User Manual

FCC ID: BY34817-24GG

Users Manual

Download: PDF
FCCID_3896458

OPERATING INSTRUCTIONS OPERATION FORWARD DRIVING KEEP PACKAGING AS IT CONTAINS IMPORTANT INFORMATION. 1. Push both the Driving Control Sticks forwards for forward motion. (See Diagram 3) REVERSE DRIVING BATTERY INSTALLATION BATTERY REQUIREMENT: 2. Pull both the Driving Control Sticks backwards for reverse motion. (See Diagram 4) 1 Vehicle: Built-in Rechargeable Battery STEERING OPERATION Transmitter: 1 x 9V battery (included) 4. Push only the Left Driving Control Stick forwards to turn Right. (See Diagram 5) 5. Push only the Right Driving Control Stick forwards to turn Left. (See Diagram 6) ATTENTION PARENTS 360 DEGREE SPINS It is recommended that this toy and all accessories be periodically examined for potential hazards 6. Push the Left Driving Control Stick forwards while pulling the Right Driving Control Stick and that any potentially hazardous parts be repaired or replaced. backwards at the same time. (See Diagram 7) 7. Push the Right Driving Control Stick forwards while pulling the Left Driving Control Stick backwards at the same time. (See Diagram 8) VEHICLE The vehicle is powered by a built-in non-replaceable rechargeable battery. The included rechargeable STOP OPERATION 8. Release both Driving Control Sticks, the vehicle will Stop. (See Diagram 9) battery is not charged prior to shipment and must be charged before the first use. WHEELIES ACTION Charging The Vehicle 9. Press reverse then Forward quickly to perform Wheelie Action. (See Diagram 10) 1. Make sure the vehicle’s switch is in the CHARGE position. (See Diagram 1) 2. Open the battery cover. (See Diagram 1) Keep packaging as it contains important information. Unscrew to open 3. Plug the charging cable USB socket to an USB certified port, CAUTION: To prevent battery leakage: Be sure to insert batteries correctly and always follow the product and battery i.e., desktop computer / laptop computer / smartphone charger / tablet charger / car changer manufacturers' instructions. Flathead screwdriver required, not included 4. Turn the vehicle's switch to "CHARGE" position. Never mix old and new batteries (replace all batteries at the same time). 5. The LED light on car body will flash to show vehicle is charging. Never mix Alkaline, standard (Carbon Zinc) or rechargeable (Nickel-Metal Hydride) batteries. 6. Once the light turned OFF, the vehicle is fully charged. Unplug the USB socket from the USB Only batteries of the same or equivalent type as recommended are to be used. certified port. Do not use RECHARGEABLE batteries, unless specified. 7. Put back the charging cable into the compartment and replace battery cover. (See Diagram 1) Non-rechargeable batteries are not to be recharged. Rechargeable batteries are to be removed from the product before being charged. 2 3 4 HOW TO INSTALL BATTERIES INTO THE TRANSMITTER Rechargeable battery is only to be charged by adults or by children at least 8 years old. 1. Unscrew to open the battery lid. Insert a new 1 x 9V battery. (See Diagram 2) Always remove exhausted or dead batteries from the product. Unscrew 2. Replace the battery cover. Remove batteries from product before extended storage. to open LED Note: Remove battery after you have finished using your vehicle. The supply terminals are not to be short-circuited. Batteries are to be inserted with correct polarity. Forwards Caution : Built-In Battery Safety Information Batteries may explode or leak if misused. Forwards Forwards Backwards Backwards 1. The vehicle includes a non-replaceable battery. Do not open, disassemble or alter the vehicle in ATTENTION: Battery / Batteries should be installed by an adult only. anyway. ATTENTION: User should remove the battery from the item before disposal. 2. Adult supervision is required when charging the vehicle. 3. Charge battery in isolated area. Keep away from flammable materials. This appliance is not intended for use by persons (including children) with reduced physical, sensory 4. Do not expose to direct sunlight. or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. 5. Do not recharge the toy if it is hot. Allow it to cool before recharge. 6. Do not allow the batteries to get wet. 1 x 9 Volt Battery Reverse • The WEEE symbol if present indicates that this item contains electrical or electronic components Driving control stick Driving control stick 7. Carefully read the instruction guide and use the batteries correctly. which must be collected and disposed of separately. 8. Rechargeable batteries are only to be charged under adult supervision. • Never dispose of electrical or electronic waste in general municipal waste. Collect and dispose of 9. Routine examination for damage to the plug, enclosure and other parts. In the event of any such waste separately. damage, the toy must not be used with USB port until the damage has been repaired. • Make use of the return and collection systems available to you, or your local recycling programme. 10. This toy is not intended for children under 3 years old. Contact your local authority or place of purchase to find out what schemes are available. • Electrical and electronic equipment contains hazardous substances which, when disposed of CARE incorrectly, may leak into the ground. This can contribute to soil and water pollution which is Never drive the vehicle on a wet floor, on sand, grass, carpet, in mud, rain or snow. These can cause hazardous to human health, and endanger wildlife. damage to the vehicle. Do not expose the vehicle to extreme temperatures. To protect the vehicle’s • It is essential that consumers look to re-use or recycle electrical or electronic waste to avoid it wheel mechanisms from lint and hair, do not drive it on carpet. Occasionally wipe the vehicle with a going to landfill sites or incineration without treatment. 5 6 7 damp cloth to remove any dirt/dust from wheels. Do not use harsh chemicals to clean the vehicle. Modifying or tampering with the vehicle or the transmitter’s internal components can cause a NOT SUITABLE FOR CHILDREN UNDER 3 YEARS OF AGE, DUE TO SMALL PARTS. malfunction. Left FCC Information NOTE: This equipment has been tested and found to comply with the limits for a Class B digital Right Right HELPFUL HINTS device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable Running the vehicle continuously for long periods of time generates high levels of heat. Heat causes Forwards Forwards Forwards Backwards protection against harmful interference in a residential installation. This equipment generates, uses, wear and tear on the motor. When the vehicle’s battery pack goes flat, let the vehicle cool at least and can radiate radio frequency energy and, if not installed and used in accordance with the 10 minutes before installing a newly charged battery pack. This helps keep heat levels down. If the instructions, may cause harmful interference to radio communications. However, there is no vehicle’s motor runs but does not respond to the transmitter, move the transmitter closer to the guarantee that interference will not occur in a particular installation. If this equipment does cause vehicle and try again. If a CB radio is used nearby, it might interfere with the control of the vehicle. harmful interference to radio or television reception, which can be determined by turning the If this happens, move the vehicle and transmitter away from the CB radio. The vehicle cannot be equipment off and on, the user is encouraged to try to correct the interference by one or more of operated near devices with transmitters that use the same frequency. Check the packaging to see the following measures: which frequency your vehicle uses. If the vehicle moves slowly, and a recharged battery pack has Driving control stick Driving control stick Driving control stick been installed, check the wheel mechanisms for lint, thread, hair or dust. • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. HOW TO PLAY • Consult the dealer or an experienced radio/TV technician for help. START TO PLAY PAIRING TRANSMITTER WITH VEHICLE If you cannot eliminate the interference, the FCC requires that you stop using your equipment. 1. Turn ON the vehicle (See Diagram 1). Warning: Changes or modifications not expressly approved by the party responsible for compliance 2. Install 1 x 9V battery in the transmitter, the pairing LED light on the transmitter will flash (See could void the user’s authority to operate the equipment. This device complies with Part 15 of the 8 9 10 FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause Diagram 2). harmful interference, and (2) this device must accept any interference received, including interference 3. If pairing success, the pairing LED light will turn OFF that may cause undesired operation. Left 4. You must pairing the transmitter with the vehicle within 45 seconds, after 45 seconds you must push the control on the transmitter to pair again. Stop 5. You must repeat pairing again when the transmitter needs to replace new batteries. Backwards Forwards Notes: ENGLISH 1. If pairing failed, reinstall the battery of transmitter, move closer and then try again. 2. If more then one vehicle are pairing at the same time, pair each vehicle one by one. Vehicle has memory to store the paired data, no need to pair each time play until replace the battery in transmitter. Driving control stick © 2018 SCIENTIFIC TOYS LTD. 1108, TOWER B, 14 SCIENCE MUSEUM ROAD, TSIMSHATSUI, HONG KONG. PRINTED IN CHINA O.I. NO.6297 #99074 SIZE: 210MM X 297MM PN#65-6297-000-0100


Document Created: 2018-06-12 16:48:24
Document Modified: 2018-06-12 16:48:24
© 2025 FCC.report
This site is not affiliated with or endorsed by the FCC