Test Report

FCC ID: AJK8222532

Test Report

Download: PDF
FCCID_3678107

849 NW State Road 45 Newberry, Fl 32669 USA Phone: 888.472.2424 or 352.472.5500 Fax: 352.472.2030 Email: info@timcoengr.com Website: www.timcoengr.com FCC PART 15 B SUBPART B RECEIVER TEST REPORT Applicant ROCKWELL COLLINS, INC. 1300 WILSON BLVD. SUITE 200 Address ARLINGTON VA 22209 USA FCC ID AJK8222532 Product Description GLU2100 LANDING UNIT RECEIVER Date Sample Received 10/17/2017 Date Tested 10/18/2017 Tested By Tim Royer Approved By Sid Sanders Test Results PASS FAIL Report Version Description Issue Date Number Number 1821UT17TestReport Rev1 Initial Issue 10/24/2017 Rev2 Revised report – new test set up 12/7/2017 photo added Rev2 Updated Power Information 12/13/2017 THE ATTACHED REPORT SHALL NOT BE REPRODUCED EXCEPT IN FULL WITHOUT THE WRITTEN APPROVAL OF TIMCO ENGINEERING, INC.

TABLE OF CONTENTS GENERAL REMARKS ............................................................................................................ 2 REPORT SUMMARY ............................................................................................................. 3 TEST ENVIRONMENT .......................................................................................................... 3 TEST SETUP SUMMARY ....................................................................................................... 3 RESULTS SUMMARY ............................................................................................................ 3 EUT SPECIFICATION ........................................................................................................... 4 TEST PROCEDURES ............................................................................................................ 5 RADIATED SPURIOUS EMISSIONS ........................................................................................ 6 Test Data: 30–200 MHz Vertical Plot .................................................................................. 7 Test Data: 30–200 MHz Vertical Plot Cont. ......................................................................... 8 Test Data: 30–200 MHz Horizontal Plot .............................................................................. 9 Test Data: 30–200 MHz Horizontal Plot Cont. .................................................................... 10 Test Data: 200–1000 MHz Vertical Plot ............................................................................ 11 Test Data: 200–1000 MHz Vertical Plot Cont. .................................................................... 12 Test Data: 200–1000 MHz Horizontal Plot ......................................................................... 13 Test Data: 200–1000 MHz Horizontal Plot Cont. ................................................................ 14 Test Data: 1–12.5 GHz Vertical Plot ................................................................................. 15 Test Data: 1–12.5 GHz Vertical Plot Cont. ........................................................................ 16 Test Data: 1–12.5 GHz Horizontal Plot. ............................................................................ 17 Test Data: 1–12.5 GHz Horizontal Plot Cont. ..................................................................... 18 TEST EQUIPMENT LIST ..................................................................................................... 19

GENERAL REMARKS The attached report shall not be reproduced except in full without the written permission of Timco Engineering Inc. Summary The device under test does: Fulfill the general approval requirements as identified in this test report and was selected by the customer. Not fulfill the general approval requirements as identified in this test report Attestations This equipment has been tested in accordance with the standards identified in this test report. To the best of my knowledge and belief, these tests were performed using the measurement procedures described in this report. All instrumentation and accessories used to test products for compliance to the indicated standards are calibrated regularly in accordance with ISO 17025 requirements. I attest that the necessary measurements were made at: Timco Engineering Inc. 849 NW State Road 45 Newberry, FL 32669 Tested by: Name and Title: Tim Royer, Project Manager/Testing Engineer Date: 10/24/2017 Reviewed and approved by: Name and Title: Sid Sanders Engineer Date: 10/27/2017 Applicant: ROCKWELL COLLINS, INC. TABLE OF CONTENTS FCC ID: AJK8222532 Report: 1821UT17TestReport_Rev2 Page 2 of 19

REPORT SUMMARY Disclaimer The test results only relate to the item tested. Applicable Rule(s) Pt 15.109, ANSI C63.4: 2013 Related Report None TEST ENVIRONMENT Timco Engineering, Inc. 849 NW State Road 45 Test Facility Newberry, FL 32669 USA. Test Condition in the Temperature: 26ºC laboratory Relative humidity: 50% TEST SETUP SUMMARY The EUT was placed on the turntable per setup per ANSI Test Setup Diagram/ C63.4: 2013. A test set up photo is provided for Description clarification. Deviation from the No deviation standard/procedure Modification of EUT No modification RESULTS SUMMARY FCC Rules 15.109 Radiated Emissions Pass FCC Rules 15.107- AC Powerline Conducted Emissions N/A Applicant: ROCKWELL COLLINS, INC. TABLE OF CONTENTS FCC ID: AJK8222532 Report: 1821UT17TestReport_Rev2 Page 3 of 19

EUT SPECIFICATION EUT Description LANDING UNIT RECEIVER FCC ID AJK8222532 115Vac/400Hz Single Phase EUT Power Source DC Power Battery Operated Exclusively Prototype Test Item Pre-Production Production Fixed Type of Equipment Mobile Portable Laboratory Temperature: 26ºC Test Conditions Humidity: 55% Modifications to EUT: No Yes (explanation below) Applicant: ROCKWELL COLLINS, INC. TABLE OF CONTENTS FCC ID: AJK8222532 Report: 1821UT17TestReport_Rev2 Page 4 of 19

TEST PROCEDURES Radiation Interference: The test procedure used was ANSI C63.4 using a spectrum analyzer with a preselector. The bandwidth of the spectrum analyzer was 100 kHz with an appropriate sweep speed. The analyzer was calibrated in dB above a microvolt at the output of the antenna. The video bandwidth was always greater than or equal to the RBW. The frequency was scanned from 30 MHz to 12.5 GHz. When an emission was found, the table was rotated to produce the maximum signal strength. The EUT was measured in three (3) orthogonal planes when necessary. Formula of Conversion Factors: The field strength at 3m was established by adding the meter reading of the spectrum analyzer (which is set to read in units of dBµV) to the antenna correction factor supplied by the antenna manufacturer plus the coax loss. The antenna correction factors are stated in terms of dB. The gain of the preselector was accounted for in the spectrum analyzer meter reading. Example: Freq (MHz) Meter Reading + ACF +CL = FS 33 20 dBµV + 10.36 dB/m +0.40 dB =30.36 dBµV/m @ 3m ANSI C63.4 Measurement Procedures: The unit under test was placed on a table 80 cm high and with dimensions of 1m by 1.5m. The table used for radiated measurements is capable of continuous rotation. When an emission was found, the table was rotated to produce the maximum signal strength. At this point, the antenna was raised and lowered from 1m to 4m. The antenna was placed in both the horizontal and verticals planes. Applicant: ROCKWELL COLLINS, INC. TABLE OF CONTENTS FCC ID: AJK8222532 Report: 1821UT17TestReport_Rev2 Page 5 of 19

RADIATED SPURIOUS EMISSIONS Rules Part No.: 15.109, IC RSS-GEN 7.1 Requirements: Frequency MHz Limits 30 – 88 40.0 dBµV/m measured @ 3 meters 88 – 216 43.5 dBµV/m measured @ 3 meters 216 – 960 46.0 dBµV/m measured @ 3 meters Above 960 54.0 dBµV/m measured @ 3 meters Measurement Procedure: The test procedure used was ANSI C63.4 using a spectrum analyzer with a preselector. The bandwidth of the spectrum analyzer was 100 kHz with an appropriate sweep speed. The analyzer was calibrated in dB above a microvolt at the output of the antenna. The video bandwidth was always greater than or equal to the RBW. The frequency was scanned from 30 MHz to 5.0 GHz. When an emission was found, the table was rotated to produce the maximum signal strength. The EUT was measured in three (3) orthogonal planes when applicable. Applicant: ROCKWELL COLLINS, INC. TABLE OF CONTENTS FCC ID: AJK8222532 Report: 1821UT17TestReport_Rev2 Page 6 of 19

RADIATED SPURIOUS EMISSIONS TEST DATA: 30–200 MHZ VERTICAL PLOT Results Meets Requirements Applicant: ROCKWELL COLLINS, INC. TABLE OF CONTENTS FCC ID: AJK8222532 Report: 1821UT17TestReport_Rev2 Page 7 of 19

RADIATED SPURIOUS EMISSIONS TEST DATA: 30–200 MHZ VERTICAL PLOT CONT. Results Meets Requirements Applicant: ROCKWELL COLLINS, INC. TABLE OF CONTENTS FCC ID: AJK8222532 Report: 1821UT17TestReport_Rev2 Page 8 of 19

RADIATED SPURIOUS EMISSIONS TEST DATA: 30–200 MHZ HORIZONTAL PLOT Results Meets Requirements Applicant: ROCKWELL COLLINS, INC. TABLE OF CONTENTS FCC ID: AJK8222532 Report: 1821UT17TestReport_Rev2 Page 9 of 19

RADIATED SPURIOUS EMISSIONS TEST DATA: 30–200 MHZ HORIZONTAL PLOT CONT. Results Meets Requirements Applicant: ROCKWELL COLLINS, INC. TABLE OF CONTENTS FCC ID: AJK8222532 Report: 1821UT17TestReport_Rev2 Page 10 of 19

RADIATED SPURIOUS EMISSIONS TEST DATA: 200–1000 MHZ VERTICAL PLOT Results Meets Requirements Applicant: ROCKWELL COLLINS, INC. TABLE OF CONTENTS FCC ID: AJK8222532 Report: 1821UT17TestReport_Rev2 Page 11 of 19

RADIATED SPURIOUS EMISSIONS TEST DATA: 200–1000 MHZ VERTICAL PLOT CONT. Results Meets Requirements Applicant: ROCKWELL COLLINS, INC. TABLE OF CONTENTS FCC ID: AJK8222532 Report: 1821UT17TestReport_Rev2 Page 12 of 19

RADIATED SPURIOUS EMISSIONS TEST DATA: 200–1000 MHZ HORIZONTAL PLOT Results Meets Requirements Applicant: ROCKWELL COLLINS, INC. TABLE OF CONTENTS FCC ID: AJK8222532 Report: 1821UT17TestReport_Rev2 Page 13 of 19

RADIATED SPURIOUS EMISSIONS TEST DATA: 200–1000 MHZ HORIZONTAL PLOT CONT. Results Meets Requirements Applicant: ROCKWELL COLLINS, INC. TABLE OF CONTENTS FCC ID: AJK8222532 Report: 1821UT17TestReport_Rev2 Page 14 of 19

RADIATED SPURIOUS EMISSIONS TEST DATA: 1–12.5 GHZ VERTICAL PLOT Results Meets Requirements Applicant: ROCKWELL COLLINS, INC. TABLE OF CONTENTS FCC ID: AJK8222532 Report: 1821UT17TestReport_Rev2 Page 15 of 19

RADIATED SPURIOUS EMISSIONS TEST DATA: 1–12.5 GHZ VERTICAL PLOT CONT. Results Meets Requirements Applicant: ROCKWELL COLLINS, INC. TABLE OF CONTENTS FCC ID: AJK8222532 Report: 1821UT17TestReport_Rev2 Page 16 of 19

RADIATED SPURIOUS EMISSIONS TEST DATA: 1–12.5 GHZ HORIZONTAL PLOT. Results Meets Requirements Applicant: ROCKWELL COLLINS, INC. TABLE OF CONTENTS FCC ID: AJK8222532 Report: 1821UT17TestReport_Rev2 Page 17 of 19

RADIATED SPURIOUS EMISSIONS TEST DATA: 1–12.5 GHZ HORIZONTAL PLOT CONT. Results Meets Requirements Applicant: ROCKWELL COLLINS, INC. TABLE OF CONTENTS FCC ID: AJK8222532 Report: 1821UT17TestReport_Rev2 Page 18 of 19

TEST EQUIPMENT LIST Device Manufacturer Model Serial Cal/Char Due Date Number Date CHAMBER Panashield 3M N/A 04/25/16 12/31/17 Antenna: ETS-Lindgren 3117 00041534 03/01/17 03/01/19 Double- Ridged Horn/ETS Horn 2 Software: Timco N/A Version N/A N/A Field 4.10.7.0 Strength Program EMI Test Rohde & ESU 40 100320 04/01/16 04/01/18 Receiver R & Schwarz S ESU 40 Chamber Coaxial Cable Micro-Coax Chamber 3 KMKM-0244- 08/09/16 08/09/18 - Chamber 3 cable set 01; KMKM- cable set (Primary) 0670-00; (Primary) KFKF-0198- 01 Band Reject Micro-Tronics BRM50702-02 -G042 09/27/16 09/27/18 Filter 2.4 GHz Antenna: EMCO 3116 9011-2145 11/18/15 11/18/17 Double- Ridged Horn 18-40 GHz Pre-amp RF-LAMBDA RLNA00M45GA NA 01/04/16 01/04/18 *EMI RECEIVER SOFTWARE VERSION The receiver firmware used was version 4.43 Service Pack 3 Applicant: ROCKWELL COLLINS, INC. TABLE OF CONTENTS FCC ID: AJK8222532 Report: 1821UT17TestReport_Rev2 Page 19 of 19


Document Created: 2017-12-13 16:35:42
Document Modified: 2017-12-13 16:35:42
© 2025 FCC.report
This site is not affiliated with or endorsed by the FCC