User Manual

FCC ID: BY34817-24GR

Users Manual

Download: PDF

FCCID_2664574

OPERATING INSTRUCTIONS Keep packaging as it contains important information.
CAUTION: To prevent battery leakage:

CAUTION- ELECTRIC TOY
KEEP PACKAGING AS IT CONTAINS IMPORTANT INFORMATION Be sure to insert batteries correctly and always follow the product and battery
BATTERY INSTALLATION: manufacturers' instructions.
(The rechargeable battery pack is not charged, please charge it for 2 hours Never mix old and new batteries (replace all batteries at the same time).
prior to use) Never mix Alkaline, standard (Carbon Zinc) or rechargeable batteries.
1. Plug the Battery Charger. Only batteries of the same or equivalent type as recommended are to be used.
2. Connect the cables leading from the Battery Pack and the Charger together Do not use RECHARGEABLE batteries, unless specified.
by snapping the jack and the socket tightly. (See Diagram 1a)
3. To disconnect cables, press down on the clip and pull apart. (See Diagram 1a)
4. You should charge the battery pack for 2 hours.
Non-rechargeable batteries are not to be recharged.
Rechargeable batteries are to be removed from the product before being charged
(if removable). NOT RECOMMENDED FOR CHILDREN UNDER 6 YEARS OF AGE. AS WITH ALL
ELECTRIC PRODUCTS, PRECAUTIONS SHOULD BE OBSERVED DURING HANDLING
5. If the speed of the car slows down suddenly, it is time to recharge. Rechargeable batteries are only to be charged under adult supervision (if removable).
6. After use, the battery pack will be hot! Wait at least 20 minutes until it cools Always remove exhausted or dead batteries from the product.
before recharging. Recharging a warm or hot battery pack will greatly shorten Remove batteries from product before extended storage.
the use life of the battery. The supply terminals are not to be short-circuited.
7. The toy must be used with the recommended battery charger.
8. The battery charger is not a toy.
Batteries are to be inserted with correct polarity.
Batteries may explode or leak if misused.
ATTENTION: Battery / Batteries should be installed by an adult only.
AND USE TO PREVENT ELECTRIC SHOCK. INPUT: 120VAC, 60HZ 10W ONLY. OUTPUT:
ATTENTION PARENTS
IT IS RECOMMENDED THAT THIS TOY AND ALL ACCESSORIES BE
PERIODICALLY EXAMINED FOR POTENTIAL HAZARDS AND THAT ANY
POTENTIALLY HAZARDOUS PARTS BE REPAIRED OR REPLACED.
ATTENTION: User should remove the battery from the item before disposal.

Battery Chargers
WARNING:
12VDC, 350mA
After use, the battery pack will be hot! Wait until it cools before recharging.
CARE Recharging a warm or hot battery (pack) will greatly shorten the battery’s life. 1 Press here 2 3
Never drive the vehicle on a wet floor, on sand, grass, carpet, in mud, rain or snow. Unplug the charger from the electrical outlet if it is not going to be used for a long when opening Unscrew to open
These can cause damage to the vehicle. period of time. Battery
Do not expose the vehicle to extreme temperatures. Battery charger must be operated by adults only. Charger
To protect the vehicle’s wheel mechanisms from lint and hair, do not drive it on carpet. 2hr
Non-rechargeable batteries are not to be recharged.
Occasionally wipe the vehicle with a damp cloth to keep the wheels clean of dirt Do not charge a battery (pack) that is hot, wet or shows signs of leakage or corrosion. 9.6V Battery
and dust. Do not expose to fire, as this may result in explosion. 1a rechargeable cover
Do not use harsh chemicals to clean the vehicle. Do not short circuit the battery (pack). Battery pack
Modifying or tampering with the vehicle or the transmitter’s internal components can Rechargeable batteries must be charged with the recommended battery charger. OFF ON
cause a malfunction. The battery charger is to be regularly examined for damage to the cord, plug
enclosure and other parts. In the event of such damage, the charger must not be ON/OFF
HELPFUL HINTS used until it has been repaired or replaced. Charging indicator switch
Running the vehicle continuously for long periods of time generates high levels of heat. The battery charger is not a toy.
Heat causes wear and tear on the motor. When the vehicle’s battery Prolonged charging will not improve the battery output, and could eventually damage
pack runs down, let the vehicle cool at least 10 minutes before installing a newly the battery (pack). Flathead screwdriver required, not included
charged battery pack. 9.6V battery pack
Do not disassemble the battery pack.
This helps keep heat levels down. If the vehicle’s motor runs but does
not respond to the transmitter, move the transmitter closer to the vehicle and try again. This appliance is not intended for use by persons (including children) with reduced
If a CB radio is used nearby, it might interfere with control of the vehicle. physical, sensory or mental capabilities, or lack of experience and knowledge,
If this happens, move the vehicle and transmitter away from the CB radio. unless they have been given supervision or instruction concerning use of the
The vehicle cannot be operated near devices with transmitters that use the same appliance by a person responsible for their safety.
frequency. Check the packaging to see which frequency your vehicle uses. If the 4 5 6
vehicle moves slowly, and a recharged battery pack has been installed, check the • The WEEE symbol if present indicates that this item contains electrical or Forward
wheel mechanisms for lint, thread, hair or dust. electronic components which must be collected and disposed of separately.
• Never dispose of electrical or electronic waste in general municipal waste.
INSERTING BATTERIES Collect and dispose of such waste separately.
VEHICLE • Make use of the return and collection systems available to you, or your local Unscrew to open Forward Forward
1. Make sure the “ON/OFF” switch at the underside of the vehicle is at the “OFF”
position. (See Diagram 2) recycling programme. Contact your local authority or place of purchase to find
2. Unscrew to open battery cover. (See Diagram 2) out what schemes are available.
3. Plug the jack of the 9.6V rechargeable battery pack into the socket of the • Electrical and electronic equipment contains hazardous substances which, when OFF ON
battery compartment, and put the battery pack inside properly. (See Diagram 3) disposed of incorrectly, may leak into the ground. This can contribute to soil and
4. Replace the battery cover and tighten the screw to secure the battery cover. water pollution which is hazardous to human health, and endanger wildlife. ON/OFF
• It is essential that consumers look to re-use or recycle electrical or electronic 1 x 9 Volt Battery switch Driving control stick
TRANSMITTER waste to avoid it going to landfill sites or incineration without treatment.
1. Unscrew to open the battery lid and insert the 9V/6LR61 battery as per the
directions shown inside. (See Diagram 4) FCC INFORMATION
2. Replace the battery cover. This equipment has been tested and found to comply with the limits for a Class B
Note: Remove battery after you have finished using your vehicle. digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not
HOW TO PLAY installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
7 8 9
START TO PLAY
PAIRING TRANSMITTER WITH VEHICLE interference will not occur in a particular installation. If this equipment does cause Right Left
1. Turn ON the vehicle (See Diagram 5). harmful interference to radio or television reception, which can be determined by
2. Install the 9V/6LR61 battery in the transmitter, the pairing LED light on the turning the equipment off and on, the user is encouraged to try to correct the
transmitter will flash. interference by one or more of the following measures: Backward Backward Forward Forward
3. If pairing success, the pairing LED light will turn OFF • Reorient or relocate the receiving antenna.
4. You must pairing the transmitter with the vehicle within 45 seconds, after 45 seconds • Increase the separation between the equipment and receiver.
you must push the control on the transmitter to pair again. • Connect the equipment into an outlet on a circuit different from that to which the
5. You must repeat pairing again when the transmitter needs to replace new batteries. receiver is connected.
• Consult your local RadioShack store or an experienced radio/TV technician for help.
FORWARD RUNNING
If you cannot eliminate the interference, the FCC requires that you stop using your Driving control stick Driving control stick Driving control stick
6. Push both the Driving Control Sticks forwards for forward motion. (See Diagram 6)
equipment. Changes or modifications not expressly approved by the party responsible Reverse
REVERSE RUNNING for compliance could void the user’s authority to operate the equipment.
7. Pull both the Driving Control Sticks backwards for reverse motion. (See Diagram 7) This device complies with Part 15 of the FCC rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and
STEERING OPERATION (2) this device must accept any interference received, including interference that
8. Push only the Left Driving Control Stick forwards to turn Right. (See Diagram 8) may cause undesired operation.
9. Push only the Right Driving Control Stick forwards to turn Left. (See Diagram 9)
10 11 12
360 DEGREE SPINS
10. Push the Left Driving Control Stick forwards while pulling the Right Driving Control ENGLISH
Right Left Stop
Stick backwards at the same time. (See Diagram 10)
11. Push the Right Driving Control Stick forwards while pulling the Left Driving Control
Stick backwards at the same time. (See Diagram 11) Forward Backward Backward Forward

STOP OPERATION
12. Release both Driving Control Sticks, the vehicle will Stop. (See Diagram 12)

Driving control stick Driving control stick
WARNING: © 2015 SCIENTIFIC TOYS LTD. 1108, TOWER B,
CHOKING HAZARD- 14 SCIENCE MUSEUM ROAD, TSIMSHATSUI, HONG KONG.
Small parts, Not for chidren under 3 years PRINTED IN CHINA
O.I. NO.5xxx

#99078 SIZE:210MM X 297MM PN#65-5xxx-000-0100

Document Created: 2015-05-22 19:20:09
Document Modified: 2015-05-22 19:20:09

© 2025 FCC.report
This site is not affiliated with or endorsed by the FCC