Modular Approval Request

FCC ID: B94VCVRA1712

Cover Letter(s)

Download: PDF
FCCID_3712126

HP Inc. 1115 SE 164th Ave. Vancouver, WA, 98683 USA hp.com Modular Transmitter Approval Request Federal Communications Commission Equipment Authorization Branch 7435 Oakland Mills Road Columbia, MD 21046 Company name: HP Inc. FCC ID: B94VCVRA1712 Gentlemen, In accordance with 47CFR 15.212 Modular Transmitters and KDB 996369 D01 ‘Module Certification Guide v01r04’. FCC ID B94VCVRA has been examined against the following requirements. Requirement per 15.212 and KDB 996369 D01 Explanation from Grantee ‘Modular Certification Guide v01r04 (do not write yes/no, but explain why product complies/how it is achieved) The radio elements must have the radio frequency All parts reside under rectangular shield; circuitry shielded. Physical components and tuning with exception of host connector, PCB capacitor(s) may be located external to the shield, antenna, and antenna tuning parts which but must be on the module assembly are outside shield. The module must have buffered modulation/data Buffered inputs are part of the design of the inputs to ensure that the device will comply with Part 15 requirements with any type of input signal radio ICs. Host provides +3.3V. Modules include The module must contain power supply regulation on specific Power Modulation Integrated Chip the module (PMIC) for generation of device voltage supplies +2.2V, +1.8V, +1.05V. The module must contain a permanently attached The module includes a pair of antennas antenna, or contain a unique antenna connector, and designed as part of the circuit board. be marketed and operated only with specific antenna(s), per Sections 15.203, 15.204(b), There is also a special connector loaded in 15.204(c), 15.212(a), 2.929(b) some module variants for connecting one

external antenna in place of one of the built-in antennas. HP has identified the external antenna to be used with this connector and that antenna was included for evaluation by the compliance test lab as part of the compliance test program. Compliance was evaluated operating the radio as a stand-alone device in the The module must demonstrate compliance in a stand-alone configuration following reports from MiCOM Labs: MARS11 U2, MARS11 U4, MARS11 U9, MARS11 U13. The FCC ID will be added to the PCB The module must be labelled with its permanently stencil on the bottom side of the module for affixed FCC ID label, or use an electronic display mass production. Any modules sold prior (See KDB Publication 784748 about labelling to this stencil change will have permanent requirements) labels with the FCC ID attached to the module. Design Verification Testing reports contain The module must comply with all specific rules all the Tx and Rx data indicating applicable to the transmitter including all the conditions provided in the integration instructions by compliance to standards. As this module is the grantee used only by HP, HP maintains full control over product integration. Compliance with the RF exposure rules The module must comply with RF exposure requirements was demonstrated in MiCOM report MARS11_MPE_FCC_Rev_A_All_Bands Name: Manish Oswal Date: 18th Dec 2017 Title: Regulatory Engineer Signature of applicant Page 2 of 2


Document Created: 2017-12-18 12:26:24
Document Modified: 2017-12-18 12:26:24
© 2025 FCC.report
This site is not affiliated with or endorsed by the FCC