02 FCC LMA Letter_unlicensed

FCC ID: AK8M18DFT1

Cover Letter(s)

Download: PDF
FCCID_3783581

soONY Request for Limited Modular Transmitter Approval February 26, 2018 FCCID : AK8MI1I8DFTI Applicant: Sony Corporation This transmitter, model: J20H096 is designed by us. It complies with the modular transmitters basic requirements (Item 1 to 8) in FCC Part 15 Subpart C Section 15.212 as indicated below: Modular Approval Checklist: Modular approval requirement Yes No (1) Have its own RF shielding. e| [ (2) Have buffered modulation/data inputs. [X [] (3) Have its own power supply regulation. [ [X This module has the power supply regulator. However the one of input voltages to RF part don‘t go through the regulator. The stable voltage will be supplied by end product. Therefore end product will be required to have the power supply regulator. (4) Comply with the antenna and transmission system requirements M K of § 15.203, 15.204(b) and 15.204(c). (5) Tested in a stand—alone configuration. U Unless the transmitter module will be battery powered, it must comply with the AC line conducted requirements found in FCC § 15.207. AC or DC power lines and data input/output lines connected to the module must not contain ferrites, unless they will be marketed with the module. The length of these lines shall be the length typical of actual use or, if that length is unknown, at least 10 centimeters to insure that there is no coupling between the case of the module and supporting equipment. Any accessories, peripherals, or support equipment connected to the module during testing shall be unmodified and commercially available. (6) Equipped with either a permanently affixed label or must be [X [ capable of electronically displaying its FCC ID. If the FCC ID is not visible when the module is installed inside another device, then the outside of the device into which the module is installed must also display a label referring to the enclosed module. (7) Comply with any specific rules or operating requirements that [X [ ordinarily apply to a complete transmitter and the manufacturer must provide adequate instructions along with the module to explain any such requirements. (8) Comply with any applicable RF exposure requirements in its final [X [ configuration: The modular transmitter complies with FCC radiation exposure requirement. _ Kiyoto Sasaki VP, Product Safety & Compliance Section Sony Interactive Entertainment Inc. Signed on bahalf of; Ryo Takata, Sony Corporation


Document Created: 2018-02-26 18:27:27
Document Modified: 2018-02-26 18:27:27
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC