LMA letter

FCC ID: BBP-WLALT01

Cover Letter(s)

Download: PDF
FCCID_2808797

810 Shimoimaizumi, Ebina-city, Kanagawa 243-0460 Japan Request for Limited Modular Transmitter Approval October 21, 2015 FCC ID : BBP-WLALT01 Applicant : Ricoh Company Ltd This transmitter, model: LBWB1ZZWU6 is designed by us. It complies with the modular transmitters basic requirements (Item 1 to 8) in FCC Part 15 Subpart C Section 15.212 as indicated below: Modular Approval Checklist: Modular approval requirement Yes No (1) Have its own RF shielding. (2) Have buffered modulation/data inputs. (3) Have its own power supply regulation. This modular transmitter has own power supply regulator. However the stable voltage from the host product will be directly to RF part. Please refer to the block diagram of the original application documents. (4) Comply with the antenna and transmission system requirements of § 15.203, 15.204(b) and 15.204(c). (5) Tested in a stand-alone configuration. Unless the transmitter module will be battery powered, it must The module was tested in a comply with the AC line conducted requirements found in FCC § stand-alone configuration. 15.207. AC or DC power lines and data input/output lines However, since the operating system connected to the module must not contain ferrites, unless they will will not support the preferred be marketed with the module. The length of these lines shall be the method for data transfer from master length typical of actual use or, if that length is unknown, at least 10 to client device, this module tested centimeters to insure that there is no coupling between the case of only DFS within that specific host. the module and supporting equipment. Any accessories, Therefore, this application is limited peripherals, or support equipment connected to the module during module approval. Please refer to testing shall be unmodified and commercially available. KDB Tracking Number 487702 and DFS proposal of the original application documents (6) Equipped with either a permanently affixed label or must be capable of electronically displaying its FCC ID. If the FCC ID is not visible when the module is installed inside another device, then the outside of the device into which the module is installed must also display a label referring to the enclosed module. (7) Comply with any specific rules or operating requirements that ordinarily apply to a complete transmitter and the manufacturer must provide adequate instructions along with the module to explain any such requirements. (8) Comply with any applicable RF exposure requirements in its final configuration: The modular transmitter complies with FCC radiation exposure requirement. Seiji Nakamura Deputy General Manager Ricoh Company Ltd


Document Created: 2015-10-21 10:50:52
Document Modified: 2015-10-21 10:50:52
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC