always follow the product and
KEEP PACKAGING AS IT CONTAINS IMPORTANT INFORMATION. 1 2
battery manufacturers' instructions.
BATTERY INSTALLATION: Never mix old and new batteries (replace all batteries at the same time).
BATTERIES: Never mix Alkaline, standard (Carbon Zinc) or rechargeable batteries.
8 x AA(R6) batteries required Only batteries of the same or equivalent type as recommended are to be used.
Do not use RECHARGEABLE batteries, unless specified.
Unscrew to open
ATTENTION PARENTS Non-rechargeable batteries are not to be recharged.
On/Off switch
IT IS RECOMMENDED THAT THIS TOY AND ALL ACCESSORIES BE Rechargeable batteries are to be removed from the product before being
charged (if removable).
PERIODICALLY EXAMINED FOR POTENTIAL HAZARDS AND THAT ANY
Rechargeable batteries are only to be charged under adult supervision (if
POTENTIALLY HAZARDOUS PARTS BE REPAIRED OR REPLACED.
removable).
Always remove exhausted or dead batteries from the product.
CARE Remove batteries from product before extended storage.
6 x AA (R6) batteries

Never drive the vehicle on a wet floor, on sand, grass, carpet, in mud, rain or The supply terminals are not to be short-circuited. Battery cover
snow. These can cause damage to the vehicle. Batteries are to be inserted with correct polarity.
Do not expose the vehicle to extreme temperatures. Batteries may explode or leak if misused.
To protect the vehicle’s wheel mechanisms from lint and hair, do not drive it ATTENTION: Battery / Batteries should be installed by an adult only.
ATTENTION: User should remove the battery from the item before disposal.
on carpet.
AA/LR6 or AAA/LR03 Batteries may present a choking hazard - keep away
Occasionally wipe the vehicle with a damp cloth remove any dirt/dust from young children.
from wheels.
Do not use harsh chemicals to clean the vehicle. This appliance is not intended for use by persons (including children) with
Modifying or tampering with the vehicle or the transmitter’s internal components reduced physical, sensory or mental capabilities, or lack of experience and 3 4
can cause a malfunction. knowledge, unless they have been given supervision or instruction Cable
concerning use of the appliance by a person responsible for their safety. Back Panel of transmitter

HELPFUL HINTS • The WEEE symbol if present indicates that this item contains electrical or
Running the vehicle continuously for long periods of time generates high levels electronic components which must be collected and disposed of separately.
of heat. • Never dispose of electrical or electronic waste in general municipal waste.
Heat causes wear and tear on the motor. When the vehicle’s battery pack goes Collect and dispose of such waste separately.
flat, let the vehicle cool at least 10 minutes before installing a newly charged • Make use of the return and collection systems available to you, or your local AA/LR6 Antenna tube
recycling programme. Contact your local authority or place of purchase to
battery pack. This helps keep heat levels down. If the vehicle’s motor runs but AA/LR6
find out what schemes are available.
does not respond to the transmitter, move the transmitter closer to the vehicle 2 x AA/LR6 batteries
• Electrical and electronic equipment contains hazardous substances which,
and try again. when disposed of incorrectly, may leak into the ground. This can contribute
If a CB radio is used nearby, it might interfere with control of the vehicle. If this to soil and water pollution which is hazardous to human health, and endanger
happens, move the vehicle and transmitter away from the CB radio. The vehicle wildlife.
cannot be operated near devices with transmitters that use the same frequency. • It is essential that consumers look to re-use or recycle electrical or electronic
Check the packaging to see which frequency your vehicle uses. waste to avoid it going to landfill sites or incineration without treatment.
If the vehicle moves slowly, and a recharged battery pack has been installed,
FCC Information
check the wheel mechanisms for lint, thread, hair or dust. This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
5 6
INSERTING BATTERIES to provide reasonable protection against harmful interference in a residential
VEHICLE installation. This equipment generates, uses and can radiate radio frequency Left/Right
1. Turn over the vehicle and push the ON/OFF to "OFF" position. energy and, if not installed and used in accordance with the instructions, may
B A
(See Diagram 1) cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
2. Open the battery cover. (See Diagram 1)
equipment does cause harmful interference to radio or television reception, On 1
3. Insert 6 “AA” batteries by matching the (+) and (–) signs as indicated in the which can be determined by turning the equipment off and on, the user is Vehicle
battery compartment. (See Diagram 2) encouraged to try to correct the interference by one or more of the following Forwards/
Backwards
2
4. Replace the battery cover. measures:
· Reorient or relocate the receiving antenna. 3
TRANSMITTER · Increase the separation between the equipment and receiver.
1. Slide open the battery cover at the back of the transmitter and insert · Connect the equipment into an outlet on a circuit different from that to which
2 “AA” batteries batteries inside following the engraved sign. (See Diagram 3) the receiver is connected. Transmitter
Consult your local retailer store or an experienced radio/TV technician for help.
2. Replace the battery cover.
If you cannot eliminate the interference, the FCC requires that you stop using
Note: Remove battery after you have finished using your vehicle. your product. Changes or modifications not expressly approved by the
Responsible Party may cause interference and void the user’s authority to
HOW TO PLAY operate the equipment.
START TO PLAY
1. Build up antenna by passing the cable through the antenna tube provided FCC Note: The antenna installed on the equipment is a unique one. Installation
and plug into the vehicle tightly. Otherwise, the vehicle will not work. of an unauthorized antenna on this equipment could void the user’s authority to 7
operate the equipment.
(See Diagram 4)
2. Push the ON/OFF switch to the "ON" position of the vehicle. (See Diagram 5)

OPERATION
ENGLISH
1. Operate the vehicle with the transmitter (See Diagram 6).
2. Turn OFF the vehicle and the transmitter after playing and remove all
batteries from the transmitter and the car.
Steering alignment lever
FRONT WHEELS STEERING ADJUSTMENT
1. If the vehicle does not run straight forwards, adjust the lever for satisfactory
alignment on the underside of the vehicle. (See Diagram 7)
2. If the vehicle runs towards left, turn "Steering Alignment Lever" towards "R"
3. If the vehicle runs towards right, turn "Steering Alignment Lever" towards "L" © 2016 SCIENTIFIC TOYS LTD. 1108, TOWER B,
14 SCIENCE MUSEUM ROAD, TSIMSHATSUI, HONG KONG.
PRINTED IN CHINA
O.I. NO.5978

SIZE:210MM X 297MM PN#65-5978-000-0100

Document Created: 2016-05-19 17:11:11
Document Modified: 2016-05-19 17:11:11

© 2025 FCC.report
This site is not affiliated with or endorsed by the FCC